Question about 2002 Jeep Liberty

Open Question

Vehicle stall, jerking, put on brake and dies

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stalls, won't accelerate, brakes quit


Do not blame you for being worried to drive, this is a very dangerous position to be in. Do you have the error codes written down, are there presently any error codes. this info is needed to diagnose problem. RE POST IF YOU CAN SUPPLY MORE INFO< ALONG WITH YOUR QUESTION
below is a link to trouble shoot your issue,
press the helpful button

Diagnosing Intermittent Stalling Issues

Jan 28, 2016 | 2005 Hyundai XG350 L

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

1 Answer

My 2008 dodge avenger jerks when i come to a stop any idea what it could be.?


Jerks coming to a stop as in engine jerks, or does it seem like the brakes are jerking. When you leave off the pedal does it stop jerking? If it does it is probably warped rotors. A lot of new cars have this problem, my theory is that the brake pads they are using are way too hard. They put way too much heat into the rotor and warp it. Of course the rotors are none too heavy either. I think it is all in an effort to reduce weight in the vehicle.

Jan 03, 2012 | 2008 Dodge Avenger

2 Answers

My engnine stalls and wants to die when i apply the brakes or when i am stopped for a period of time with the brakes applied.


Your brake booster may have a torn diaphram. Can you hear air leaking under the dash with the brakes applied? Let me know if this isn't it or you have more questions.

Oct 31, 2010 | 2002 Mercury Mountaineer

1 Answer

Toyota carina injection 1993 2000cc auto cuts out as soon as I


Does the vehicle restart and die when you put it in gear. If answer is yes then you need a torque converter clutch solenoid (TCC) or a brake light switch. The brake light switch cancels the TCC at a slow down or stop.. If it doesn't cancel it you will stall out. If your vehicle restarts and dies once you put it in gear then its the TCC. If none of these symptons fit your vehicle get back to me .

Apr 18, 2010 | 1991 Toyota Camry

1 Answer

At a stop car jerks forward with brakes applied


Are the engine rpms climbing when its jerking forward? seems like it could be a Transmission torque converter problem.

Apr 04, 2010 | 2004 Dodge Neon

1 Answer

The gear shift on my 1998 Lincoln Navigator is difficult to move out of park. It started about a month ago, when I tried to back out of my parking spot at home. Tonight, the vehicle died on me at a stop...


It can be either the shift cable or the Automatic parking brake release.
With your vehicle stalling it sounds like the parking brake release is leaking vacuum and causing stalling.

You can check with Autozone or Oreillys to see if there is an aftermarket part for that. Then locate the Auot release on your vehicle and when you take it off, slide the parts within the fixture to verify sticking.

Oct 12, 2009 | 2004 Lincoln Navigator

1 Answer

95 cherokee sport stalling


Since the car stall only in the drive position, it sounds(i'm not there to actually ck the car)like when the engine torques, it might be pulling on a harness somewhere and killing the ignition. Do this,start the car and under the hood while the engine is running, move or jiggle the harnesses around and see if the car stalls. If the car stalls try to pinpoint the location on the harness and look for frayed or broken wires.

Sep 03, 2009 | 1995 Jeep Cherokee 2 Door

2 Answers

Transmission shifts hard, makes a grinding noise, and stalls


Put in gear and stalls,,, The lock up torque converter is staying engaged. take it to auto zone and have them disconnect the plug for the torque. You will no longer have over-drive until you change the sensor,but will get you by for the time being.
Hard shift / shudder, check fluid level and colour, if full and red in colour have the trans flushed and replace trans filter.
If dark coloured you can try the flush, but to save you money, have auto zone install another transmission.

Jul 23, 2009 | 2001 Oldsmobile Intrigue

Not finding what you are looking for?
2002 Jeep Liberty Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...