Question about 2000 Buick LeSabre

1 Answer

Firing Sequence What is the correct Firing Sequence for a 2000 Buick Lesabre Custom? 3.8L

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 80 Answers

Firing Order
1-6-5-4-3-2

Posted on Sep 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 buick lesabre custom


Depends on what kind of noise and where its coming from.
Could be a problem inside the compressor, or the ac clutch, or something else.
Did you get a warranty with the compressor ?

Jul 06, 2013 | 2000 Buick LeSabre

1 Answer

2000 buick lesabre custom oil in the coolant


You have a blowin head gasket, Verry costly to have repaired, Plan on $2000 end up.

Nov 28, 2012 | 2000 Buick LeSabre

1 Answer

Firing order 1996 buick regal custom


The firing order is 165432 and the sequence is from the front of the car from left to right is cylinder # 1-3-5 and the firewall side from left to right is # 2-4-6

Apr 23, 2012 | Buick Regal Cars & Trucks

1 Answer

I HAVE A HEADLAMP SWITCH TO INSTALL IN MY 2000 BUICK LESABRE CUSTOM. WHERE DO I GET INSTRUCTIONS FOR INSTALLATION?


Hello! Remove the left instrument panel trim plate...Disconnect the connector from the Headlamp Switch...Remove the Headlamp Switch from the trim plate...The instrument panel trim plate is removed by gently prying with the handle of a toe nail clipper if you do not have the correct tool...Guru...Saailer

Sep 19, 2010 | 2000 Buick LeSabre

1 Answer

Which port do I recharge my ac in my 2000 buick


If you have no Refrigerant in the system,you don't put any in. It will just leak out and pollute the atmosphere.
Go to a repair shop that does A/C work and follows correct EPA standards for working on air conditioning.
You can't do that job at home without proper training and equipment.

Jul 29, 2010 | 2000 Buick LeSabre

1 Answer

Ses light on code po102 and po171 2000 buck lesabre


Have 2000 Buick Lesabre custom every time car gets up to operating temp. the engine misses going down the road , also let car sit and idle and it shuts off after about 2 minutes , my code reads PO171 system to lean bank 1, changed co2 censor, mass air flow censor, plug wires, and plugs.

May 15, 2010 | 2000 Buick LeSabre

1 Answer

2000 Buick Lesabre custom liscense plate bulb


kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together

Mar 08, 2010 | 2000 Buick LeSabre

2 Answers

I need a diagram to replace the left rear wheel bearing on a 2000 Buick LeSabre Custom


I'm going to have to replace both front bearings on my 2000 Lesabre as well. Mind firing the diagram off to me as well? Thanks a million.
bridon37@hotmail.com

Feb 10, 2010 | 2000 Buick LeSabre

1 Answer

Diagrahm of firing order for 1994 buick lasabre


The firing order number sequence is stamped on the manifold near the distributor.

6 cylinder: 5-2-6-3-4-1


8 cylinder: 1-8-4-3-6-5-7-2



Sep 21, 2009 | 1994 Buick LeSabre

Not finding what you are looking for?
2000 Buick LeSabre Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...