Question about 1991 Pontiac Trans Sport

Open Question

Wipers stop intermittently. I have to push them to get the to move again. This is difficult driving.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 toyota corolla/ windshield wipers stop working on intermittent setting. have to push on blades to start moving again. is it relay, motor, switch?


hi there . think they may need a bit of wd40. spraying on the shaft.
probably just road dust and debris. making it stick.

Mar 01, 2014 | 2009 Toyota Corolla

1 Answer

Windshield Wipers not functioning correctly...slow and intermittent


did you try to direct your new motor to the battery only?....if you direct its fast that means your rod to the wiper are rusty or dirty try to spray some oil or grease...

Dec 09, 2013 | GMC Sierra Cars & Trucks

1 Answer

I have a 523i bmw and out of the blue the windscreen wipers stopped working. It is intermittent and they stop and start when they want to which makes driving in adverse weather quite difficult. Had a...


2things it could be,the wiper motor,or the switch that turns them on,if power is going to switch and it doesn't work,then maybe switch,apply .You can always take switch or motor back if they there not the problem.

Aug 03, 2012 | BMW 523i Cars & Trucks

1 Answer

My 2004 audi a4 windscreen wipers move across the windscreen very slowly then stop.they will then start up again and move slowly.sometimes they dont start first time and when they do their is only 1 speed-...


First you must diagnose why windscreen wipers going slow and/or stopping.
In order to find out the cause of wipers stopping you can try follows: 1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!! 2. Disassemble the plastic covers from the bottom of the windscreen. 3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables. 4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi. 5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters. 6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation! 7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.

Sep 06, 2010 | 2002 Audi A4

1 Answer

2007 Tahoe LTZ wiper washer gone crazy


Try replacing the wiper module.It is the part on the wiper motor that does all the functions when you push or turn on the wipers.To replace it you remove the cover from the wiper motor and you will see the circuit board.you can just pry it out with a small screw driver.Most dealerships have these in stock.When you replace it make sure and use a silicone sealer on the cover to keep the water out.Good luck.

Dec 07, 2009 | 2007 Chevrolet Tahoe

2 Answers

Wipers do not work in intermittent position. They do work in low and high speeds but do not automatically return to the park position. They stop wherever you turn the switch off.


i belive that your wiper switch has gone out on the intermittent side. this is a very common problem.
I hope this helps you
Thanks
Please leave rating

Apr 21, 2009 | 2000 Isuzu Amigo

1 Answer

Instructions for turning on back screen wiper on Ford mondeo 1.8


2 ways this could work. 1 is by pushing the wiper switch towards the dash.

2nd is when you pull the lever towards you, it will turn the intermittant wipe on, pull it towards you again to cancel.

TL

Jan 12, 2009 | 1999 Ford Contour

Not finding what you are looking for?
1991 Pontiac Trans Sport Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...