Replace the side mirror cover on 2001 Lexus IS 300

2001 Lexus RX 300 - Openbay

https://www.openbay.com/intake-manifold.../2001-lexus-rx-300/chicago...
2001 lexus rx 300 4dr suv base fq oem 1 500 ... rely on very precise measurements of air to properly mix in fuel, so these leaks lead to poor engine performance.

Lexus RX300 Valve cover gasket replacement - YouTube

? 11:21
www.youtube.com/watch?v=brV5MEgzfHs
Feb 17, 2014 - Uploaded by Stevie Kicks
Lexus RX300 engine repair. ... Nice video Stevie. I was watching it to see if I could spot the bank 1 sensor 1 air/fuel sensor. I have to replace ...

You need to drop the sub frame and support motor from above using a brace or bracket from side to side.

you have to disconnect the window regulator motor connector and apply 12v at connector. using a jumper wire connect to the motor side connector one to the negative cable and the other to positive connector.

Something is being over looked. Diagnostics have to be performed to find out if this is related or a coincidence. I would first look, inspect and verify that the main accessory fuses are receiving 12 volts and are still properly grounded. What do you have for test equipment? Do you own a Power Probe, test light or multimeter? Please write back and let me know what tests you have run and what you have found so far. Most of these circuits are wired so they receive power when the key is in the ACC or RUN position and are activated from the Ground side.

it would be in the interior fuse box some where near the drivers feet or door. there is a key on the cover that should say mirrors

Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.

Your local jun kyard may be of help...maybe
Good Luck

Unscrew 3 - 4 screws on the front tire fendor cover close to your side marker light. Pull the fender cover out, use your other hand to reach the side marker light. Using twist and pull the light set out. Replace a new light bulb. Replace everything in a reverse order.

it is a heated mirror. usually comes on with defroster setting

Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.