Question about 1994 Jeep Grand Cherokee

1 Answer

Where is the fuse for the ignition - 1994 Jeep Grand Cherokee

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Should be in the power distribution center near the battery. sub-fuses for computer are likely in the cabin fuse panel

Posted on Sep 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 chevy surban that keeps blowing the ignition fuse what can cause this


You have a direct short to ground on that power feed circuit . You need to find a power distribution diagram to see what all gets is power from that fuse . Isolate the circuits till the fuse doesn't blow any more , then trace out that circuit that blows the fuse .

Which Ignition fuse ? Which fuse box is it in ? under hood , passenger compartment ?
IGN A
40A
Ignition Switch RUN, START, RUN/START/ACCY
IGN B
40A
Ignition Switch RUN/ACC, RUN/START
Could be ignition switch problem , Chevy has had problems with them .

Jul 06, 2016 | Cars & Trucks

1 Answer

No start no power to ignition coil tested high current fuse panel no power there either 1994 ford Taurus 3.8 fuel injected


Ignition switch supply's B+ voltage to ignition coil fuse in the engine compartment fuse box , 10 amp fuse . If no B+ voltage there check ignition switch .

Dec 16, 2015 | Ford Cars & Trucks

1 Answer

Lost power to ignition,power window's and heater.


look for the fusible link located from battery to starter or from the starter to the ignition.

May 28, 2013 | Cars & Trucks

2 Answers

Car turns over but won't start fuel injector fuse and ignition fuses are good but no power is getting to them. also the stereo and wipers only work when ignition is on accessory. when its on r


Sounds like it could be a bad ignition switch-the electrical part, not the lock cylinder. When key is in the on position (run), those fuses should be powered. Are all the maxi-fuses good? They distribute power throughout the car's electrical circuits-like the fuse panel, for instance, so check the maxi-fuses. If good, probably the ignition switch is bad.

Apr 03, 2013 | 1997 Pontiac Grand Am

1 Answer

Diagram of a 2000 chevy express wiring of a starter


( one question i have is every time the ignition fuse blows do i need to replace the starter relay? ) NO ! You have a dead short to ground on one of the circuits that fuse feeds. Do you know how to find a short circuit ? Video's on youtube show how. The fuse that blows ,is it IGN - A 40 amp. located in the under hood fuse/ relay center ? That fuse feeds B+ voltage to the ignition switch ,which powers up other thing's ,fuse's etc.. Not just the starter relay ! I see five other fuse's that get power from that fuse when ignition switch is in the start or run position . In the I/P fuse panel the gauges fuse #4 10amp , air bag fuse #10 10amp , turn b/u fuse #16 20amp. , Plus trans fuse #20 10 amp ! Pull out these fuse an try to start the van. if the ignition fuse doesn't blow the problem is in one of these other fuse circuits. There is one more fuse that get's B+ power from the ignition switch and ign A fuse ,crank fuse fuse #8 10amp. this powers the control side of the starter relay .
You can find a free wiring diagram here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine . Under system click engine , under subsystem click starting. Click the search button then the blue link.
If you pull those fuse's i mention and it still blows the fuse look for a shorted ignition switch or wiring from ignition to the starter relay , not the relay itself. Park neutral safety switch . Isolate the circuit , pull the relay out of it's socket ,pull the crank fuse #8 in the I/P fuse box. with a ohm meter check to see if that part of the circuit is shorted to ground. Do you know how to do that ? Do you have a volt ohm meter ? You can buy one cheap at parts store .

Sep 14, 2017 | 2000 Chevrolet Express Cargo

1 Answer

2000 silverado 1500 no spark


check ignition fuse to coil and check see if power getting to coil if yes ignition coil or ignition module faulty.if no power getting to coil and ignition module more likely you have blowed ignition fuse or faulty wiring from ignition fuse box terminal to the ignition coil and module.

Nov 06, 2011 | 2000 Chevrolet Silverado 1500

1 Answer

I have no ignition spark, i blew the 80 amp fuse, by jumping with a charger jumper boost , sence then there is no ignition spark, fuse has been replaced . is it possible the computer modual is fried or is...


yes there is a fuse that controls the ignition aswell you could have blown all those underhood relay fuses, an ive seen people fry computers doing this aswell, check/replace bad fuses an if its still a no go, try an do a diagnostics check on it

Feb 12, 2011 | 1991 Toyota Camry

1 Answer

Fuse for ignition


There is no single fuse for ignition. If if is a major fault with heavy duty circuits ie Glow plugs, Alternator, A/C etc , there are H/D fuse links at the battery positive connection (or close to ) If you mean the ignition on the dash it's most likely a connector problem as wipers / heater / radio / lights/ are protected by multipal fuses and not a single ignition fuse .

Apr 05, 2010 | 2000 Chrysler Grand Voyager

1 Answer

Is there a inline fuse from the ignition switch to the ignition coil?


no sir
not from the switch to the coil.
the coil does not get power from the switch.
the switch turns relays on that powers the coils.
but there is an ignition fuse.
the ignition switch turns on power relays from the battery that powers the ignition system.
the ignition system fuse is in the fuse box.

hope this helps
thank you
jm

Jul 29, 2009 | 1995 Ford Explorer

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...