Question about Jeep Liberty

1 Answer

2002 Jeep Liberty service engine light stays on; and abs and brake lights stay on. Replaced cracked hose to fuel tank vent underneath in the back between tank and differential. Still stays on code says something about loose gas cap; replaced cap and still stays on. ABS lights came on shortly after removing boat from water and the speedometer does not work either. Perhaps rear sensor is shot? How are they removed? Is there a screw; or do they just thread into the to of pumpkin?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 83 Answers

Grab a service manual from here Promanuals

Posted on Sep 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

So I have a 2002 jeep liberty it bogs at 2500 rpms when gas tank is full and when its empty it drives good what is the issue? I can't figure this out.


Did you try loosening the gas cap? If it behaves differently, never mind the engine light for the moment, but does the performance improve any? If so, replace the gas cap or make certain it is tight after fueling. Let us know if this helps or fixes the issue.

Nov 23, 2014 | 2002 Jeep Liberty

2 Answers

Brake light and atl light stays on


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System

Nov 02, 2012 | 2002 Jeep Liberty

1 Answer

Is the starter seperate from sylanode


2002 liberty what causes engine light to stay on,at first it wouldnt crank.When it did start,engine light stayed on.

Sep 05, 2012 | 2002 Jeep Liberty

1 Answer

Engine light stays on code # P0456


P0456 is Evaporative Emissions System - Small leak detected.

More often than not it is a gas cap that is either not put on corrert or it has failed to hold the seal.
Less likely causes are:
  • A small leak in any of the EVAP hoses or fuel tank hoses
  • A small leak in the purge valve or vent valve
  • The EVAP Canister may be leaking

Aug 02, 2011 | 2002 Jeep Grand Cherokee

2 Answers

Abs light stays on in a 2005 jeep liberty


check brake fluid level ,worn pads, this can cause light to come on disconnect negative battery cable whait 2min and reconnect battery this will reset abs controller.

Aug 17, 2010 | 2005 Jeep Liberty

3 Answers

2005 Jeep Liberty 3.7L engine light stays on. Gas cap is tight.


U need to pull the fault code go to NAPA they do that for free. I will help you from there on.

Oct 25, 2009 | 2005 Jeep Liberty

1 Answer

Dashboard lights on 2002 Jeep Liberty Sport


Donna,

You can go to Auto Zone . They can scan the car for codes for free, and check the Alternator. I think with all the issue with the dash lights coming on, The codes should get a tech in the right direction. You could be right and the Alternator is the root cause of failure.

Good Luck

Aug 16, 2009 | 2002 Jeep Liberty

1 Answer

2002 GJCL, ABS light came on today and stays on. Alsp smell gas.


If the ABS lights stays on it means the computer has detected a problem in the anti lock brake system and has shut it off until it is repaired. You still have your regular brakes, just not the ABS parts. Could the smell be exhaust gas?

Feb 02, 2009 | 2002 Jeep Grand Cherokee

4 Answers

2002 jeep liberty


I found that the hoses for the Evap. system near the gas tank had split on the ends and was causing a leak.

May 31, 2008 | 2002 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

563 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...