Question about 2005 Honda Element

Open Question

Passenger window fell to open position 05 element. How do I remove door panel

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the right front door panel on a 2004 buick le saber


Did you test it or are you guessing just because it won't open or close ? How To Install Remove Front Door Panel Buick Lesabre 00 05 1AAuto com both right an left are the same .
Power Windows System Components
The following components are used to control the power windows:
?€¢
Driver Door Module (DDM)


?€¢
Passenger Front Door Module (PDM)


?€¢
LH Rear Door Module (LRDM)


?€¢
RH Rear Door Module (RRDM)


?€¢
Driver Door Switch Assembly (DDSA)


?€¢
RH Front Power Window Switch


?€¢
LH Rear Power Window Switch


?€¢
RH Rear Power Window Switch


?€¢
LH Front Power Window Motor


?€¢
RH Front Power Window Motor


?€¢
LH Rear Power Window Motor


?€¢
RH Rear Power Window Motor


?€¢
Class 2 serial data circuit


?€¢
Power door serial data circuit


?€¢
PWR WDO 30 Amp Circuit Breaker


?€¢
DRVMDL Fuse (10 amp)


Driver Door Switch Assembly and Driver Door Module logic, Driver Door Module internal driver operation


?€¢
PASS MDL Fuse (10 amp)


Front Passenger Door Module logic and internal driver operation


?€¢
RRDR MDL Fuse (10 amp)


Left Rear Door Module and Right Rear Door Module logic and internal driver operation


Do you know about computer controlled power windows ?
Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally to its associated door. The driver door window can be operated only from the driver door window switch built into the DDSA.
When a window is operated from the DDSA, the DDSA interprets the window switch signal as a specific window switch request and sends the information to the driver door module (DDM) via the power door serial data circuit. The DDM examines the request and checks to see if it has received any class 2 serial data messages from any of the other vehicle modules (i.e. ignition switch position) prohibiting the movement of the window. If the window being operated is the driver door window, and if no prohibitive class 2 messages have been received, the DDM then applies voltage and ground to the driver door window motor to move the window glass as requested. If the window being operated is a passenger door window, and no prohibitive class 2 messages have been received, the DDM sends the request, via the power door serial data circuit, to the appropriate passenger door module. The passenger door module then applies voltage and ground to the passenger door window motor to move the window glass as requested.
When a passenger door window is operated from the power window switch mounted locally to its associated door, the passenger door module first checks to see if the DDM has received any prohibitive class 2 serial data messages. If there are no prohibitive messages, the passenger door module powers the associated passenger door window motor.
Both front door windows have the express down feature. This allows the front door windows to be fully opened by momentarily pulling the appropriate window switch lever to the second detente and then releasing.

Oct 30, 2016 | Buick Cars & Trucks

1 Answer

Drivers window fell off the track. how do I put it back?


just remove the door card/panel , lower the regulator/winder and manipulate it back into position then secure it.
You may want to investigate why it came off.
h

Jun 14, 2015 | 2009 Cadillac CTS

1 Answer

Rear passenger door lock fell down inside door.


open the door panel and locate the lock. screws are usually found on the handle inside, clips under the panel.

Sep 19, 2009 | 1997 Ford Explorer AWD

1 Answer

Drivers side door wont open from inside, window problems


It is most likely a rod has fallen off inside the door. You may have to use a coat-hanger to read down inside and pull back on door latch to open it up.
Then after it is opened, remove screws on inner door panel, remove window/lock controls, take a big flat-head screwdriver and gently pry next to the plastic tabs holding on door panel. Remove door panel and put window back on track , and replace or reattach door handle rods.

Aug 17, 2009 | 1998 Volkswagen Jetta

1 Answer

Rear passenger fell into the door


You need to remove the handles, there should be small covers blocking the screw, remove these, then gently pull by the bottom of the cover, you should feel the clips holding the cover to the metal frame of the door. Remove them all round and push the cover up so the window seal jumps out from the rail. Should be easy.

Jul 18, 2009 | 1999 Mercedes-Benz C-Class

1 Answer

Window fell down in door


window regulaotr cable broke. Need ane regulator. go to tascafordparts.com for discount price. Do not use a used one.

Front Door Window Regulator Motor Removal and Installation
  1. Raise the front door window glass to the full up position.
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
  1. Remove the door speaker.
  1. Position the watershield aside.
  1. sxj~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Make sure the electrical connector is positioned aside before drilling.
    To access the power window motor bolts, use a 19 mm (3/4-in) hole saw with a 8 mm (1/4-in) pilot to drill three holes at the existing drill dimples on the door.
cc3b152.gif
  1. Disconnect the front door window regulator electrical connector.
  1. Remove the bolts and the front door window regulator motor.

Jul 02, 2009 | 1999 Ford Expedition

1 Answer

1993 Jeep Grand Cherokee. Passenger window fell (tipped forward


All its done its just come off its tracks so remove the door insert carefully place the window back on the track and tighten it up using basic tools and no the door insert/panel can come off even if the window is all the way up. Hope this helps.

Jun 20, 2009 | 2002 Toyota Camry

1 Answer

Door will not open on 1998 V70 wagon


You have a broken latch that you will need to access from inside the car. Remove the door panel carefully and have a magnetic pickup tool handy to fish in the bottom of the door for any parts that fell to the bottom when the latch let go. To cheat, remove the door panel from the rear door too and you can see what is missing from the broken one.

Jan 06, 2009 | 1998 Volvo V70

Not finding what you are looking for?
2005 Honda Element Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...