Question about 1996 Nissan Sentra

Open Question

1996 nissan sentra power steering diagram

Hi, just replaced power steering pump and cant seem to locate where the second and larger hose on the ps resevoir goes too?

Posted by on

  • Anonymous Mar 24, 2014

    How to replace them both

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car is leaking power steering fluid can u give me the diagram for the high pressure power steering line


We do not have a diagram but follow the high pressure hose from the PS pump to the steering gear, clean it off with a pressure washer first and then you can id the leak which will be the high pressure hose I bet..

Sep 06, 2012 | 1996 Ford Contour

2 Answers

I cant find the power steering refill location....where the hell is the power steering thing. Can it be any more difficult to find..?


According to my service manuals the 08 Sentra has EPS or Electronic Power Steering and does not use any fluid or have a pump because it is an all electric system.

Jan 17, 2011 | 2008 Nissan Sentra

1 Answer

I need to know where is the oil presure switch of a 2003 ford windstar 3.8l


On a 1996 3.8 L Should be under the power steering on the block. Looking at the pulleys on the right side just above the oil pan. This would involve removing the pwr steering punp and hoses.

I don't know if a 2003 is different.. You could inspect the area visually to check it.

To get to replace it...
96 - 98 windstar 3.8 oil pressure switch is located under power steering pump. Remove serpentine belt and alternator. Remove PS pump pulley with special puller to get access to PS pump bolts. Drain PS pump and remove PS hoses. Remove PS pump.

Nov 30, 2010 | 2000 Ford Windstar

1 Answer

This is about the high pressure side hose from the power steering pump which has a sort of electric shut off. Dati nag leak at pinalitan ng bagong hose using the same valve. after 2 months, umingay na na...


First try to replace the Hi side hose w/ original one before u buy a PUMP assembly! U could buy cheaper part in Banawe, Young Bros. is the store, they could get u a replacement and original w/ discount!

Nov 11, 2010 | 1996 Nissan Sentra

1 Answer

Where is the inhibitor relay on a 1996 nissan sentra


It's in the black box between the washer fluid reservoir & power steering pump on the left hand side of the engine. The box has the relays clearly marked.

Jun 26, 2010 | 1996 Nissan Sentra

1 Answer

2000 Nissan Sentra Crankshaft Position and Replacement


Go to dealership they will give a diagram to locate every single one. I replace them on my daughter car. I believe there were three sensors. I exactly know what you are talking about. I had a hard time locating the back one right above the drive shaft on driver side.

Aug 27, 2009 | 2000 Nissan Sentra

1 Answer

Power steering leak/Squealing car


Sounds like you bought the wrong hose. also check the o-rings & be sure to use new ones when replacing the hose. Be sure you have it in right & not cross threaded. If it's cross threaded,you got a major problem. First it will always leak,second you probably ruined the pump or rack where it screws in. If it's engine oil,then buy a dye from the auto parts store of choice & have it checked by a shop with an ultra violet light.

Jun 28, 2009 | 1989 Nissan Sentra 4 Door

1 Answer

1996 nissan sentra transmission vacuum hoses diagram


you can try a Chiltons...to my knowledge no one has a diagram but they may illustrate the location of the hoses.

Jun 14, 2009 | 1996 Nissan Sentra

1 Answer

Power steering pump


This removal is rather involved: use a turkey baster to suction out PS fluid,disconnect neg battery cable, remove serpentine belt, raise vehicle, support on jack stands, disconnect Oxygen sensor wiring harness from vehicle wiring harness, (access to this connection is thru the wiring harness grommet in the floor of the vehicle) remove catalytic converter from the exhaust manifold, remove exhaust system hangers/isolators from the bracket on the exhaust system, move the exhaust system as far as possible to the rear and left side of the vehicle, remove accessory drive splash shield, detach the ps supply hose coming from the fluid reservoir, from the fitting on the ps pump, plug the hose to prevent fluid leaking all over, remove ps pressure line from pump, plug this line also, remove ps return hose, plug line, remove nut attaching pump (@ rear of pump) to mounting bracket, loosen 3 bolts at front ps bracket, remove pump and bracket as an assembly, now remove 3 bolts and separate, reverse to install. Yes, it's a b-itch. good luck, countrycurt0

Oct 07, 2008 | 1996 Plymouth Grand Voyager

Not finding what you are looking for?
1996 Nissan Sentra Logo

403 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...