Question about 1995 Oldsmobile Cutlass Ciera

1 Answer

How do I replace the back window? - 1995 Oldsmobile Cutlass Ciera

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 45 Answers

Remove the black vinyl trim from the edge of the glass. Remove broken glass & urethane adhesive from the metal pinchweld leaving a thin layer (approx 1/16") of urethane for new new urethane to adhere to. Vacuum broken glass. Prime nicks to the metal to protect from rusting (also insuring a good surface to bond to). Attach vinyl reveal molding to glass (unless it's a "T" shaped push in type - it would install after the glass is set). Clean and prime the replacement glass. Apply new urethane adhesive. Set glass in place.Slide the metal joint cover in place on the molding (at bottom in the center). Clean outer surface of glass. Allow for safe drive away as noted by urethane manufacturer.

Posted on Sep 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

DS window on 2011 Toyota Tacoma pickup is not working. Just replaced the 30a fuse & the window stated going down. Now the other windows work, however the drivers window will not go back up. 30


if there is noise coming from the driver side window is down why you pushing the control button for upwards means the window motor / regulator needs to be replaced. If there is nothing the main control switch for the windows may need to be replaced

Jan 12, 2015 | 2011 Toyota Tacoma

2 Answers

Window off track of chevy tahoe rear window how do you get it back up


If it is off track just take the inner door panel off and put it back on track. if that don't work replace the broken window regulator and check the window motor to see if it is still good. replace if necessary .

Feb 16, 2013 | 2004 Chevrolet Tahoe

1 Answer

The windows in the back seat won't go up...there was no sound...one window is stuck about 5 inches from the top and won't go up or down


Try replacing the fuse for your back windows or you might have to replace the electric motor that operates the back windows.

Jun 29, 2011 | 1999 Volkswagen Golf

1 Answer

Power Window in 99 Grand Am came down and won't go up


Broken sash clip or broken cable. Read this post

http://ricksfreeautorepairadvice.com/replace-a-window-regulator/
Replace window regulator Ricks Free Auto Repair Advice

Sep 30, 2017 | 1999 Pontiac Grand Prix

1 Answer

Replacing the back window in a 2002 convertible


The rear window in your car is a separate part from the top so it can be replaced without replacing the top.
You must, however remove most of the top.
Windows are available on Ebay and instructions are available on DVD here.
http://www.topgunwon.com/DVD/

Regards, Karl

Oct 28, 2009 | 2002 Chrysler Sebring

2 Answers

I recently had my back window in my audi A3 shatter when closing the trunk. This has been replaced but since then the reception on my car radio is terrible. Is the aerial built into the back window or...


on a lot of cars there is an antenna in the back window and if it was not reconnected when the new window was installed that would cause the problem did your old window have lines in it if so it had the heater and the antenna.

Aug 31, 2009 | 2005 Audi A3

1 Answer

Just bought /used 1996/ back window is hanging how do i replace


have to remove the top to restich in window....and with labor cost so much you might just as well replace whole top...

Aug 16, 2009 | 1999 Chrysler Sebring

2 Answers

Back window of VW Cabrio 2001 is broken/ Need replacement


Look for a junkyard around that sells the window or buy one online for dirt cheap and then put it in yourself. It is not that hard just time consuming.

Jul 09, 2009 | 2000 Volkswagen Cabrio

1 Answer

Replacing rear passenger window


I ended up removing the regulator, replacing the window in its track and ordering a replacement regulator.
the information provided by FixYa was helpful in getting the window back in place but the main issue was 'restringing the cables' on the regulator - apparently difficult if not impossible to do, therefore the necessity to order the new part.

Mar 21, 2009 | 2004 Pontiac Grand Prix

Not finding what you are looking for?
1995 Oldsmobile Cutlass Ciera Logo

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...