Van started missing a bit changed the plugs rotor button plug wires and cap now it seems to idle ok but when you put it in gear it starts running rough,now it has no power running very rough.I checked the firing order and it is correct any help out there?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the problem is not in the plugs , wires , cap , rotor but in dirty injectors or injector controls and wires
use a quality injector cleaner for a few tanks of fuel
ECM controlled cars do not a tune up as the computer does that 60 times a minute so all you need to do is to run the fault codes and fix the faulty sensors
fault codes are being recorded all the time and only the serious engine or transmission faults put the engine light on
When it comes time to change the plugs and wires and distributor cap do the cap and rotor first. Remove the old cap with the wires still attached. Put the new cap and rotor on the distributor and transfer the old wires one at a time. Make sure both caps are lined up in regards to mounting position on the distributor. The cap will only mount one way. When you have this done then you can do the plugs and new wires, again one at a time. This way, when you are done the van should start right up and purr like a kitten. Hope this helps.
You may have some contaminated fuel,use a additive called heet,for moister,and lucas fuel treatment,these are premium additives,do not just use any brand,these I know will fix the problem if it is in the fuel.