Question about 1999 Plymouth Voyager

Open Question

I have a 1999 Plmounth Grand Vovager SE.I've had problem's with the transmission output Sensor.I've replaced it 3 times.There is a fuse that burns out when it shuts down also it is the EATX fuse.I've just replaced it again but the transmision is still not shifting out of first then it dies on me.Can some1 please guide me to what this might be?

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Jeep 1993 grand problems HI am KC from Iraq Am withe jeep from along time but now its different my jeep is not starting fuses ben check new wiring fuel good but still and i found that if i disconect the...

crankshaft position sensor! located on top of transmission bell housing.replace it .if your problem persist your gonna have to remove transmission and replace the fly wheel flex plate they are bad to crack and cause erratic crank position signal. this is usually accompanied by a sound resembling a pebble in the tailpipe type rattle. good luck and happy motoring __O^-o

Dec 22, 2013 | Cars & Trucks

1 Answer

My engine keeps sputtering. I have a 2005 pontiac grand am 3.4 liter V6. I've replaced the spark plugs due to a misfire, I've replaced the cranshaft sensor, I checked the timing on the timing

fuel pump could be going bad check fuel pressure that will make it sputter,if that not the case check fuel filter.
do a compression test on cylnders

Mar 01, 2013 | 2001 Pontiac Grand Am SE

1 Answer

My Automatic grand cherokee limited 4.7litres (1999 Model) runs on only one gear without changing on diagnosing the error code P0731 ( gear 1 incorrect ratio) was reported

If you have a scan tool capable of looking at input and output speed sensor data for the transmission that is the first thing I would look at. If you don't than it wouldn't hurt to try a new input speed sensor. They are available from your local NAPA. The speed sensors are located on the drivers side of the transmission. They are a light yellowish white color. it will have a black connector with two wires. The one towards the front is the input speed sensor the one to the rear is the output speed sensor. you will need a 1"socket to remove it.

If replacing the sensor doesn't fix it you will need to bring it in and have it looked at.

The speed sensors are pretty common failures on Chrysler transmissions.

Jan 20, 2011 | 1999 Jeep Grand Cherokee

2 Answers

Why doesnt my transmission make shifts speedomiter

First check the 10 amp fuse #1.

If fuse is good, speed sensor has failed or is disconnected. Check connection. If connection is good, replace sensor.

Sensor is mounted on transaxle output. It should have a 3-wire connector on it with one yellow, one orange, and one black wire, as shown in diagram below.

Please let me know if you have questions.


Oct 06, 2010 | 1992 Honda Accord

1 Answer

1999 plymouth grand voyager se transmission shifts into 2nd imediatly and stays there, speedometer and odometer not working. overhead console comes on but not working

probably has a bad input or output speed sensor gone bad.they have a known 100% fail rate.check codes first if there is a bunch of them and one is input or output speed sensor then thats whats wrong, replace both they are only 20 bucks each and just screw in

Mar 22, 2010 | 1996 Plymouth Grand Voyager

1 Answer

Back up lights are always on, 1999 dodge grand caravan

Here is some info.

Apr 24, 2017 | 1999 Dodge Caravan

Not finding what you are looking for?
1999 Plymouth Voyager Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides