Question about 2001 Mitsubishi Galant

Open Question

Replace starter on 1996 mitsubishi galant - 2001 Mitsubishi Galant

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 155 Answers

SOURCE: can not find the starter on my mitsubishi galant

The starter is located between the firewall and the engine
below the fuel injection assembly.

Posted on Sep 01, 2009

  • 234 Answers

SOURCE: Starter on 2001 mitsubishi galant es 2.4L not working

dont know exsacly where is but should be where gear box meets engine and it sounds like the soliniod is stuck or gone or starter could be stuck in engine if manual put in gear and rock back and forward this may help relase it

Posted on Jun 06, 2009

  • 11 Answers

SOURCE: 96 Mitsubishi Galant won't turn over

check the charging from alternator if ok you might have a blown fuse ect if no charging 14v id say alternator brushes . or regulator in the alternator

Posted on Aug 26, 2009

  • 438 Answers

SOURCE: 2002 mitsubishi galant,how to replace the starter

It's fairly easy, albeit a tight fit. Before you start, be sure to disconnect the battery. The starter is located between the firewall and the engine, underneath fuel injection assembly. Stick your hand in there and you should be able to feel how the starter is positioned. There are 2 or 3 bolts holding the starter and they're easy to remove. You need to disconnect the wire on the starter coil (the coil is located on top of the starter itself).
Now the fun part: removing the the starter itself. The way I did it is by wriggling it out the open space on the left side of the engine, hence the tight fit. Move any cables or wires that may get in the way for more room. (Important advice: Remember, patience is a virtue!)And there ya go! To install/re-install the starter just do the reverse. It's a lot easier to put it back in than removing it. Good luck!

Posted on Sep 28, 2009

  • 3 Answers

SOURCE: Need help in locating starter on a 2001 mitsubishi

they at the back of the motor just at the top or could be at bottom at back of gearbox

Posted on Jan 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Blown starter fuse


Check the starter solenoid for a short to ground.

May 20, 2014 | 1996 Mitsubishi Galant

2 Answers

Im replacing the starter on my 1995 mitsubishi galant. I need a picture of the wire hookup to the starter.....you know, which wire goes to the negative and so forth


this might help...Same concept ..3 wires http://www.google.com/search?q=how+to+install+a+1995+mitsubishi+galant+starter&um=1&hl=en&source=lnms&sa=X&ei=TO4OUqrrHMaB2gXtmYCgAw&ved=0CAgQ_AUoAA&biw=1024&bih=672#bav=on.2,or.&fp=1cb0759d76b6b3f9&hl=en&q=1995+mitsubishi+galant+how+to+replace+the+starter+

Aug 17, 2013 | Cars & Trucks

1 Answer

1996 Mitshubishi Galant ES, 4 cyl. when i turn the key it clicks n doesn't always start, i have radio, lights, new battery, ignition switch, starter and selinoid some times it's worse than other times.


it sounds like you may have a bad wire leading to your starter selenoied try replacing the wireing to your starter and when you make the connections put some dielectric greese on the connections to prevent carrsion

you may also have a bad relay replace it before you replace the wires to your starter

i hope this helps

Aug 06, 2010 | 1996 Mitsubishi Galant

1 Answer

Mitsubishi galant 1996 manual filing order


1996 Mitsubishi Galant 2.4 liter SOHC L4

d65cad5.gif


Hope this help (remember comment and rated this post).

Apr 29, 2010 | 1996 Mitsubishi Galant

1 Answer

Not starting - always need to use jump starter


your ignition module is bad or has a crack in it i know my dads vechicle does the same thing. for futher help please call 419 689 1114

Apr 17, 2010 | 1996 Mitsubishi Galant

1 Answer

II have a galant 96 model.when I turn the key nothing happens,exept the lights go dem.starter is good,battery good,posts r good.can any one help


sound like ur starter might b jammed. U could try tapping on it and see if u hear it releast.Also recheck ur connection again. Ur alternater might b grounding out too...U need a shop

Mar 09, 2010 | 1996 Mitsubishi Galant

1 Answer

I think my starter is going bad on my 1996 Galant


take your car to a starter rebuild shop, they should be able to tell your problem. the starter has plastic plantary hud with metal gears, that the noise you hear. the starter needs to be greased

Jan 04, 2009 | 1996 Mitsubishi Galant

Not finding what you are looking for?
2001 Mitsubishi Galant Logo

Related Topics:

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...