Question about 2001 Toyota Sequoia

Open Question

Where is the vsc fuse located? - 2001 Toyota Sequoia

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My vsc light is coming on,2007 tundra. can you tell me which fuse that is


Hello, it's not a fuse problem, there is a fault code in the ABS computer that should be diagnosed using a code reader that can access the abs/vsc system.

Sep 19, 2017 | 2007 Toyota Tundra

1 Answer

The vsc trac sensor location on a 2002 Toyota sequoia


A speed sensor failure in the rear axel housing has damaged friction plates in the differential (limited slip). This axel should have had oil serviced at 80,000 miles

Jun 02, 2017 | Toyota Cars & Trucks

1 Answer

Transmission locked in Park, and ABS, VSC TRAC, VSC OFF show on the dash. Heater blower not working so I was pulling fuses looking for a blown one.


04 toy LC.
engine run, Headlights work not dim.??????
dash lamps can glow good on a near dead battery......!!!
lets do the blower but there are 2 ,front and rear?
it fails on high?
what series LC , LC has vast variances world wide, you in
USA or Uganda/?
our LC, is show here, at alldata.com we log in see schematic
and bingo the voltmeter is busy
got a schematic yet , of your HVAC?

USA comments to follow.
easiest Blower remove , ever.... just 3 hand moves... amazing.
wow front and rear A/C ! and blowers..... like a hotel....
3 fuse boxs, 2 in cab and 1 in eng.bay
im busted, my online sources as one page missing in hvac.
the blower.
sorry
the USA LC is complex. id recommend a real FSM. for best play.


Jan 15, 2014 | 2004 Toyota Land Cruiser

1 Answer

Toyota troubleshooting


Check fuse block for possible burned electrical fuses, if good, check park safety switch located above brake pedal for failure.

Dec 22, 2013 | Cars & Trucks

1 Answer

Enable vsc on 2001 lexus gs430


the VSC is reading only when is dissabled

Jun 07, 2017 | 2001 Lexus Gs 430

1 Answer

My toyota Highlander is showing CHECK VSC light


First check and make sure your gas cap is tight, if this does not resolve the problem read below.A vacuum hose has become disconnected, more than likely due to having your air filter replaced. The VSC and Check engine light typically don't come on until after 150-200 miles after the vacuum hose was pulled out The fix: on the right-hand-side of the engine compartment behind the big plastic housing that holds the air filter you will find a black rubber hose that is not connected to anything. Squeeze the finger clamp on the hose and slide the hose back onto the half inch nipple on the back of the air filter's plastic housing In order for the VSC and Check engine light to be turned off, you will need to open the fuse box, right-side of the engine compartment, and pull the 20 amp EFI fuse for 10 seconds. This will reset the system. The fuse location is marked on the lid of the fuse box, also I believe the EFI fuse is the only 20 amp fuse.(and after you're sure nothing is really wrong with your car), try resetting the "maintenance required" display by setting first your ODO display to the ODO setting. Turn off your engine. While pressing and holding down the ODO button, turn your key to the ON position. The display will do this weird blinking action then it'll go back the ODO reading. No more "maintenance required" display.

Oct 11, 2011 | 2008 Toyota Highlander

3 Answers

The following lights came on:VSC TRAC, VSC OFF, Airbag.


You have a short in your system. Most likely from the fuse you replaced you are going to have to trace wires and figure out exactly where the short is located and replace the wiring.

Jun 04, 2010 | 2005 Lexus GX470

2 Answers

2007 lexus rx350 ,vsc light on and check engine light is flashing


First check and make sure your gas cap is tight, if this does not resolve the problem read below.
A vacuum hose has become disconnected, more than likely due to having your air filter replaced. The VSC and Check engine light typically don't come on until after 150-200 miles after the vacuum hose was pulled out.
The fix: on the right-hand-side of the engine compartment behind the big plastic housing that holds the air filter you will find a black rubber hose that is not connected to anything. Squeeze the finger clamp on the hose and slide the hose back onto the half inch nipple on the back of the air filter's plastic housing.
In order for the VSC and Check engine light to be turned off, you will need to open the fuse box, right-side of the engine compartment, and pull the 20 amp EFI fuse for 10 seconds. This will reset the system. The fuse location is marked on the lid of the fuse box, also I believe the EFI fuse is the only 20 amp fuse
. This will help. Thanks, please keep updated. please do rate the solution positively .thank you for using fixya


Dec 29, 2009 | 2007 Lexus RX 350 FWD

1 Answer

My 2006 highlander vsc lights and abs lights stay and the shifter wont disengage out of park


Look for a blown Brake Lamp fuse, or a faulty brake lamp switch, which is located above the brake pedal.

Oct 19, 2009 | 2003 Toyota Highlander

1 Answer

Vsc, vsc off - lights on


It is probably your MAF sensor located near the airfilter (Mass Airflow Sensor) or the Oxygen sensor. but most probably the MAF.

Feb 16, 2009 | 1999 Lexus Gs 300

Not finding what you are looking for?
2001 Toyota Sequoia Logo

Related Topics:

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...