Question about 2001 Chevrolet Silverado 1500

1 Answer

MY ANTYLOCK IS REAL SINSITIVE AT LOW SPEED - 2001 Chevrolet Silverado 1500

Posted by on

  • yadayada
    yadayada May 11, 2010

    are the rear brakes locking up?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 29 Answers

What is the problem? Too sensitive? What speed does it occur? First apply? Every apply? Wet roads?

Cheap tires, cheap brakes, wrong tire size (not calibrated), contaminated brakes, faulty wheel speed sensor.

Most common problem is cheap rear brake pads.

Posted on Sep 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Chevy Malibu won't start, odometer reads error


The odometer will display 'error' if an internal IPC memory failure is detected or if there is a serial data communication fault between the ECM and the BCM. IPC instrument panel cluster .
Circuit Description
The communication among control modules is performed through the GMLAN high speed serial data circuit and the GMLAN low speed serial data circuit. The modules that need real time communication are attached to the high speed GMLAN network. The body control module (BCM) is the gateway between the networks. The purpose of the gateway is to translate serial data messages between the GMLAN high speed buss and the GMLAN low speed buss. The gateway will interact with each network according to that network's transmission protocol. Refer to Body Control System Description and Operation for more information about the gateway.
Your best bet is to take your vehicle to the dealer , sorry !

Sep 25, 2016 | 2007 Chevrolet Malibu

1 Answer

I have a nissan 1400 champ 95 model.When i drove home bakkie starts to miss like it dont get petrol but if ref high the miss is gone,when low it dies.I have clean it and put new gaskets,still the same


Ignition modules have two sections--a low speed section and a high speed section. Tests of these often are not accurate, so replacement is the only real test.

Aug 12, 2016 | Nissan Cars & Trucks

1 Answer

The speedometer on my 1998 toyota D4 corona premio, 3s engine, suddenly drops when i step on the accelerator with the intention of increasing my speed. when i try to speed up the vehicle almost stops but...


GAS
3s-fse-d4-engine???? 3s-GE OR GE WITH RED BEAM? "VVT"
M./T OR A/T (STICK OR AUTO)
the key factor is engine RPM
if it rises, but not speed, that is trans./clutch slip
if no rpm rise that is weak engine , BUT IS THE RED BEAM.?

LOW POWER, 101
1: NEVER TUNED UP. BAD SPARK CLOGGED FILTES X2
2: ENGINE ecu stuck in limphome, scan it, see errors, BINGO
3: engine misfiring, cause by low compression, weak spark or bad fueling (too rich or too lean) many tests, ask.
4: low fuel pressure or regulator not regulation per FsM PAGE
5:STUCK OPEN egr main valve (missing in some countries)
6: melted cat converter , vacuum gage reads real bad,
7: and more, i charge more for more, LOL vvt?

ask or tell?
i want wild guessing
or I want to do the tests. to find it.

Gue$$ or Test.
toss coin.?


Jan 08, 2015 | Toyota Cars & Trucks

1 Answer

Any bodyis having the same problem.


Sounds like a bad ground or short Circuit.

Dec 29, 2014 | Cars & Trucks

1 Answer

Turn whhel real sharp on 2005 ford explorer left rear wheel wants to lockundefined


If you have four wheel drive, turning the wheels sharply at a slow speed when in 4X4 mode can result in a wheel binding. The other possibilities are low lubricant in the rear differential, wrong lubricant in the rear differential if it has been replaced, or a bad differential.

Oct 05, 2014 | 2005 Ford Explorer XLT

2 Answers

1994 corolla 160i misfires at low speed below 50km/h


unplug and clean each of the injector plugs, blow them out with an air hose real good.

May 29, 2014 | 1994 Toyota Corolla

1 Answer

Check engine light come on and the idle is real low


unsure which engine model you have. is a real common problem here with gdi v6 models,cleaning air mass meter(usually in ducted pipe connected to air filter) and throttle body with bottle brush and good carbon removing solvents restores the idle speed and ecl should go out. engine may be covered by plastic cover,this removes easily 4-6 bolts and allows access to throttle body failing that low idle could be limp mode.it triggers when either a major sensor faults or more that 3-4.the ecu will need to be checked for fault codes and then a plan of repair will be more effective

Aug 31, 2009 | 2002 Mitsubishi Galant

1 Answer

Automatic jeep cherokee 1998 tyres squeak when turning low ,low s


sounds like you may have a bad front cv axle inspect it you may find that i'm right ,and no you can't disarm the all wheel drive . hope this helps you!

Jun 20, 2009 | 1998 Jeep Cherokee 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...