Question about 2007 Jaguar XK8

Open Question

1999 xj8 - turn key all dash lights up like normal but nothing happens...sometimes it will take one try and other times it may take 3-5 tries. In each try I remove the key and try again.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: Get error message on dash.

Hi,

To my understanding, it is directly neither a wiring problem nor a computer problem. Technically the the computer is affected but it is not the source of the problem. The computer needs the dashboard cluster/instrumentation as part of its sensor array/feedback and therefore will not function correctly in the absence of the signals from the dashboard.

There are specialist for this kind of troubles which unfortunately is not an easy user repair. Perhaps your best bet then would be to consult or seek the services of these qualified professionals. Pls try Mr. Wizard. You can verify if your particular model is repairable by them here.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Posted on Aug 30, 2008

Ad
CMR_Racing
  • 24 Answers

SOURCE: turn key nothing happens no clicking noises

Starter, altinator

Posted on Dec 13, 2009

  • 1 Answer

SOURCE: how do I get a hold of a front bearing removal tool for my XJ8

All you need to remove the abs reluctor is a 12 point 2" socket. No special jaguar tool needed.
Rick

Posted on May 06, 2010

  • 1374 Answers

SOURCE: 1999 Izuzu Trooper will not start

Try neutral start switch. Use shop manual to determine its location on an automatic vehicle. If vehicle is a stick its attached to clutch pedal via lever. To test it remove it from its connectors and make a jumper wire and jump the circuit if car starts you found your culprit.

Posted on Jun 23, 2010

  • 33 Answers

SOURCE: 1999 euro van wont start. When I turn my key all

make sure battery is charged good if so replace starter. the starters have a history of doing this

Posted on Jun 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Saab 9-3 1999 Car wont start turn key nothing happens


1. Try locking and unlocking of the doors five times with the remote to reset the immobilizer.

2. Key in ON position push Open button on key fob.

Jan 29, 2014 | 1999 Saab 9-3

1 Answer

Turn key all light come on as a normal start. but when key is turned nothing happens. no noise nothing.. keep trying and eventully starts.Sometimes 3 or 4 times.. Sometimes 10 min. later. it can be days...


You didnt list the type of car this is, the most common thing that causes this is the starter, i just had a saturn, the customer had the same problem we told her it may be the starter but cant be 100% sure until it actted up, she didnt want to replace it unless we were sure, so we kept and drove the car around for 5 days and finally the last day it didnt start and it was the starter , same problem turn key and nothing no noise and no start, i would have the starter replaced and go from there, its a mater of time before the car just wont start,hope this is helpful.

Jan 08, 2011 | Chevrolet Aveo Cars & Trucks

1 Answer

2000 Olds intrigue: When i turn the key nothing happened. All the lights came on (like they would if it normally started). There was no clicking noise - nothing. I tried shifting the car from park...


if an ignition switch fails, sometimes you can jiggle the key and it will start right up. its very hard to tell. but if you can start it by bypassing the ignition switch, then its the switch itself. go to this site for more detailed info--- aa1car.com/library/1999/cm119948.htm---this page should help. click on top link.

Dec 22, 2010 | 2000 Oldsmobile Intrigue

2 Answers

My 1999 tahoe has a security problem. The light comes on and goes off it will start.If the light flashes it fails to start. can you help


The pass lock is beginning to fail.You can try reporogramming it following this procedure. If it still continues to happen the pass lock/ignition tumbler may need replaced.
PASSKEY LOCKOUT RESET ALL GM CARS 1999 AND UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the PASSKEY system to recognize your key
.

Sep 23, 2010 | 1999 Chevrolet Tahoe

2 Answers

Ignition wont turn when you put in key


Try rocking the steering wheel side to side slightly while turning key. Sometimes these bind in a such a way that it prevents the ignition from turning. This is normal.

Jan 30, 2010 | 1999 Dodge Caravan

1 Answer

1998 oldsmobile sometimes starts


Battery could be not holding a consistent charge. If not, Voltage regulator, starter motor or starter solenoid need replacing....Bad wire connections to all 3 also possible. Voltage regulator should be least expensive to try through process of elimination

May 11, 2009 | 1998 Oldsmobile Intrigue

1 Answer

2008 nissan sentra has occasional starting issues. this has happened 4 times since we bought the car. car runs fine, sometimes will not start when key is turned. everything is dead....no lights inside, no...


Could be bad battery or Somthing going on with the main fuse box.  Another thing to check is your ground wires.  If they are loose, you can not complete the circut.

Mar 03, 2009 | 2008 Nissan Sentra

2 Answers

2001 XJ8 keyless remote programming


This is the procedure from the service manaul:

JAGUAR
XJ8 Remote Control Programming
1. Unlock the Boot/trunk with key.
2. Turn Ignition on.
3. Warning light on dash comes on.
4. When they go out, lift arm rest, inside their is a valley button, Press 5 times within 5 secs of lights on dash going out, Horn & Lights Flash.
5. Press any button on remote, remote programmed.

Jan 16, 2009 | 2006 Jaguar XJ8

1 Answer

Keyless entry not working


Try re-programming the remotes, here is the procedure for your car.
JAGUAR
XJ8 Remote Control Programming
1. Unlock the trunk with key.
2. Turn Ignition on.
3. Warning light on dash comes on.
4. When they go out, lift arm rest, inside their is a valley button, Press 5 times within 5 secs of lights on dash going out, Horn & Lights Flash.
5. Press any button on remote, remote programmed

Dec 11, 2008 | 2006 Jaguar XJ8

Not finding what you are looking for?
2007 Jaguar XK8 Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...