Question about 1995 Ford Econoline

1 Answer

ROUGH IDLE,CUTS OFF WHEN SHIFT TO REVERSE - 1995 Ford Econoline

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Should read trouble code 634 on a diagnostic.
The problem is the manual lever position sensor, located on the side of the transmition at the linkage.

Posted on Sep 29, 2009

Testimonial: "have't tried yet.sounds reasonable.thanks for advice.will post result later"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I change coil pack,transmission speed sensor but the engine still in rough idle


Would search first inlet air leak in between air box and engine - all hoses on, clamps tight no cracks
then disconnect idler control - about where the engine accelerate cable comes in / most probably opposite. Problem still there?
look for ignition - plugs, check leads with multimeter, connections

Apr 18, 2014 | Hyundai Elantra Cars & Trucks

1 Answer

2003 tacoma 2.4 rough idle then cuts off


Sounds like it may be a faulty TCC clutch solenoid. Torque Converter Clutch. The TCC solenoid is located in the transmission valve body located directly under the transmission oil pan.

Mar 06, 2014 | Cars & Trucks

1 Answer

1993 gmc suburban rough idle, stall in reverse


Idle air control (IAC) control rpm idle during idle.

Test it on idle with ALL electrical on full force.
RPM should increase.
If RPM remain the same then IAC is question.

Jan 13, 2014 | 1993 GMC Suburban

1 Answer

92 NISSAN WITH BOGGING AT 2800 3500 RPM AND AT LEVEL SPEED 4CYL AND 5 SPEED


For this types of problem,there are few help inks to troubleshoot the problem.Click the link below to go through the troubleshooting procedure to resolve the issues :----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------van idles rough? http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html
--------------runs lean and idles rough? http://technoanswers.blogspot.in/2012/02/ford-runs-lean-and-idles-rough.html
-----------Car still runs Rough after tune up? http://howtobyme.blogspot.com/2011/12/car-still-runs-rough-after-tune-up.html
------------Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed? http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html
----------High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html
------------Engine Backfires? http://technoanswers.blogspot.in/2012/02/jeep-backfires.html----------- Nissan stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

-----------
Nissan Pathfinder Backfires? http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-backfires.html
---------How to adjust rpm? http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
------------Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html
----------This will help.Thanks.

Feb 17, 2012 | 1992 Nissan Pickup

1 Answer

2004 freestar no reverse /hard staring idle rough and cuts off and back fire


As far as the transmission issue is concerned, it sounds like you may have a clogged filter, and are in need of a fluid, and filter change, but that is best case scenario, worst case is you need some serious transmission work performed. The rough idle, could be due to bad plugs, a faulty MAF-mass air flow-sensor, or TPS-throttle position sensor. I would have a diagnostic ran on the van and see what codes come up.

Mar 20, 2011 | 2005 Ford Freestar

1 Answer

When i press the accellerator the idle fluctuates up and down


Couple of items can cause this:
manual shift valve, transmission range sensor, idle air control or fuel pressure regulator. Only once I had to replace the ECU.
I would scan for codes first and see what you get.

Apr 28, 2010 | 2004 Ford Explorer

Not finding what you are looking for?
1995 Ford Econoline Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...