Question about 1997 Jaguar XK8

Open Question

Heater blowing cold on my 3.2 sport but cannot find a bleeder can anyone help

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 45 Answers

SOURCE: 1997 audi A4 heater blowing cold air

You will have to change the heater core. 9 out of 10 times, when the heater is not heating the air, it is a bad heater core.

Posted on Nov 13, 2008

alicantecoli
  • 22156 Answers

SOURCE: Ford Expedition 2002 Front Heater blows cold air below 45 MPH

impeller is made of plastic on teh water pump and its slipping and spinning on the shaft renew before weather warms up as engine will overheat

Posted on Jan 01, 2009

  • 651 Answers

SOURCE: heater blowing cold air

squeeze the hoses to get any air bubbles out and refill coolant as necesary. are you sure you put thermostat in the right way? may be backwards. also may be your sensor.

Posted on Jan 04, 2009

  • 1 Answer

SOURCE: 1999 dodge stratus heater blows intermittent hot and cold

HI its almost certainly a thermostat problem, Change the stat and refill slowly with the engine running to eliminate air locks in the system. Hope this helps

Posted on Apr 19, 2009

  • 6982 Answers

SOURCE: 98 XJ cherokee sport 4.0 a/c blows hot air not

check that the heater control valve on the heater hoses is working, also check that blend door inside heater box and blend door vacuum motor are working. Likely the problem is with the door or motor, but unfortunately, the entire heater box needs to be removed to get to them on most vehicles.

Posted on Jul 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the cooling system (vent/bleeder) on a 1996 ford explorer?


sorry no bleeder . but if the hose is warm to and from I'd guessing the heater core is plugged. those hoses should be semi hot. and noone would hold on to them but a second or two

Jan 15, 2015 | 1996 Ford Explorer

1 Answer

Toyota Corrolla 1995. The heater does not work, I replaced the thermostat and have put a lot of antifreeze.


bleed cooling system, probably there is air trapped in the heater core preventing warm coolant to circulate into the heater core. try this
1 open radiator cap fill coolant and put heater in hi heat
2 start engine and wait until you see the coolant start to circulate
3 squeeze hose several times watching if coolant volume decrease
4 add more coolant and repeat 3 until coolant volume stays same or start overflowing.
5 check if heater giving off warm air or repeat 3 and 4 until warm air blows on heater.
--------------------------------------------------------------------
or find the coolant bleeder screw, do 1 and 2
open bleeder screw until coolant come out, do this several times until no air comes out when opening bleeder screw, fill coolant in radiator.

Dec 11, 2013 | Cars & Trucks

1 Answer

2000 dodge grand caravan sport 3.3L flexonly blows cold air


You say you can hear the climate control work, but the blend door for the heater may not be moving. If both heater hoses are hot, I would suspect the blend door.

Dec 10, 2012 | Cars & Trucks

1 Answer

Heater blows cold air


t stat stuck or posibley air in the motor needs blead out there is bleeders on the motor in 2 or 3 spots good luk

Nov 28, 2010 | 2000 Buick Century

2 Answers

It keeps over heating after putting on a new water pump and thero and there no holes in the hose


check for water locks by draining and catching water from bottom pipe.then refill leaving top pipe off bottom on then check the difference in the amount of water lost to refill if u get me!

Jun 11, 2010 | 1997 Pontiac Trans Sport

2 Answers

There's no heat coming out of the vent, just cold air. What is the possible solution to this problem


possible low anti freeze, air bound heater core, defective heat blend door control servo. Start with coolant level, if o.k. check hoses feeding heater core. If the lines are both hot suspect blend door servo/control unit. If only one hose hot suspect clogged/air bound core. Special bleed procedure for engine. With engine running, check for bleeder scews at upper hose mounting, open bleeder and watch for steady stream of coolant. Be careful as coolant is hot. If this does not help, disconnect hoses frm heater core when cool and blow out core with compressed air to unclog system. I hope this helps.

Dec 25, 2009 | 2002 Acura 3.2TL

1 Answer

Find location for lh electric acuator for 1995 buick regal grand sport. heater blows out hot air on the passenger side and cold air on the drivers side and cold air thru the defrost


its located on heater box, there are 3, what you do is watch each one as you move selector to vent ,deforost, hot cold etc, watch to see which one is no moving.should be on drivers side. hope this helps.

Oct 10, 2009 | 1995 Buick Regal

1 Answer

1999 dodge stratus heater blows intermittent hot and cold


HI its almost certainly a thermostat problem, Change the stat and refill slowly with the engine running to eliminate air locks in the system. Hope this helps

Apr 19, 2009 | 2002 Dodge Stratus

1 Answer

Heater problems


Did you bleed the air oout of the cooling system - Their is a bleeding next to the therostat housing.


1 - When the vehicle is cold remove the rad(tank) cap and top up the level if needed

2 - start the vehicle with the rad cap off and leave the car run until you can see that the therostat has openned(look in tank/rad) to see fuild flow then open the bleeder slowly to let any air out of the cooling system. Once you have coolant flowing out of the bleeder close the bleeder and install the rad/tank cap.

NOTE - Be careful with the engine running and hot Coolant.

You make need to bleeding system 2-3 time to get all the all out. Once all the air is out of the system you problem should be solved. If air returns to the coolant system have the system checked for possible head gasket leaking air into the coolant system

Nov 19, 2008 | 1997 Dodge Intrepid

Not finding what you are looking for?
1997 Jaguar XK8 Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...