Question about 1996 Acura TL Series

2 Answers

Windshield wipers don't work right. Try to and quit mid cycle.

Windshield wipers don't work right. Try to and then stop. 1996 Acura 3.2 TL what is wrong?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Acura Master
  • 14,036 Answers

YOUR WIPER MOTOR COULD HAVE BINDING LINKAGE AND PIVOTS.TRY LUBRICATE THEM WITH WD40.TRY NOT TO GET ANY ON WINDSHIELD.IF THIS DONT WORK WIPER MOTOR COULD BE FAULTY.

Posted on Sep 27, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 28 Answers

Change the motor

Posted on Sep 19, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2000 Acura TL wiper arms bang the cowling and pillar. What is wrong


might be someone took the whole arm off to paint em or whatever so while they are in the off position check to make sure they don't need a quick adjustment for example if they are flat/level with the windshield lower seal if they are than you got the wrong size blades if they are off a little than remove clip holding the windshield wiper arm and slide off of the cog and move it a couple teeth till its flat than check your work by turning the wipers on if they aren't perfect than keep adjusting till they are on both sides

Dec 31, 2014 | 2000 Acura TL

1 Answer

Acura tl 2001 wiper hit hard


the wiper control arms bushings are worn out and need replaced..

Feb 09, 2013 | 2004 Audi A4

1 Answer

Where is the location of acura tl 2004 wiper motor?


The wiper motor is located in the left rear of the engine compartment near the corner by the driver side. Remove the wiper arm assembly (both if necessary) and then remove the plastic cover at the edge of the hood near the windshield the motor is underneath. To remove the wiper arm flip up the small cover where the arm is attached and you will find a (12mm usually) nut. Remove the nut and work the arm off of the post using a rocking motion. Hope this helps.

Sep 02, 2011 | 2004 Acura TL

1 Answer

What position do you put the wiper linkage in when you fasten it to the motor shaft?


tTHIS SHOULD BE DON IN >WIPER-PARK POSITION ONLY WIPER-PARK = OFF POSITION

Nov 24, 2010 | 1996 Acura TL Series

2 Answers

1999 Acura TL - WIPER BLADES HIT HARD ON BOTH SIDES, IS THERE AN ADJUSTMENT OR JUST REPLACE THE WIPER MOTOR


I had this same problem. The wiper blades would extend too far and hit the edge of the car, or they wouldn't extend far enough and only wipe about 3/4 of the windshield. The problem was a broken Wiper Rod A. My local mechanic replaced it - the part was about $20 and the labor about $230. Have them look at wiper rod A

Jan 09, 2010 | 1997 Acura TL Series

2 Answers

Windshield motor make noise but the wiper don't move


Remove the wiper blades then remove the cover and you will find that the linkage has come off the motor.Replace the linkage or fit a new one.Hope that was helpfull.

Aug 07, 2009 | 1996 Acura TL Series

1 Answer

1996 Acura 3.2 TL windshield wiper problem


they have what one guy, I know called a small "transmision" that engages both wipers and the speed. On one car the winshield wipers transmission connections were loose. A small bolt came off.
Check all the workings by running the wipers .
Try to get to the wiper motor assembly and take a look at it. You may have to remove some screws.

Dec 23, 2008 | 2000 Acura TL

Not finding what you are looking for?
1996 Acura TL Series Logo

585 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...