Question about Pontiac 2000

Open Question

I cant get any spark to the plugs to start it have changed the ignition coil module dont have any power to the radio at all and wont start at all it is a pontiac tempest the canadian version of the cutlass ciera and corsica and berreta

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It mayI have no fire going to the coil or from the coil to the plugs


Have you checked the wiring, the spark @ plug, Power to the coil???

Engine Won't Start No Spark - Auto Diagnosis Repair Help

aa1car.com/library/no_spark.htm
If your engine cranks normally but will not start because it has no spark, or it ... If an engine has a coil-on-plug ignition system with no plug wires, remove one of ...

No-start, No-Spark diagnosing simulated - YouTube

? 5:13
https://www.youtube.com/watch?v=XSWN1M8Hoqo
May 19, 2010 - Uploaded by FrankHurtAuto
Simulation of no start with no spark diagnosing, ... Ignition coiland module test with test light (ScannerDanner Premium lecture) - Duration: ...

getting fire from coil but not to plugs - CarGurus

www.cargurus.com > Questions > Dodge > Ram 1500

CarGurusJun 12, 2013 - 2000 dodge ram 1500 4x4 not getting fire changed distributor cap, coil, pickup ignition, rotor, plugs, plug wires 2 answers. ... 1994 dodge 5.9 just shut off and wont start back up there is no spark or fire from coil or plugs. ... 94 dodge van 318 eng will not start new plugs new crank ...

Ignition Coil Troubleshooting: (No) Fire in the Hole

www.secondchancegarage.com/public/coil-troubleshooting.cfm

Jan 27, 2016 | Cars & Trucks

1 Answer

Changed spark plugs and firing order is correct but truck wont start


well if it started before then the distributor is most likely good but check your ignition coil and also you ignition module also the pickup coil

Feb 26, 2013 | 1986 Ford Bronco

2 Answers

It turns but it wont start,it has gas and power


Pull off the coil ignition cable at the distributor and check for spark coming out of coil when cranking engine over. Use a heavy rag or glove to hold the wire 1/4 inch from a metal ground. Should see a strong blue spark when cranking to verify ignition is good. If no spark, check for battery voltage to coil on the coil primary. If you have current to the coil, suspect a bad coil, ignition module, crank position sensor, or cam position sensor, or pcm. The coil, ignition module, and sensors can be tested before replacing.

Jan 29, 2013 | Cars & Trucks

1 Answer

My 1990 hond accord will turn over but wont start can you please help


MAKE SURE SPARK PLUGS AND WIRES IN GOOD CONDITION, REPLACE DISTRIBUTOR CAP AND ROTOR,CHECK FOR SPARK AT SPARK PLUGS,IF YOU DONT SEE SPARK CHECK TO SEE IF POWER GOING TO COIL IF NOT CHECK IGNITION FUSE.IF FUSE OKAY AND POWER GOING TO IGNITION COIL,COIL FAULTY OR IGNITER UNIT FAULTY. CHECK FOR FUEL PRESSURE MAKE SURE FUEL FILTER BEEN CHANGED.FUEL PRESSURE SHOULD BE 40 PSI. IF YOU GETTING SPARK AND FUEL. YOUR IGNITION TIMING OFF OR VALVE TIMING OFF DUE TO A WORN TIMING BELT.

Nov 01, 2011 | 1990 Honda Accord

1 Answer

Will not start after it rains - have replaced fuel pump, fuel filter, ignition coil, plugs, plug wires, etc


you change cap and rotor? ignition module?, when it wont start either you dont have spark or fuel, tto check if you gave it a blast of starting fluid while cranking If starts and dies you got a fuel problem, if it just cranks you got a spark-ignition problem

Aug 07, 2011 | Chevrolet Tahoe Cars & Trucks

2 Answers

Change starter its tern but wont start no electriciti going too sparplug


CHECK TO SEE IF IGNITION COILS AND MODULE GETTING BATTERY POWER.IF NOT CHECK THE IGNITION FUSE.IF FUSE OKAY.YOU HAVE FAULTY IGNITION MODULE OR BROKE WIRE TO IGNITION COILS AND IGNITION MODULE..

Mar 02, 2011 | 1992 Oldsmobile Cutlass Ciera

1 Answer

1989 chevy 2500. started it up in driveway it died wouldnt start. changed ignition module drove it to town died wouldnt start again. got a diognostic tester which read throttle positioning sensor changed...


I WOULD CHECK IGNITION FUSE TO SEE IF POWER GOING TO COILS AND IGNITION MODULE. REPLACE DISTRIBUTOR CAP AND ROTOR.HAVE IGNITION TIMING CHECK.DISTRIBUTOR CAN SLOWLY WORK A LOOSE JUST A LITTLE TO THROW OFF IGNITION TIMING SO PLUGS WONT GET NO SPARK.

Jan 04, 2011 | Chevrolet 2500 Cars & Trucks

1 Answer

I changed spark plugs, wires,and ignition coils and noe my truck wont start. its a 2.2 chevy s10. 1994. i dont know what it could be. HELP


Do you have spark?, if not, under your coils is a module (like a plate that the coils mount too) That may be the issue.

May 26, 2010 | 1994 Chevrolet S-10

4 Answers

Car turns over will not start no spark at the spark plugs


CHECK IGNITION MODULE FUSE.AND CHECK FOR POWER GOING TO MODULE AND COILS.IF NO POWER PROBLEM IN IGNITION MODULE FUSE OR LOOSE BROKEN WIRE.IF POWER GOING TO IGNITION MODULE.THE IGNITION MODULE FAULTY.TO SAVE MONEY AND TIME.HAVE CAR SCANNED TO MAKE SURE YOU DONT HAVE ECM OR PCM PROBLEMS.YOU DONT WANT TO BUY A IGNITION MODULE IF YOU DONT NEED IT BECAUSE THEY COST FROM $100.00 TO $200.00.THATS WHY SCAN IT FIRST.

Apr 04, 2010 | 1991 Oldsmobile Cutlass Supreme

1 Answer

1999 mazda prodege 1.6 wont start


no spark. maybe a broken timing belt, bad coil,crank sensor,ecm,ignition module,etc.

Aug 19, 2009 | 1999 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...