Question about 2002 Honda Accord

3 Answers

My 2002 honda has a transmission problem went to autozone to check on there computer it came up with p1750 code thought it was low fluid but i added fluid and it did not help the check eng light is still on and now the green light around the Drive is blinking and it won't change gears.

Posted by on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 713 Answers

If I am not mistaken isn't that a shift solenoid code. If it is a shift solenoid code you will need to service the tranny and have it replaced. You can also check and see it there are any service bulletins or recalls on the tranny system through your local dealer.

Posted on Sep 26, 2009

Testimonial: "i have another ques. about the shift solenoid is it possible that u can do it yourself and how do u go about doing it if so."

  • william moody Sep 27, 2009

    Well on most Honda's the shift solenoid is mounted on the outside of the transmission. All you have to do is locate the correct Pack on the tranny because there are two of them. Remove the bolt holding the pack in place and unplug it.put new pack in place. Should fix your problem.

×

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Dear Williammoody,

I saw your advice to terry69jam on Sep 26, 2009.

I have the same error code p1750 which shows up as "Mechanical Problem in Hydraulic Control System of A/T Clutch Pressure Control Solenoid." Your initial recommendation to terry69jam is replacing a tranny. Was your later suggestion on replacement of the shift solenoid can be made in lieu of replacing a tranny? Does "pack" mean the shift solenoid? If yes, where can I find a replacement and how much would that cost?

Posted on Aug 19, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had a similar problem, it shifted weird, then the ATC system went on by itself and only reset after shutting off the car. I added lucas extender, then lucas fix transmission, and they did help, it shifts better and I have 101000 miles on it. the dealer wanted 3800 to replace with new trans. I couldn't afford that, so I chose to try lucas and have been happy. lucas fix trans is VERY thick, so drain more than you have to, mix trans fix with regular trans fluid then be patient while pouring it in. it is no guarantee, but it should help unless you have electrical issues. good luck

Posted on Jan 04, 2011

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 116 Answers

SOURCE: 2000 Accordlx eng. light on and drive blinks yellow code p0780?

po780 is a trans hydrolic systen code
could be a shift solinoid gone bad
have an experienced mechanic replace the lock-up controlle solenoid control solenoid valve/shift controlle solenoid valve "A" assembley
and the A\T clutch pressure control solenoid valve "A"/"B" assembley
start with these two parts farily inexpensive if this doesnt solve the problem then the trans needs to be replaced really expensive
both of these parts are located on the out side of the trans
rank my solution

Posted on Dec 15, 2008

dr_greg
  • 192 Answers

SOURCE: Drive D light is blinking.

u need to have the codes retrieved and take it from there, there are specific codes that need to be troubleshooted in order to diagnose it correctly...

Posted on Apr 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Mitsubishi Montero sport 1998 code p1750 need picture of location


Picture of location for what ?
First thing to do with any transmission codes is check the fluid and clear the codes after recording them then redo a test drive cycle

A P1750 can be anything from a wiring short or a bad TCM

It could be the converter clutch solenoid, shift control solenoid, pressure control solenoid or engine control module has failed.

If the code comes back then you will have to check the wiring harness to the transmission and test the solenoid pack and see if they are malfunctioning ! Your best bet , take it to a qualified repair shop .

Dec 29, 2016 | 1998 Mitsubishi Montero Sport

1 Answer

P1750 honda pilot


code p1750 refers to AT-hydraulic system mechanical malfunction====causes --wiring---shift solenoids--ECM---transmission mechanical fault. Have a pressure test done to determine if there is a mechanical failure in the transmission.

Jun 10, 2014 | Mitsubishi Galant Cars & Trucks

1 Answer

Shuts off when put in drive 02 accord ex 4Cyl


I have seen this be caused by a clogged up internal filter. Low pressure upstream of the filter won't let the transmission engage. Unfortunately you have to open up the trans to fix and replace it. It might be time to just get it in for an overhaul when that happens. Hope this helps

Apr 24, 2014 | Honda Accord Cars & Trucks

1 Answer

2003 Grand Cherokee laredo with p1762 trouble code. Found that transmission fuild was down over 2 qts. Added fuild, then reset the code. Code went away. Should I still have mechanic check this?


hi
you have sorted the problem, the fault code that you had is caused by low transmission fluid. BUT.....
you still have to check the transmission for leak, to find out why the fluid went down that much
Good luck

Feb 16, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

P1750 code


P1750 Electronic gear selector module. Low control unit supply voltage too low.


Clear this fault first, as gear position sensor is not saying transmission is in P or N in order for engine to start. Check voltage at battery. Should be 12.65 if fully charged.

Low voltage causes false codes too and if too many set they will need clearing. Spilling tea coffee or soda down the shift gate can cause similar problems. Also the wiring to the transmission can become oil soaked and not pass full voltage to shift module at the connector.
It is also possible this code has nothing to do with a no start and you have another componet failure. .

Oct 09, 2013 | Mercedes-Benz Cars & Trucks

1 Answer

Transmission selonoid assambly


Diagnostic Test Code (DTC) P1750 is a "generic" OBD fault code that is output by your engine control computer to let you know that the transmission control computer is reporting a problem with one of the transmission control solenoids. To find out the nature of the problem and which of the solenoids has the failure, you must access your transmission control module and retrieve the fault codes from there.

The transmission control computer outputs 2-digit codes that are not accessible by a generic OBD code reader.

Jan 20, 2012 | 1998 Mitsubishi Montero Sport

1 Answer

2 weeks ago i had oil changed. The next day, MIL came on. I added some fuel and later that same afternoon, MIL went off. Two days ago, MIL back on. Added transmission fluid, MIL went off. Yesterday, guess...


Check engine light has to be scanned to see what is causing it. The problem causing it is probably stored in the car's computer. Get it scanned at autozone or a similar place, they usually do this for free. Not likely a CEL would be thrown for fluids being low.

Jul 23, 2011 | Hyundai Tucson Cars & Trucks

1 Answer

2004 Honda civic hybrid the transmission acts like it is nuetral


Black is not good for fluid color. The transmission has been neglected or abused. Sometimes changing the fluid at this stage will create new problems with dirt/gunk being cut loose by the clean fluid. I guess you can try it to see what happens ... then get an estimate for repair.

Apr 20, 2010 | 2005 Honda Civic

1 Answer

Car was low on transmition fluid,added it and still wont reverse


take it to a transmission shop. you need another transmission

Feb 01, 2009 | 1989 Honda Civic

Not finding what you are looking for?
2002 Honda Accord Logo

1,632 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...