Question about 1991 Jeep Wrangler

1 Answer

Does not start or crank lights work starter and silnoid is good battery good radio does not work dash lights work no power to small inside underdash lights clock is good however does not work

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Try replacing the crankshaft position sensor

Posted on Sep 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starter not turning over only dash lights w


Probably a dead battery, if the battery and wiring was Good, all the lights and radio etc... would work, the dash lights only require a small amount of power. ...

Feb 20, 2015 | Cars & Trucks

2 Answers

2005 lincoln aviator dash wont work and no crank on the engine


Sounds like an electrical problem.Start with the battery, then check your selonid and starter.

Apr 02, 2014 | 2005 Lincoln Aviator

2 Answers

Disconnected battery in 2007 gmc Yukon. Dash lights and radio work. Engine won't crank. Remote won't work. How to reset?????


kindly pls check the BCM which is located under the left side of the dashboared i hope that will help.

Mar 30, 2013 | 2007 GMC Yukon

1 Answer

When I try to start my 95 Toyota Previa, it seems to have full battery power (dash lights, radio plays) until I get to the start position. There is one click and every thing goes dead. If I unhook the...


Have your battery tested to start the fact that the radio and lights work are not an indicator that the battery is good. if in fact battery is good and you hear a click and nothing else then make sure you got power at starter from ignition switch and power going to the actual starter motor while some one holds the key in the crank position. Do this safely. the starter should have power on the B+ terminalwhich comes directly from the battery. It also gets power when in the crank position to engage the solenoid in the Igniton terminal when engaged the power from B+ is tranfer to the the starter motor which in turn turns the engine if this isnt happening for you replace the starter

Sep 27, 2012 | 1995 Toyota Previa

1 Answer

My 2008 mazda 6 intermittenly won't crank, power window work and radio works, after it sits awhile it starts...is there any type of diagnostic to perform on this type of issue


first thing to do is get the car not to crank and check for power to the starter. if the starter has battery power and signal from the ignition switch then the problem is the starter. second thing is to check the plug at the trans range switch. the connector may be loose since you just had the trans repaired. ground may be an issue but not likely since the dash lights and other things work. GOOD LUCK.

Jun 06, 2012 | 2008 Mazda 6 2.0

1 Answer

Won't start turn ignition on does not crank gauges work battery is good already cleaned battery post and checked all fuses the voltage gauge in dash shows to be a little weak and the heater blower is not...


the best bet is to go to the started and check to see the signal wire is getting current when you try to crank it, if not you locate the signal wire on the starter which is the small wire and jump it with power, if it is not doing anything then your starter is bad. if it turns then your problem is somewhere else.

Feb 26, 2011 | 2000 GMC Sierra

1 Answer

When I Try to start the Car, I have power but the car will not even crank..it just sits silent...i have the radio...dash lights come on...but the engine just does nothing. i had no warning lights...nothing...


The most common problem here would be a bad starter, you can test it with a test light,have someone hold the key in the crank postion while you test foor power at the starter, there are two wires to starter one is a battery cable which should have power going to it at all times then a small wire that has power when key is in the crank postion to spin starter, if it has power then starter is bad, if theres no power then you may have a bad ignition switch or bad neutral safty switch, also try starting in neutral. hope this helps. another trick is while holding key in crank postion tap starter with hammer if it starts then starter is bad,

Sep 13, 2010 | 2004 Pontiac Grand Am

1 Answer

96 Stratus, has some power, but won't start. How do I know if this is the starter, a loose connection, or something else? Dash lights and headlights works, but nothing else. It doesn't make a peep when I...


test battery first ,make sure it good,if battery is good then check for power at starter, two wires one has power all the time from batt, now have someone strat hold key in crank position and test for power at small wire, if you have power then starter is no good replace it, hope this helps.

Oct 10, 2009 | 1996 Dodge Stratus

3 Answers

Car would not start and made a clicking noise. I


It sounds l; like the starter solenoid has gone bad or the wire to the solenoid has gone bad. Check the wire harness to the starter and solenoid on the starter. If the wire is good, then it's the solenoid that needs to be replaced. If you remove the starter, Auto Zone can test it for you and should have the solenoid for the starter alone or it you like you can replace the whole unit. Starter and solenoid together. Good luck and hope this helps.

Jun 15, 2009 | 2006 Hyundai Elantra

Not finding what you are looking for?
1991 Jeep Wrangler Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...