Question about 2005 Chrysler Pacifica

Open Question

How do I replace the spark plugs on my 05 pacifica

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: where are the spark plugs on an 05 3.5 liter chrysler pacifica?

Each of the plugs has it's own coil so they are under the swaure coil, you won't see traditional spark plug wires, look for sets of two wires headed for ~ 2.5 inch square block, three plugs can be seen in front of the large plastic air plenum, the uther three are underneath the plenum. Takes a real handy DIY person to do this as there are plenty of things to remove before the plenum comes off. Take good notes on how you remove things, I missed a lever that is part of the idle system and throught I messed things up bac\d, but when I located the correct place to attach the lever it was fine. Also be careful and not break a connector to the individual coils. I did, but was able to glue it together...

Posted on Apr 09, 2009

bschilz
  • 2049 Answers

SOURCE: how i do replace my spark plug in my pacifica

This video tutorial should give you the information you need to do the job.
http://www.wonderhowto.com/how-to/video/how-to-replace-your-own-sparkplugs-127455/
Good luck!

Posted on Aug 12, 2009

  • 60 Answers

SOURCE: How do you change Spark plugs for an 05 Chrysler

is it a DOHC V6 if so ur in luck their is probably a plastic cover on the engine remove that to gain access to the valve cover on the front bank. The spark plugs should be right in the center of the valve cover you'll need to get a 6" or so extension to reach down into the cylinder head to remove them the same steps for the spark plugs on the back bank (closest to the fire wall).

Posted on Oct 13, 2009

  • 599 Answers

SOURCE: torque specs on replacing cv axle on 05 Pacifica

ok here we go tie rod=55 ft lbs axel nut= 180 ft lbs strut bolts= 65 ft lbs plus 90 degrees

Posted on Jan 07, 2010

Testimonial: "thank you very much!!!!!!!!!!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the spark plugs on an 2006 Chrysler Pacifica 3.5 liter


The spark plugs are located on the "back side" of the engine. To get to them (i.e., for plug replacement) is quite the ordeal -- requiring removal of a bunch of stuff.

I had the dealer do my plug replacement and it was a little spendy -- mostly b/c of all the labor involved.

Mar 07, 2015 | 2006 Chrysler Pacifica

1 Answer

Installed timimg belt on a 05 Chrysler Pacifica 3.5L V6. Marks are aligned correctly with engine on TDC. But car starts like timing is off. Has no power. No codes present. Running out of ideas. Can so


I have had this problem on one car where the inside of the gear has detached from shaft , another where the distributor had mal alighned its weights

Jan 06, 2015 | 2005 Chrysler Pacifica

1 Answer

Where are the spark plugs located on a 2007 chrysler pacifica?


Usually just above the pistons in the engine located under the hood.

Apr 28, 2013 | 2007 Chrysler Pacifica FWD New Cars

1 Answer

I'm trying to change my sparks plugs on a 2004 chysler pacifica. I wanted to how many spark plugs does my car have.


Your Pacifica 2004 has a 3.5L engine 6 cylinder, you will need six spark plug's, the spark plug gap is .050", make sure you gap the spark plug's before you install them, hope this was very helpful.

Aug 26, 2010 | 2004 Chrysler Pacifica

1 Answer

How do you set the timing on the spark plugs for a 2005 chrysler pacifica


the 05 pacifica has veryable valve timing. no adjustment. hope this helps CJ

May 20, 2010 | 2005 Chrysler Pacifica

1 Answer

Torque specs on replacing cv axle on 05 Pacifica


ok here we go tie rod=55 ft lbs axel nut= 180 ft lbs strut bolts= 65 ft lbs plus 90 degrees

Jan 07, 2010 | 2005 Chrysler Pacifica

1 Answer

How do you change Spark plugs for an 05 Chrysler Pacifica and where is it located?


is it a DOHC V6 if so ur in luck their is probably a plastic cover on the engine remove that to gain access to the valve cover on the front bank. The spark plugs should be right in the center of the valve cover you'll need to get a 6" or so extension to reach down into the cylinder head to remove them the same steps for the spark plugs on the back bank (closest to the fire wall).

Oct 13, 2009 | 2005 Chrysler Pacifica

1 Answer

Changing my spark plugs


you can do this at home without a lift because your spark plugs are on the top of your motor, but it is a pain. i have an 05. you need to go and get yourself a manual from autozone or advance auto for a 2004 and up charger. it has the 3.5l v6 in there as well and breaks it down on what you ahve to do to change them.

Jun 04, 2009 | 2004 Chrysler Pacifica

1 Answer

Where are the spark plugs on an 05 3.5 liter chrysler pacifica?


Each of the plugs has it's own coil so they are under the swaure coil, you won't see traditional spark plug wires, look for sets of two wires headed for ~ 2.5 inch square block, three plugs can be seen in front of the large plastic air plenum, the uther three are underneath the plenum. Takes a real handy DIY person to do this as there are plenty of things to remove before the plenum comes off. Take good notes on how you remove things, I missed a lever that is part of the idle system and throught I messed things up bac\d, but when I located the correct place to attach the lever it was fine. Also be careful and not break a connector to the individual coils. I did, but was able to glue it together...

Mar 20, 2009 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...