Question about 1999 Ford Explorer

1 Answer

Car will not turnover/start. I got in it cranked up fine, I backed up, pulled back in to run inside house and it would not turn over. lights, radio and door open sounds are strong and working-so it doesnt seem to be my battery.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 532 Answers

Probably is what happenened to my pick-up,try putting it in neutral,try starting it,if it starts then get the shifter linkage adjusted,may not be going all the way into park.If this is the case then the vehicle may roll away in park so set the emergency brake until it gets fixed.

Posted on Sep 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 sebring convertible won't start or crank has lights and power but no radio tried #8 fuse but doesn't work


i have the 2.7 as well. mine is in an intrepid. Car was running perfectly fine when i went into bestbuy and when i came out 5 min later i tried to start the car and it would just crank n crank. no start though. eventually it started after lots of cranking. after a couple of times of doing this in order to start the car i would get nothing from the startrer. everything had power and everything electrical worked. found out that if i went under the car and hit the starter with a hammer a couple of times it would finally crank again. but i had to do this every time i shut the car off and wanted to start it again. i loive in WI and its wintyer right now so it really sucked to do this. took it to my buds shop and pulled the starter out and dissected it and found that the (i believe they are "brushes") were ground down to next to nothing, the positive ones, do to constant cranking. was going to get a starter from junk yard for 20 befor i knew what the problem was. did some calling around and found brand new brushes for $20.00. i just got those and installed them and had a good as new starter again. lots of dust to clean out of the housing though. brake fluid and air hose works wonders for that problem. but from best buy on the car would not start without starting fluid if it was at running temp. still yet to solve that one. replaced the cam sensor, crank sensor, plugs, COP's and checked the rest of the sensors. still cant figure this out. anyone have advice let me know what i can check. fuel pump kicks in wen the key turns as well...

Jan 12, 2013 | 2001 Chrysler Sebring

1 Answer

My 1995 Mazda Protege 1.5L was running fine. We were driving home and the car cutoff, will turnover but will not crank. I can take the oil cap off and see one of the CAM's turning and turning freely


if you can see the cam shaft turning then the timing belt is ok
run the fault codes and check for crank position or cam shaft position sensor failures
one or the other or both are candidates for your problem

May 18, 2017 | 1997 Mazda Protege

1 Answer

2000 ford focus sedan 2.0 dohc ztec engine rear


check all battery leads and earth straps
"" car body and engen bay straps""
also check battery terminals are tight check its full of battery water too if its been low for a time bump it!
and have a ""drop meeter test"" done on the battery if its a bad battery it should show that up first time it could have cracked plates inside the battery its self, test by turning on head lights then hit starter, if every thing go's dead!!!! put ""good jump start"" battery on to car and try it again,,, all should work just fine then,,,,it could just be a flat battery?????

Oct 27, 2009 | 2000 Ford Focus

1 Answer

Car tries to start but doesnt, it just spits & sputters


I had the same problem all of these models do, but GM wont recall them. Here is what you do if you have not yet, turn to key to on but don't start the engine all the lights in the dash will go on, when they turn back off see if your security light stays on or blinks. If it does its your Pass Lock security system. You can reprogram it using the key, take the key out then put it back in the ignition move it all the way to ON but don't turn on the engine when the lights in the dash go out turn the key back to the ACC position leave it there for ten minutes the light should turn off after about ten min. then turn the key to the OFF position pull it out about 1/4 of the way then push it in and start it up. If this is the problem you may have to do this any time it does not start up.

May 28, 2009 | 2001 Pontiac Grand Am SE

2 Answers

Starter clicks car wont start. Plastic metal smell.


the starter it self......if it doesnot crank it is the starter........

the starter probably has one or two chipped teeth..."if you can try going under ur car and remove the starter......

hope this helps man ! XD

May 14, 2009 | 1994 Chrysler Concorde

1 Answer

1997 Saab 900 se Turbo won't start.


FUSES ARE LOCATED IN THE ELECTRICAL DISTRIBUTION BOX ON THE LEFT HAND WHEEL HOUSING UNDER THE HOOD.

Apr 22, 2009 | 1997 Saab 900

1 Answer

My 1997 Honda Accord LX 4 door wont start. The car was running fine the night before.The next morning I tried to start it, and it wont even crank. The battery is good, I checked it out. All the lights and...


Hi
Try to jump start the car.
Put the jump leads on and leave it for 10 mins
that will charge the battery up
then try and start.
Also check the starter motor.

Jul 17, 2017 | 1997 Honda Accord

1 Answer

Car will not start after I pulled the fuse for my radio


Thats because on the G6 your entire control center and brain of your car is ran through your radio. Without the fuse to your radio, there is no current getting to the controllers for the G6's quick click auto start feature. The G6 does not use a regular starter cylinoid like most cars older than 2004-2005. The controlling signal of starting your car when you click your key over for that split second is run through systems housed and integrated in the radio.

Mar 01, 2009 | 2006 Pontiac G6

1 Answer

My 1997 Dodge Avenger's engine won't start


Try cam and/or crank sensor. If crank to cam timing isn't detected properly it'll crank all day but won't start. I had similar problem on my 2.5L V6 Avenger....drove home fine, no engine light, next morning it cranked, but wouldn't start. The crank sensor was faulty.

Jan 11, 2009 | 1997 Dodge Avenger

1 Answer

Electrical strangeness 94 Concorde 3.3


DEar Customer,

you have to check YOUR CONNECTION OR WIRINGF OF YOUR CAR BATTERY,& OTHER INDICATION SYSTEM,

THIS MUST HAPPENS WITH CAR WHEN CAR CONNECTION MAY GOES LOOSE,OR DISCONNECTED FULLY,

reconnect this all after cleanings all wirings & connectors,

THNX

May 20, 2008 | 1994 Chrysler Concorde

Not finding what you are looking for?
1999 Ford Explorer Logo

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...