Question about 2008 Chevrolet Trailblazer

1 Answer

Nicked steering wheel

I got in to my car and caught my suspender's clip on steering wheel. It took a small chunk out of it. Repair or replace?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 51 Answers

Cant repair it unless you pull the steering wheel and give it to an upholsterer. Other than that,replace it. It will be cheaper to have reupholstered though.

Posted on Sep 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to repair my black steering wheel.


look up por 15 they have a kit to repair steering wheels

Jun 13, 2014 | 2005 Ford F-150 SuperCab

1 Answer

I have a 2006 chevy cobalt , i need to no how the center of the steering wheel comes off ! does it just pull off .


the air bag is held in with spring clips disconnect the battery and pull the air bag fuse before the bag blows off in you face then look on the sides of the wheel for a small hole if it has that style push a center punch into the hole and pull up on each side if no holes on the side there is slots on the back side with a small screw driver push the tabs off to the side to release

Jun 11, 2012 | 2006 Chevrolet Cobalt

2 Answers

97 nissan pathfinder how do i take the air bag


Is this the steering wheel air bag? Pretty sure the center just clips in and the air bag just comes out. PLEASE PLEASE disconnect the battery before you start. Check behind the steering wheel some have small bolts holding the cover on.

Jul 22, 2010 | 1997 Nissan Pathfinder

1 Answer

How to take apart four wheel drive front end on a ford f250 2006.


jack and block up pull wheels then tack the cover off the front end
theres a little pin in the middle with a bolt holding it in tack it out slide the pin out (thebolt is real small 5/16s) then pull the hubs off and tack the half moon keys out push in the axles then tack the half C-clips out in side the chunk then slide the axles out then remove the 4 big bolts and the chunk will come out any ? you can call 863 763 4709 or 863 261 6116 ask for Dalton

Feb 13, 2010 | 2006 Ford F-250 Super Duty

1 Answer

I have a right hand drive 95 Cherokee, where is the horn relay located?


The horn relay is located under the hood within the power control box. However, I should make clear that Jeep has a characteristic problem in that the small pigtail wire under the steering wheel comes loose and pops out. To repair this remove the steering wheel with a puller kit. Then remove the locking plate with a special puller for this also.Now you can see the pigtail wire, it was connected to the horn button when you started. Look at the base and you'll see a spring and clip assembly.If you can manuver the clip into place it will be fine. If the little tab that holds the clip in place is broken, than you'll have to superglue it back into place. Use a lond pair of needlenose pliers to do this. Replace the lockplate and steering wheel(making sure that the index mark is lined up perfectly. That's it. Thank you ,Dana

Sep 30, 2009 | 1995 Jeep Cherokee

1 Answer

Headlights not working even after bulbs and fuses replaced


Replace your headlight switch. You need torx bits, a steering wheel puller, and bolts to perform the repair.

Disconnect your negative battery cable and wait at least 1 minute before going any further (this insures your airbags are disabled if your vehicle has them).

Remove the plastic covers that cover the steering colum. If applicable, remove the airbag from the steering wheel; if you don't have a airbag pull the horn switch from the center of the steering wheel. Remove the retaining clip from the center shaft in the steering colum. Remove the bolt that holds the steering wheel, then use a steering wheel puller to remove the steering wheel. Remove the torx screws from the headlight switch, and remove the electrical connectors. Install in reverse.

I hope this information helps you, and I wish you luck on your repair.

Apr 25, 2009 | 1996 Chevrolet Cavalier

1 Answer

Need to replace ignition switch


well,after the wheel there is a disk with notches in it that comes off and has a c clip holding it there,there is a spring behind it then take off the turn signal switch,then there is a small bolt or screw to take off where the switch is(still behind the steering wheel)put your key to accessories then pull the switch out,if you have no key,then you have to either break the switch or get a locksmith to do it,ive done it in my chevys and its not really fun without a key

Apr 22, 2009 | Chevrolet Camaro Cars & Trucks

1 Answer

Remove steering wheel


First there are 2 screws behind the steering wheel they are hex or phillips
take them out and it come s out then you need a socket to remove the nut and a puller to take the wheel off. Once you are to that point it is very complicated.
from hear on out. it took over 4hrs to remove mine down to the titlwheel section.
there is a spring behind the metal plate that you see and you have to press down
on that metal plate to get the c clip off with a special tool that you have to get
it presses down on that plate to release the spring , which take pressure of to get
at the c clip there are lots of srews and small parts inside be careful not to lose them!!!!

Jun 13, 2008 | 1989 Oldsmobile Ninety Eight

2 Answers

2000 jetta need to remove steering wheel


This is not an easy procedure, especially since you've never done it before. With the wheels in the straight ahead position, look at the back of the steering wheel, you'll see two holes. One at 9 o'clock and one at 3 o'clock. You stick a small flat blade screwdriver in the first hole and you pry on the retaining spring while gently pulling on the airbag until it releases. Repeat on the other side. I'm a professional mechanic and the first time I did it, it took me over a half hour to figure it out. Now I can do it in less than a minute. Might want to take it to the dealer.

May 20, 2008 | 2000 Volkswagen Jetta TDI

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...