How to get my power window up manually on 2000 Subaru Outback

May have a weak or broken motor mount along with a bad ground showing up as the engine torques and lifts up losing ground and causing the issue of flickering lights .

WE know the motor is working fine, so it must be the switch or in the electrical circuit. Good Luck

need a window mecanisson

thelight comes on, one or more diagnostic trouble codes (DTC) are stored in theengine control module.

So here is a diagram of the seat circuitry for your car. Since every other function works except the forward/backward slide function, that leaves basically the forward/backward slide motor, the seat switch, and/or the wiring. If you can verify that the wiring under the seat is in good condition without obstructions, chaffed wires, and/or wires pulled too tight, then it's safe to say it's down to just the motor and/or the switch. Sometimes if the passengers front seat has the same switch, you can plug it in to the drivers' side connector and see what works and what doesn't. If the seat works fine with the other switch, then that's all it needs, if not then it will need a motor. If the other seat doesn't have a switch then you can find them at wrecking yards, or just supply power and ground to the motor in question to see if it works. If it does, then you know you kneed a switch and if not then a motor.
I hope this info helps!~subyguru~

the blower motor is located under the passenger side of the dash. The blower motor resistor is located behind the glove box assembly. You will need to remove the glove box assembly and then you will see the resistor. It will have one connector with four or five wires and will be held to the HVAC unit with 2 screws.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

junkyards, ebay, craigslist

Is it a lift back or window and tail gate? Either way, there is a little hole on the inside for the escape hatch. Take a small pin, wire, coat hanger, push it straight in, it should pop the window, door, whichever, might be a small button over the hole, that way you can get the door lock fixed without smashing the lock off. I never tried mine , but I know all cars have them now. Check it out.

may be bad window motor or switch, your going to have to check for power at motor .if it has power and ground then motor is bad,

look near the firewall on the passenger side of the engine ( back side of engine) .