Question about 2002 Ford Ranger Regular Cab

Open Question

How do you get to the front turn signal on a 2002 ford ranger to change the bulb

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: change rear signal bulb on 2002 ford focus wagon

Open the rear tailgate There are 2 screws that hold light housing in place.. Remove the screws then pull the housing outwards till the clip behind it springs. You then need to knock the housing sideways (outwards) to free the 2 prongs that attach housing to the car body.
Unclip the rear housing from the back of the light unit & change the bulb.

Posted on Jan 17, 2009

  • 534 Answers

SOURCE: left rear turn signal quit on 2000 ford ranger.

Check correct wattage globe is installed in both front and rear indicator lights;
check if any other side/repeat indicator lights have failed.

Posted on Jun 18, 2009

  • 82 Answers

SOURCE: I have a 77 Ford Ranger, the break lights and rear

You probably have a broken or corroded wire somewhere between the steering column and the rear lights. Trace the wires from the light toward the front and check for problem areas. You may have to peel back the wire covering the tube the corrugated plastic stuff to find a bad splice. Could be a bad ground somewhere in there also.

Posted on Jun 29, 2009

  • 157 Answers

SOURCE: how do you change the

Hi there,

Here are some few tips to help out. Firstly, remove the screws retaining the headlight and trim assembly. Then carefully rotate the headlight and trim assembly away from the vehicle, rotating the inboard side away from the vehicle. Remove the side marker, parking and turn signal bulbs and sockets from the headlamp and trim assembly. They can be removed by turning them. If you are replacing a lens, remove the retaining screws for the lens to be changed and remove it from the headlight door.

When removed, install the removed lens assembly. Then, install the bulbs and sockets and install the headlight and trim assembly. Make sure you check the operation of the lights.

Best of luck...

Posted on Jan 16, 2011

  • 43 Answers

SOURCE: how do you replace front

unscrew the bolts attaching the bulb cover to the mounting then open it and squeeze the bulb in order for it to be detached from where it is placed..then simply replace the bulb replacement then squeeze it to lock to its holder..then attach or place back the bulb cover and screw the bolts to finish the job..thats it..

Posted on Mar 06, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Turn signal harness 2002 ford ranger 14a320 diagram turn signal connector wire colors and ppin location

images for Turn signal harness 2002 ford ranger

Ford explorer turn sinal problem got fixed - YouTube

? 3:23
Jul 12, 2013 - Uploaded by Raybob216 My 04 exployer left turn signal and break light not working fix loose wires behind ... bulb and come to find out wire had popped out of the harness. ... How to Change Ford Explorer 2002 Flasher Relay for Hyper Flasher Relay ... How To Install Replace Turn Signal Wiper High Beam Switch Ford Ranger 95-98 ...

Oct 07, 2015 | Ford Cars & Trucks

2 Answers

My right front turn signal on my 2001 ford ranger doesnt work and my inside right turn signal light on dash doesnt work and flashes really fast. Buld on right side was replaced and works when lights

was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ALso produce turn singles

Dec 06, 2014 | 2001 Ford Ranger Regular Cab

1 Answer

How do I replace the front turn signal Bulb of a 2001 Ford Ranger

If I remember correctly to change the turn signal bulb you have to go in from the back side. So open the hood, look around because you may have to move some stuff for hand clearance, then it's a 1/2 twist to get the bulb socket out. install is the reverse of getting it out.

Sep 28, 2014 | 2001 Ford Ranger Regular Cab

1 Answer

1993 ford ranger. when you turn on left turn signal front light burns steady and back light does't burn. tested for power and had power. bulb is good. right side works fine.

Although you say you tested it for power, and the bulb is good, I am almost certain it you change the bulb it will work. The one at the back. Take the one from the right side and try it in the left. Then you'll know. If there is still nothing and your test light shows power, it has to be a bad ground wire. If you have an aftermarket trailer plug on that thing, that will be another place to look.

Aug 18, 2013 | 1994 Ford Ranger Supercab

1 Answer

2002 Ford Ranger pickup. The signal lights blink real fast and it appears to be wired wrong. Where are the front signal lights located

The light bulbs may have the wrong part number bulb,check the parts store to see that this is the problem,the blinkers are in the front near the headlights.

Aug 15, 2010 | Ford Ranger Cars & Trucks

1 Answer

2003 Ford Ranger, XLT 6Cyl. Flashers, Running Lights, Reverse Light, Right and Middle Brake Light and Headlights are working. Front running/parking lights are not working. Signal Lights, Front and Rear are...

Found very detailed assistance and instructions, FREE on the Ranger Station Forum. It is nice being able to go on-line and find lots of free information from fellow American Ford Ranger owners and not be asked for $$$.

If you want the details let me know and I will send it to you for $19.95 or $39.95 if you want immediate response.

Jan 02, 2010 | 2003 Ford Ranger Regular Cab

1 Answer

The drivers side turn signal will not work when you put the parking or headlights on

sounds as if there may be a short in filaments in one of the bulbs on that side change front and rear bulbs on t hat side

Aug 20, 2009 | 1998 Ford Ranger SuperCab

1 Answer

2001 Ford Ranger right turn signal doesn't work when the braking

Flasher Unit sounds bad... change the flasher, which is in the inboard fuse panel.

Feb 27, 2009 | 1986 Ford Ranger 2WD

Not finding what you are looking for?
2002 Ford Ranger Regular Cab Logo

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides