Question about 1988 Toyota Celica Liftback

Open Question

I NEED A STEP BY STEP DIRECTIONS ON HOW TO CHANGE THE RADIATOR FLUIDS ON A 1988 TOYOTA CELICA? I DON'T WANT TO PAY SOMEONE ELSE TO DO IT.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My toyota Celica is not circulating water in the engine. I have changed the thermostat and checked the radiator but still it keeps on heating up and does not allow water in the engine.


IS YOUR THERMOSTAT (OEM) OR (AFTERMARKET) GENERIC FROM AUTOPARTS, IT ALMOST SOUNDS LIKE YOU DON'T HAVE THE RIGHT THERMOSTAT ON IT...

I.'M ALSO ASSUMING THE YOUR WATER PUMP IS WORKING CORRECTLY RIGHT ? IS WORKING CORRECTLY RIGHT ?

Oct 10, 2012 | 2000 Toyota Celica

1 Answer

What is the fuel pressure of a 1992 Toyota Celica?


Direct fuel pump pressure is 60 -80 psi, and regulated fuel pump pressure is 38 - 44 psi.

Jul 24, 2012 | 1992 Toyota Celica

1 Answer

2000 toyota celica gts,no heat,overhe4ating,changed thermostat,same problem.not loosing any fluid n no water n oil


Hi, the indication is a possible blown head gasket. Such a leak can create an air bubble that hangs at the heater hose. To verify, park on an incline, open the radiator cap, run the engine until the thermostat is open, and fill the radiator to the neck. Wait until the level stops dropping and make sure bubbles don't continue to come up. If they do, you may have a blown head gasket that will keep forming these bubbles until you change the gasket. When the haed gasket causes overheating, it is usually leaking quite a bit of gasses into the coolant system. If this is not the problem, please see my tip at http://www.fixya.com/cars/r6235876-no_heat_fan_blowing_cold_air for additional troubleshooting steps. These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Jan 01, 2011 | 2000 Toyota Celica

1 Answer

If you have an 1988 old car and you wana keep it for as long as possible what things should be taken care of or changed over the years to run the car at its best


Keep a very close eye on your regular service items, trans fluid flushes, oil changes, and flush your other fluids as well, ie... brake and coolant.A very important item is to replace your timing belt at the specified intervals or it could fail and cause massaive internal engine damage.Hope I could help!!!

Apr 27, 2010 | 1988 Toyota Celica Liftback

1 Answer

I need step by step instructions on how to bleed brakes on my 2005 toyota celica


If you don't have someone to help you you'll need to get a one man brake bleeding kit. The bleeding kit will take the place of the helper. IF you have a helper start with the rear passenger side wheel (furthest from master cylinder). Remove the wheel, have a helper sit in the vehicle and pump the brakes several times (motor off). Tell them to hold the pedal down while you open the bleeder screw. Tighten the bleeder screw before the helper releases the brake pedal to avoid sucking air back into the line. Repeat this process until the fluid flows out of the bleeder with no air. Then repeat these steps on each wheel. The order of bleeding is always furthest from the master cylinder. Rear passenger, rear driver, front passenger, and lastly front driver. After each wheel is done check the fluid level in the master cylinder and add as necessary. You don't want it to get low and **** air in from the cylinder.

Nov 06, 2009 | 2002 Toyota Celica

1 Answer

I cant find my starter in toyota celica 1988


look under intake manifold under car or under exhaust manifold it could be in the rear of the engine or in the front but check those places.

Jul 05, 2009 | 1988 Toyota Celica Liftback

1 Answer

98 Celica overheating problem


c7d7b55.jpg Cooling Thermostat.
Look along the radiator hose where it enters the engine. This controls the water temperature.


toyotacelicathermalfanswitch.jpgToyota Celica Thermal Fan Switch The Toyota Celica thermal radiator fan switch is usually located in the radiator or the engine block and has 2 or 3 wires coming from the unit. The 3 wire switch has a dual sensor for dual speed radiator fans. The Toyota Celica thermo fan switches come in the factory temperature settings and also come in cooler thermostatic settings so the fan will come on at a lower coolant temp.

The Toyota Celica cooling system is made of aluminum components and requires a Phosphate free coolant. DO NOT PUT an over the counter antifreeze in your Toyota Celica, as it will ruin the radiator and water pump.

Feb 19, 2009 | 1998 Toyota Celica

1 Answer

Trunk lid hinge replacment


lift trunk lid and support it
unbolt hinges
remove trunk lid
bolt in new hinges

Dec 31, 2008 | 1988 Toyota Celica Liftback

1 Answer

Toyota celica 2.0gt


it sounds like your head gasket unfortunately

May 23, 2008 | 1995 Toyota Celica

Not finding what you are looking for?

Open Questions:

See all 1988 Toyota Celica Liftback Questions

Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...