Question about 1995 Ford Thunderbird

1 Answer

Trying to remove door latch on 1995 thunderbird. Car has power locks.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

Inside or outside latch? please rate

Section 01-14A: Handles, Locks, Latches and Mechanisms 1995 Thunderbird, Cougar Workshop Manual
REMOVAL AND INSTALLATION Latch, Door Removal and Installation

  1. Remove front door trim panel (23942) and watershield from front door (20124). Refer to Section 01-05 .
  1. Mark the location of the bolt retaining front door glass run front retainer (21572). Remove the bolt.
  1. Check all rod connections against the appropriate illustration. Correct any disconnected or loose connections and check operation before replacing parts.
  1. Remove power door lock actuator (218A42).
  1. Disconnect the rods from the front door latch (21812) . The front door latch remote control link (21940) and the latch-to-lock cylinder rod cannot be removed because of the rod's end configuration. Remove wiring from clip on front door latch shield.
  1. Remove front door latch control cylinder rod (22134) from the door lock cylinder (21985).
  1. Remove front door latch remote control and link (21818).
  1. Remove the front door latch retaining screws. Disconnect the door open warning lamp switch (14018) , if so equipped. Remove the front door latch from the front door .
  1. NOTE: Do not damage anti-theft shield.
    Remove anti-theft shield from the front door latch .
  1. Remove front door latch remote control link , front door latch control cylinder rods , and door open warning lamp switches from front door latch , where applicable.
  1. To install, reverse Removal procedure. Tighten front door latch retaining screws 4-8 Nm (36-70 lb-in).
trying to remove door latch - 3e933ef.gif

Item Part Number Description 1 21852 Front Door Latch Push Button Rod 2 21940 Front Door Latch Remote Control Link 3 386656-S Bushing 4 21978 Door Latch Shield 5 218A42 Power Door Lock Actuator 6 22134 Front Door Latch Control Cylinder Rod 7 21812 Front Door Latch
------------------------------------------------------------------------------------
Remote Control Assembly Door Latch
Removal and Installation
  1. Remove front door trim panel (23942) and watershield. Refer to Section 01-05 .
  1. Remove screw and washer assembly retaining front door latch remote control and link (21818) to front door (20124) .
  1. Rotate front door latch remote control and link to remove from front door latch remote control link (21940) .
  1. To install, reverse Removal procedure.

Posted on Sep 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 T-Bird key will not unlock or lock doors on either side.


The lock you stick the key into is mechanical. There is also an electric solenoid that moves the latch on each door.

Dec 20, 2012 | 1995 Ford Thunderbird

1 Answer

1995 ford futura doors wont lock


Inside the door is an electric motor that pulls the door lock down to the locked position, either the rod has come off to the door latch from the door lock motor or the motor has failed. Remove the door panel and check it for power when the button is pressed for the power locks, if it gets power then it is most likely the motor that is the problem.

Nov 01, 2012 | Cars & Trucks

1 Answer

How do you replace the front door latch assy on 1995 Ford F150 with power windows and power door locks. I am unable to disconnect the rod that connects the latch / lock to the solenoid so I can remove and...


You will have to cut the rivet holding the lock solenoid,you will need to move the solenoid around to un-hook it from the rod.Be careful because the part the rod hooks to is plastic and i already broke mine on my 1994 Bronco.while replacing the latch,consider replacing the cable for the inside handle-they stretch and makes you pull harder on the handle until it breaks the handle off.I got tired of replacing the plastic handle so i made one out of steel at my work.

Feb 26, 2010 | 1995 Ford F150 Styleside Regular Cab

2 Answers

The cross dock on the left side of the door on my 2003 Thunderbird broke. How do I replace it?


there is no part that i am aware of that is called a "CROSS DOCK" so to help you with this problem we need to know the correct name of the part, contact Ford parts and ID the part with the correct name

Dec 05, 2009 | 2003 Ford Thunderbird

1 Answer

Front outside door latch does not work


Remove the inner door panel which allows access to the door lock. Remove it and you should be able to remove the outer latch mechanism by removeing screws from the inside. Check both the lock mechanism and the latch for whatever broke or bent.

Oct 31, 2009 | 1995 Isuzu Rodeo

1 Answer

How do I replace the door lock actuator on a 1999 Mercury Villager w/o damaging the connecting rods and door track?


SECTION 501-14A: Handles, Locks, Latches and Mechanisms 1999 Villager Workshop Manual REMOVAL AND INSTALLATION Actuator —Power Door Lock, Front Removal
  1. Remove the front door latch. For additional information, refer to Latch—Front Door .
  1. Remove the power door lock actuator from the front door latch.
    1. Release the locking tabs.
    1. Remove the power door lock actuator from the front door latch.
583b623.gif
go here too

http://groups.yahoo.com/group/villagerquest/

Sep 26, 2009 | 1999 Mercury Villager

1 Answer

1995 honda accord door won't open.


you'll need to slide something into the window well and try to hit the latch

Mar 04, 2009 | 2000 Honda Accord

1 Answer

1995 Saturn SC door won't open from the outside.


you need to take the interor panel off and take a look the latch. the connecting rod from the outside handle to the the lock most likely is the problem.

Feb 24, 2009 | 1995 Saturn Sc

Not finding what you are looking for?
1995 Ford Thunderbird Logo

Related Topics:

2,363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...