Question about 1993 Dodge Dynasty

1 Answer

Fuel filter lines

How do you unhook the fuel lines from the fuel filter on the 93 dodge dynasty ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 6,674 Answers

If it has the little shoulder style, push in toward fitting on that sleeve, then twist & pull line apart. Warning!!, make sure fuel pressure has been released/relieved before.

Posted on Sep 27, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

93 dodge van dies,but runs if i unhook vacuum lines what would cause this.also shouldn't it die when I undo the fule pressure regulator

Have you checked your air filter ? It may be dirty or some section of your air intake tubes clogged. This may be why it run when you disconnect a vacuum line.

As for your fuel pressure regulator matter, as long as there is fuel going to the rail and injectors, it may continue to run.

If you can add more detail information of your problem and what have you done in the form of diagnosis, it would help.

Dec 18, 2016 | Dodge Cars & Trucks

1 Answer

Dodge dynasty will turn over but will not start

check the injectors relay most problems are down to this..... injectors dont go at the same time. also check that the line has pressure there is a vale on the injectors lines for the fuel there is a valve check this has pressure dont do this with the engine running or ignition on as fuel will come out. if no pressure check the regulator & fuel pump relay.

Dec 06, 2013 | 1989 Dodge Dynasty

1 Answer

1990 dodge Dynasty bad gas mileage and now cutting out real bad. Changed spark plug wires, spark plugs and fuel filter. Ran good for a test run right after installing items. This morning ran fine the 5...

May just be some dirty fuel, or clogged dirty air filter...try putting 2 bottles of fuel injector/carb cleaner in the tank to be sure dirty fuel has been treated. Did your Dynasty sit for a period of time? (Not driven or run for several months, or did you let the fuel tank get very low? Same remedy. Hope this helps..

May 23, 2012 | 1990 Dodge Dynasty

1 Answer

How do i get the fuel filter off, the line coming in comes off no problem but the line going out wont come off

You probably are going to need a fuel line disconnect tool. They are very inexpensive at a parts store. Tell them what you need and they should be able to show you how to use it.

Mar 23, 2011 | 1992 Dodge Dynasty

1 Answer

How do i relive the fuel pressure on the line to replace the fuel filter

There is usually a schrader valve in the fuel rail with a plastic cap on it.

Jan 03, 2011 | 1991 Dodge Dynasty

1 Answer

I believe it is the fuel pump because when I prime it with raw fuel it goes. Then when the fuel is used it wont start. The car has been sitting for quite a while[1yr.] Seems it must be the fuel pump,...

try a new fuel filter first, the pump may be in the fuel tank but I am not sure as I am not familiar with that car.
The fuel filter may be under the car more towards the rear near the rear passengers foot well

Sep 27, 2010 | 1990 Dodge Dynasty

1 Answer

How to disconecct the fuel filter

that fuel filter should have the "tool" built in. its that plastic thing that sticks out from the fuel line. push fuel line in towards filter and hold it there. then what i use is i pair of 30 degrre bent nose needle nose pliars to push the plastic thing back towards fuel line when its shoved in equally and almost all the way in pull the fuel line away from the filter. they are kinda tough sometimes and the line can get damaged. thats why chrysler offers a fuel line repair kit. and they are inexpensive.

Apr 24, 2010 | 1993 Chrysler New Yorker

2 Answers

How to uninstall fuel filter for 1993 3.3l V6 Dodge Dynasty


Feb 23, 2009 | 1993 Dodge Dynasty

Not finding what you are looking for?
1993 Dodge Dynasty Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides