Question about Hyundai Sonata

2 Answers

I have a 2002 hyundai sonata that makes a clicking noise when you turn the wheel, I was told the front axles might need changing and if so what procedures need to be taken to do this repair?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,280 Answers

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Posted on Oct 03, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

Determine which axle is bad. Usually pretty obvious, the one that the rubber boot is ripped open. Remove wheel, outer tie rod end from spindle, lower ball joint from spindle, pry down with long heavy bar on lower control arm to disengage ball joint stud, Large nut from end of axle. Pull spindle away from car to get axle out of spindle. Carefully pry between axle and transmission to disengage axle.

Posted on Sep 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 hyundai sonata lx ,replaced passenger side drive axle.had to use great force to get inner back on.why? also still have same thumping noise coming from same area at highway speed.also makes an almost...


You had to use force because the splines are no longer aligned. The noises are made by the hub bearings, it's worn out and you must replace them. If the bearing is severely worn out it would also explain why the splines are no longer aligned.

Jul 10, 2011 | 2006 Hyundai Sonata

1 Answer

Car makes a big clunking noise when you first start to move


Hyundai Sonata is a front wheel drive.
When moving in a straight line,the noise will be from motor mounts,transmission mounts and stabilizer support from the top / front of the engine.
Inspect for rubber bushing ware and loss mounting.
Lift up the vehicle with jack stand or a shop lift to give a better view of the worn parts.
======
Check the CV plastic boot axles.
A worn CV will make noise on tight turns.
======

Jan 28, 2011 | 2005 Hyundai Sonata

1 Answer

2009 Hyundai Sonata- Car is making a ticking, sometimes clunking noise from the front left side, when making a left turn. What could be causing this noise?


That will be your front axle or your left side ball joints, have them checked out, it will not be an easy fix or something that you can do yourself, it will continue to happen and wont get fixed with time.

Jun 12, 2010 | 2009 Hyundai Sonata

1 Answer

How do I change the front wheel bearing in a 2001 Sonata 6 cyl


jack the front off the ground remove the tire remove the brake caliper remove the rotor remove the bolt hol;ding the front axle into the spindle hub, remove the hub and bearing.

May 06, 2010 | 2001 Hyundai Sonata

1 Answer

Clicking noise when turning right


check your cv axles in the front end. they are basically your drive axles. the popping while turning is usually the outer boots on the axle shafts have torn and the grease inside the boots has ran out causing the shaft to be dry and click or pop when steering. usually you can replace the boot thats torn but it must be done within a few days of it tearing otherwise you will need to replace the axle shafts.

Aug 10, 2009 | 2006 Hyundai Sonata

2 Answers

Need front passenger window regulator, tracking,


The only real difference that their should be is going to be Left/Right Front/Back

Just make sure you purchase the correct one that you are actually going to replace

Jul 03, 2009 | Hyundai Motor 2002 Sonata

1 Answer

Clicking noise in front after hitting smaller bumps


it is the front strut i am a certified mechanic i have changed many of these

Feb 02, 2009 | 2002 Chevrolet Malibu

1 Answer

My wife says it's making a noise like a wheel falling off


If it makes a clicking noise when turning it could be the axles. Check the rubber axle boots and see if they are torn open. If they are that lets the grease out and will wear out the joint.

Jan 26, 2009 | 2002 Chrysler Concorde

1 Answer

2000 Hyundai Sonata right front axle


It does come with the axle. That is the counter balance.

Sep 15, 2008 | 2000 Hyundai Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

628 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...