Question about 1998 Volkswagen Beetle

Open Question

NO COOL AIRFLOW

WE CHECK THE FUSES AND DONT WORK

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could be wrong


Non working blower is usually a bad resistor. Mounted close to the blower.

Apr 09, 2016 | Cars & Trucks

1 Answer

2000 Mazda Protege A/C will cool air but airflow will randomly start, stop, and change intensity. Checked fuses, relays, and front cooling & additional A/C fans and ask seem to be working, perhaps a blower...


Sounds like the blower resistor. It can make contact and break contact as it heats up and cools down. This would cause sudden changes. If the airflow gradually changes speed, it could be the blower motor binding, such as if the motor lubrication has become very old or used up.

May 16, 2014 | Cars & Trucks

1 Answer

Fan switch 2000 beetle


Sounds like the blower resistor fuse link has popped.(not sure where the resistor is on a Beetle,but it is on the HVAC assembly somewhere-it requires airflow to keep the resistors cool).Most of the time the resistor overheats due to low airflow,if you replace the resistor,change the cabin air filter too.

Apr 14, 2012 | Cars & Trucks

1 Answer

Engine on my 2004 ford freestar is trying to over heat when accelerate and cools goes down when I slow down, also heats up going up hills.


Physically look in the radiator under the cap when cool, for coolant level, and check the valve in the cap for sticking. If air is present in the radiator it can't get out, and more coolant can't get in,(from the overflow). Either clean the cap or replace it and check that it is the CORRECT cap.
Radiator fins dirty, clean with a strong stream of water, not high pressure water.
Radiator clogged, try backflushing it, or replace.
Thermostat stuck open or shut, replace it.
Water pump worn out, can no longer move enough coolant, replace it.
Fan shroud broken or missing....
Electric Fan(s) not working, Check the fan, relay, fuse and engine temperature sensor's.
Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out.

Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on the driveway or curbs. It forces air up into and thru the condenser and radiator. If it's loose, airflow can actually push it out of place making it useless or blocking the airflow. Along with that, there may also be a plastic piece attached to the bottom of, and wraps up behind the bumper. If it's loose, airflow can actually push it out of place blocking the airflow. Simply reattach it with 4 or 5 screws.

Also, if the vehicle has A/C and electric fans, one fan is dedicated to the A/C and should come on almost the instant the A/C is turned on. The engine fan will run even with the key off, that is normal. The system is trying to cool itself. Hope this helps.

Aug 26, 2011 | 2004 Ford Freestar

1 Answer

The antifreeze from the radiator is going to the deposit box and the radiator stays empty this happens after use.


Physically look in the radiator under the cap when cool, for coolant level, and check the valve in the cap for sticking. If air is present in the radiator it can't get out, and more coolant can't get in,(from the overflow). Either clean the cap or replace it and check that it is the CORRECT cap. Check for obvious leaks.
Radiator fins dirty, clean with a strong stream of water, not high pressure water.
Radiator clogged, try backflushing it, or replace.
Thermostat stuck open or shut, replace it.
Water pump worn out, can no longer move enough coolant, replace it.
Fan shroud broken or missing....
Electric Fan(s) not working, Check the fan, relay, fuse and engine temperature sensor's.
Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out.

Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on the driveway or curbs. It forces air up into and thru the condenser and radiator. If it's loose, airflow can actually push it out of place making it useless or blocking the airflow. Along with that, there may also be a plastic piece attached to the bottom of, and wraps up behind the bumper. If it's loose, airflow can actually push it out of place blocking the airflow. Simply reattach it with 4 or 5 screws.

Also, if the vehicle has A/C and electric fans, one fan is dedicated to the A/C and should come on almost the instant the A/C is turned on. The engine fan will run even with the key off, that is normal. The system is trying to cool itself. Hope this helps.

Aug 26, 2011 | 1993 Honda Accord

1 Answer

My 1998 kia sephia over heated today. could it have been the heat? My air conditioner was.


Physically look in the radiator under the cap when cool, for coolant level, and check the valve in the cap for sticking. If air is present in the radiator it can't get out, and more coolant can't get in,(from the overflow). Either clean the cap or replace it and check that it is the CORRECT cap.
Radiator fins dirty, clean with a strong stream of water, not high pressure water.
Radiator clogged, have it boiled out, or replace.
Thermostat stuck open or shut, replace it.
Water pump worn out, can no longer move enough coolant, replace it.
Fan shroud broken or missing....
Electric Fan(s) not working, Check the fan, relay, fuse and engine temperature sensor's.
Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out.

Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on the driveway or curbs. It forces air up into and thru the condenser and radiator. If it's loose, airflow can actually push it out of place making it useless or blocking the airflow. Along with that, there may also be a plastic piece attached to the bottom of, and wraps up behind the bumper. If it's loose, airflow can actually push it out of place blocking the airflow. Simply reattach it with 4 or 5 screws.

