Question about 2008 Saturn Sky

1 Answer

Door check creaking noise when opening and closing driver door . door check was replaced by dealer, still same problem.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 520 Answers

This can also mean a loose check verify tension of all mounting bolts for the check and lube before electing to get even another door check

Posted on Sep 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Door needs adjustment


if its dropped then open door slightly then place a nice piece of appropiate sized wood block under the flat part and jack the door up till it creaks ,small short creak will be about a mm or so and good grunt noise will be nearer a centimeter .if it is still low then jump up and down on the car body door seal .Yes i know it may sound strange but this is how the big boys do it in the dealers ,where do you think i learnt it ?

Nov 10, 2012 | Cars & Trucks

1 Answer

The driver side door makes a coupe of lloud noises everytime it's opened and closed. The dealer says it the mechanism that keeps the door from flying back in a heavy wind and would cost over $400 to...


The dealer is right, the latch that keep door from opening to far wears and makes a poping noise but 400.00 is a bit much, try the web and see if you can find one cheaper, its not to hard to install, you would just need to remove door panel to replace, good day

Apr 06, 2011 | 2005 Pontiac Vibe

1 Answer

1996 mustang gt makes a reking noise when turning


There are several possible causes to your problem.

Most likely it is a ball joint.
A bad strut mount will make a similar noise. Sometimes dirt/rust in-between the strut spring and the rubber insulators can cause a creak.
If the environment is really dry or the rubber bushings on the car are really old, they can cause a creaking noise.

I would have it checked out because if it is a ball joint, it will eventually cause uneven tire wear and can even separate, resulting in total loss of control of the vehicle.

Jun 04, 2010 | 1996 Ford Mustang

1 Answer

My 1997 Jeep Grand Cheroke's doors close funny. Both of them don't close smoothly. Anyone else have this problem? It's not when the door latches it's during the close, like something is bent but it's on...


Each door has two hinges. The bottom hinge has a lever spring and two rollers attached that prevents the door from swinging freely when it is opened or closed. (one roller for opening and one for closing) If the door seems like its bent, it is probably because the rollers are frozen and when you open/close the door the lever spring is scraping across the raised edges of the rollers instead of riding them. If the door is not moving smoothly, or is making loud creaking noises, give a good dose of WD-40 to the hinges as well as the rollers, especially the rollers. The rollers should roll when the lever spring engages it as you open/close the door.

Dec 20, 2009 | 1997 Jeep Grand Cherokee

2 Answers

When I open the drivers side door the hinge pops


oil hinges.check that door & front fender aren't rubbing.

Sep 23, 2009 | 2002 Saturn SC

3 Answers

I also have a toyta seiana 2005 that makes a noise


The door check on the front of the door tears internally and requires rewelding. This repair has had the warranty extended if I recall c

Models:
'04 - '06 Sienna March 23, 2007
TSB REVISION NOTICE :
^ November 28, 2007: The note below the Warranty Information table has been updated. ^ July 6, 2007: The Warranty Information table has been updated with separate "Combo A" Op Codes. ^ May 29, 2007: The Warranty Information has been updated. The note before step 1 of the Repair Procedure has been updated. Previous versions of this TSB should be discarded.
Introduction
Some customers may experience a popping noise when opening and/or closing the front doors on their vehicle. Use the following procedure to diagnose and correct the condition.

Warranty application is limited to correction of a problem based upon a customer's specific complaint. Repair Procedure
NOTE :Inspect the door frame around the door check mounting area. ^ If a spot weld or check mount area is cracked or split, the following repair method CANNOT be performed and the door assembly MUST be replaced. ^ If a door is to be replaced, all hemming flanges and body panel seams MUST be sealed with body seam sealer prior to painting the door assembly. Refer to the Technical Information System (TIS), CRIB (Collision Repair Information Bulletin), "Bulletin # 16:1987 All: Sealing of Hemming Flanges And Body And Panel Seams," and "Bulletin # 44:1991 All: Body Seam And Joint Sealer Application ". (Note that the CRIBs are located within the CR tab of the main TIS screen.) ^ If a spot weld has separated, have a body shop perform the following procedure.

9bb8415.gif

Sep 14, 2009 | 2006 Toyota Sienna

1 Answer

Passenger Door "Pops"


Sounds like the detent rollers on the door hinge are dry and need some grease (if the door has proper clearance on the front fender...check this first) spray some white lithium grease spray on the hinges and related moving parts on the door hinges upper and lower and the plastic guide that goes in the door... Let me know how it goes.
KEN

May 08, 2009 | 2006 Ford Explorer

1 Answer

2008 BMW 750LI


sounds like a faulty impact sensor designed to unlock the door in an impact, in the door telling everything else its open but isnt

Aug 02, 2008 | 2006 BMW 750Li

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...