Question about 1992 Mercedes-Benz Mercedes Benz 500 Class

Open Question

Top caught about halfway up and at each side of top about a 2 inch tear and can't put it up the rest of the way

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Halfway point between 2 cities


run a ruler between the two points and half way will be half the distance of the ruler measurement multiplied by the scale of the map example if the ruler is 6 inches between the cities and half way is 3 inches and the scale is I inch equals 300 miles then 3 inches will be 900 miles ( scale is on the front or back of the map)

Dec 30, 2013 | Cars & Trucks

1 Answer

Saturn ls 2000 with v6 engine 26000 miles stalls when driven 3hrs. In 96 weather and idles unstable with air conditioner on it runs Iike it is to hot but temp gauge reads below halfway mark .


try unplugging map sencer, it should be on top side of engine, a black plastic box about 2 inches wide and 3 1/2 inches long, or throttle position sencer could be bad causing engine to idle from high to low. Hope this is some help 2 you.

Sep 07, 2013 | 2000 Saturn SL

1 Answer

Crank pulley/harmonic ballencer is almost a half inch off from all other pulley on my 99 3.1 malibe


You need to replace the harmonic balancer it is coming apart.the outer part of crank pulley is actually rubber mounted to the inner part.

Mar 18, 2012 | 1999 Chevrolet Malibu

1 Answer

I have a 1997 cavalier z24 2 door coupe and having problems with power window on passenger side. when i press switch it goes down nice, but putting it up is slow and seems to stop just before halfway up.It...


the window is binding on its track! the reason that you have to give it time. is the motor for window is getting hot. and shutting down untill it cools. door panel has to come off to fix it. good-day!

Aug 27, 2011 | Chevrolet Cavalier Cars & Trucks

2 Answers

CAN NOT LOCATE THE CRANK CENSOR


the crank sensor is located on the pass. side attached to the transmission bell houseing with i 10 mm. bolt and a 3 wire connector. ramundoo

Mar 01, 2011 | 1999 Dodge Intrepid

1 Answer

Have a 2002 chevy silverado 2wd that is making a popping noise when I turn left or right and has vibration going down highway. Noticed that grease boot on driver side ball joint was busted and was...


It is possible that the ball joint is bad, to check you can jack the wheel up 1/2 off the pavement and use a tire iron to lift up and on the tire and watch the ball joint if it moves up and down thats your problem. from a mechanics point of view I would replace both the top and bottom at the same time as this saves labor since you have to tear it down anyway and the upper ball joint should be worn as well. If the ball joint does not move then put your hands on each side of the tire and move it back and forth, if you get movement you will need to get a second person to move the tire back and forth and watch to see where the play is. normally it will be in the drag link or the control rod, replace items as needed and try for free play again, you may find another bad part as well. normally there is more than on failed part. once you have done the parts replacement you can put a scratch in the tire with a nail on each front tire and then with a tape measure measure the front and back of the front tire you will want to get it toed in 1/8 of an inch then go to a tire shop for a alignment. should be around 58 inch's center so front would be 57 inch's and 15/16 this of an inch and the back would be 58 inch's and 1/16 of an inch. hope this helps. If it does please rate and thanks for using fix-ya.

Oct 06, 2010 | 2002 Chevrolet Silverado

1 Answer

I have a 2008 saturn sky. When I put the top up the fabric on the passengers side always gets pinched in the frame and I have to keep pulling it out. Is this a common problem. Can it be resolved.


I had the same problem. Check for a tear on the underside of the top..,directly underneath where the fabric gets pinched. It's most likely torn from the metal piece that has popped out of the rubber shroud. Every time you open and close the top, this part rubs...eventually tears...and then pinches when you try to close the top back.

Solution --

1. Bend the metal back into place (hammer if necessary).
2. Glue a piece of velcro (fuzzy side up) to cover the exposed metal (gorilla glue works nice..but don't use too much!!)
3. Glue a piece of vinyl to the underside of the top (covering the rip)...use a good, flexible-type contact cement and let it sit for a couple of days to allow proper adhesion.
4. The velcro will slide on the vinyl and...no more pinched top!

Keith
Sky owner since Nov '06

Aug 10, 2010 | 2007 Saturn Sky Red Line Convertible

1 Answer

I would like to top up the differential/axle oil on my yr 2000 Wreg Ford Transit Longcube 2.5 ltr non-turbo diesel *. I've had a look on top of the differential but can not find an obvious filler cap or...


two places to look ,on the back of the diff unit about halfway or on the nose cone about halfway ,use EP90 hypoid oil ,the one on the top is a breather/vent you can only fill to the plug level .plug could have a 1/2 inch square drive to remove it .top class these transits best white van around

Aug 05, 2009 | 2000 Ford F Super Duty Chassis Cab

1 Answer

1998 mercury grand marquis 4.6 sparkplug change


un-plug the coil packs--injectors--pull wiring out of the way,and then unbolt the coil packs and pull them out,and use a 6 inch to 8 inch extension on a 3/8 drive rachet with a 5/8 plug socket...snug the plugs back in pretty good because the 4.6 and 5.4 are known to blow the plugs out and wreck the threads on the head.On the drivers side you may have to unbolt the fuel rail(2 bolts)and lift it up off from the injectors,make sure that you dont tear the 0 rings on the injectors and watch to see if some or any 0 rings comes off from the injectors and stays with the fuel rail..when putting the fuel rail back on the injectors,use a little motor oil and wipe it on all 0 rings to assist in going back together without tearing the 0 rings.

May 08, 2009 | 1998 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...