Also, if the vehicle has A/C and electric fans, one fan is dedicated to the A/C and should come on almost the instant the A/C is turned on. The engine fan will run even with the key off, that is normal. The system is trying to cool itself. Hope this helps.

Aug 25, 2011 | 1998 Kia Sephia

1 Answer

Cooling fan isnt working and van is overheating. There is plenty of coolant in the well but it seems like it has been in there for a while and hasnt been depleting much. thank you


Physically look in the radiator under the cap when cool, for coolant level, and check the valve in the cap for sticking. If air is present in the radiator it can't get out, and more coolant can't get in,(from the overflow). Either clean the cap or replace it and check that it is the CORRECT cap.
Radiator fins dirty, clean with a strong stream of water, not high pressure water.
Radiator clogged, have it boiled out, or replace.
Thermostat stuck open or shut, replace it.
Water pump worn out, can no longer move enough coolant, replace it.
Fan shroud broken or missing....
Electric Fan(s) not working, Check the fan, relay, fuse and engine temperature sensor's.
Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out.

Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on the driveway or curbs. It forces air up into and thru the condenser and radiator. If it's loose, airflow can actually push it out of place making it useless or blocking the airflow. Along with that, there may also be a plastic piece attached to the bottom of, and wraps up behind the bumper. If it's loose, airflow can actually push it out of place blocking the airflow. Simply reattach it with 4 or 5 screws.

Also, if the vehicle has A/C and electric fans, one fan is dedicated to the A/C and should come on almost the instant the A/C is turned on. The engine fan will run even with the key off, that is normal. The system is trying to cool itself. Hope this helps.

Aug 25, 2011 | 2002 Kia Sedona

1 Answer

Oolant wont stay in my 03 nenvoy sounds at times like the fan is over working racing sound and the gauge stars rises than after awhile it goes back to normal what is my problem i had it checked for leaks...


Physically look in the radiator under the cap when cool, for coolant level, and check the valve in the cap for sticking. If air is present in the radiator it can't get out, and more coolant can't get in,(from the overflow). Either clean the cap or replace it and check that it is the CORRECT cap.
Radiator fins dirty, clean with a strong stream of water, not high pressure water.
Radiator clogged, have it boiled out, or replace.
Thermostat stuck open or shut, replace it.
Water pump worn out, can no longer move enough coolant, replace it.
Fan shroud broken or missing....
Electric Fan(s) not working, Check the fan, relay, fuse and engine temperature sensor's.
Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out.

Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on the driveway or curbs. It forces air up into and thru the condenser and radiator. If it's loose, airflow can actually push it out of place making it useless or blocking the airflow. Along with that, there may also be a plastic piece attached to the bottom of, and wraps up behind the bumper. If it's loose, airflow can actually push it out of place blocking the airflow. Simply reattach it with 4 or 5 screws.

Also, if the vehicle has A/C and electric fans, one fan is dedicated to the A/C and should come on almost the instant the A/C is turned on. The engine fan will run even with the key off, that is normal. The system is trying to cool itself. Hope this helps.

Aug 24, 2011 | 2002 GMC Envoy

1 Answer

My radicator fan is not working causing my temp gague to move alittle to the red. Is this the fuse? I added anti freeze and it still moves to the red. Thanks


Physically look in the radiator under the cap when cool, for coolant level, and check the valve in the cap for sticking. If air is present in the radiator it can't get out, and more coolant can't get in,(from the overflow). Either clean the cap or replace it and check that it is the CORRECT cap.
Radiator fins dirty, clean with a strong stream of water, not high pressure water.
Radiator clogged, have it boiled out, or replace.
Thermostat stuck open or shut, replace it.
Water pump worn out, can no longer move enough coolant, replace it.
Fan shroud broken or missing....
Electric Fan(s) not working, Check the fan, relay, fuse and engine temperature sensor's.
Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out.

Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on the driveway or curbs. It forces air up into and thru the condenser and radiator. If it's loose, airflow can actually push it out of place making it useless or blocking the airflow. Along with that, there may also be a plastic piece attached to the bottom of, and wraps up behind the bumper. If it's loose, airflow can actually push it out of place blocking the airflow. Simply reattach it with 4 or 5 screws.

Also, if the vehicle has A/C and electric fans, one fan is dedicated to the A/C and should come on almost the instant the A/C is turned on. The engine fan will run even with the key off, that is normal. The system is trying to cool itself. Hope this helps.

Aug 24, 2011 | 2003 Pontiac Aztek

2 Answers

I have a 94 olds cutlass cierra and the fans dont work


Check fuses, relays, the hook fan straight to batt power with jumper if fan is inop replace. If it works find your wiring problem.

Sep 21, 2009 | 1994 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
1998 Volkswagen Beetle Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...