Question about 1995 Chevrolet Camaro

1 Answer

Starter installation on 1995 z 28 camaro auto

Starter installation on 1995 z 28 camaro auto trans

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 713 Answers

This is the old square body style car correct. Not hard to do, disconnect the positive battery cable from the battery. Pull the car on ramps and set the emergency brake or put on stands. Crawl under the car on the passenger side and disconnect the wires from the starter one should be a 9/16 and the other is probably a 3/8. Remove the rear support bracket if it has it should go from the rear of the starter to the engine. Then remove the two starter bolts possibly a 9/16 also careful to pay attention to any shims that might come out of it then pull the starter out of the bell housing and replace with new one and reconnect everything.

Posted on Sep 27, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Starter quit working on 1989 camaro 350 tunport put a new one on tsill wont do aneything when every thing ealse works

Grab a volt meter and check your battery out. Take a look at the condition of wiring and connections on the battery, alternator and starter. whatever the cause it seems likely the start is not the issue here, often time 'no start' conditions can be linked to a faulty charging system. There is an excellent article available regarding this topic on,

Auto Absolute Home Page

Feb 22, 2016 | Cars & Trucks

1 Answer

How can I jump the starter on my 91 camaro?

hot wire starter you can short out ignition switch and wiring. to jump starter ignition switch start have to run 10 gauge jumper wire from the starter solenoid positive battery terminal to starter switch or S terminal on starter solenoid this procedure take two people but better remove starter replace starter solenoid. trying jumping off starter on camaro would be dangerous you have jack up car to get to starter and wiring person laying under car hot wiring starter while other person hold ignition start position put person under car in deadly position just remove starter have auto parts check it out first replace starter or solenoid if either bad. easier hot wire starter if starter under hood like my 1977 vega monza had starter at top could take long screw driver jump starter off.on the four cylinders engines back in the 70s. camaro starter under car dangerous trying to hot wire not a good idea.

May 07, 2013 | Cars & Trucks

1 Answer

My 91 camaro wont crank, all we get is a clicking noise and we tried jumping it to see if battery was the problem, but still just clicking when trying to crank it..please help..

sounds like a bad starter solenoid it is located on top of the starter remove starter take it to a auto parts store and have it tested

Apr 30, 2012 | 1991 Chevrolet Camaro

1 Answer

Where is the starter located on a 97 camaro

left side of the block at the trans under the car

May 08, 2010 | 1997 Chevrolet Camaro

1 Answer

How to put a starter in a 1998 camaro

disconnect the battery.

remove the wire from the starter.

remove two bolts (probably 1/2 inch) from the starter

take to auto parts place - exchange for a rebuild.

bolt in the new starter

attach the cable

connect the battery

Apr 28, 2010 | 1998 Chevrolet Camaro

1 Answer

Need to install a timing gasket cover set....aproximately how long should that take?


Nov 07, 2009 | 1995 Chevrolet Camaro

1 Answer

Putting a transmission in a 1988 camaro

remove all trans bolts,starter,remove torque converter bolts, trans jack and remove trans cross member and drive shaft assembly and drop trans.

Sep 14, 2009 | 1988 Chevrolet Camaro

2 Answers

Could anyone confirm for me the tranny behind a '94 3.4L camaro?

i'm not sure if its the same or not but for a 94 camaro i'm coming up with 4l60-e for the auto trans, i can confirm this by running a vehicle build if you send me the vin number, i work at a gm dealer so i can look things like this up

Jun 20, 2009 | 1994 Chevrolet Camaro

1 Answer

Power to ignition, wont start 83 Chev,4*4 auto tran. 350

Check neutral start switch. On stick cars, above clutch pedal. On auto trans, likely above steering post. If I remember correctly, has two 12ga purple wires going to it.

Dec 29, 2008 | 1983 Chevrolet Camaro

1 Answer

Starter on a 1988 camaro iroc z

go to your local auto zone or advance and get a manual and look it up!! hell jus go in with a friend and pick da book up and jus walk around like your looking and read up on it!! I would have to check others but im sure i people that know!! Let me know if you are unable to do this!

Sep 27, 2008 | 1988 Chevrolet Camaro

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides