Question about 1998 Subaru Legacy

1 Answer

I just changed the starter, disconnected battery

I just changed the starter in my 1998 Subaru Legacy AWD, disconnected battery put it all back together and now my lights are flashing along with the glove box light. Not emergency flashers,much slower. I pulled all fuses, don't know what to do. Can you help19

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 382 Answers

Under dash by your left knee is a 4"x4" box. It has a small wire lead with a button on the end. Turn ignition on and push button. Resets the alarm. THis will stop your lights from flashing. Have a great day.

Posted on Oct 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace 2000 subaru outback starter motor?


1) Remove air cleaner box
2) Disconnect battery
3) Remove 2 bolts that mount starter
4) Remove wires at starter
5) Remove starter
6) Reversr order to install

Jul 11, 2014 | 1998 Subaru Legacy

1 Answer

AWD went out in my 1998 Subaru Forester?


This recently happened to my 98 Subaru Legacy Outback.
My problem is in the rear differential. May be the same for you.
When making a turn, the car sounds like a Star Wars T.I.E. Fighter. The outside wheel is not turning fast enough to keep up with the inside wheel or vice versa. AWD is disengaged and car is currently operating on Front WD. I was told this is fine to drive this way.

Jul 22, 2010 | 1998 Subaru Forester

2 Answers

Replaced battery about a month ago. After about as


Could be a poor connection on one of the battery terminals - be sure they are tight.
Could also be a starter solenoid that is sticking.

Dec 02, 2009 | 1998 Subaru Legacy

3 Answers

'97 subaru legacy L,AWD wagon, 2.2L, auto trans.


Do you hear a 'click' when the key is turned to start? Have someone try the key while you listen under the hood. It should be the starter solenoid clicking. You need either a test light or voltmeter to test further. One large terminal on the solenoid has the large wire from the battery positive, and should always show voltage/light at all times. Test the other side of the solenoid (large terminal) that is connected to the terminal on the starter motor. It should show light/voltage when the key is turned. If it doesn't, the solenoid must be replaced. If it does show light/voltage, then the starter motor is defective (probably brushes). If you get no click when turning the key, test the small terminal on the solenoid, you should see a voltage/light change when the key is turned. If you see a change, but no click, the solenoid coil is open or the case of the solenoid is not grounding where it is mounted. Try loosening the mounting and re-tighten. If no help, replace the solenoid. If you see no change at the small terminal, remove the wire from it and using a spare piece of wire, touch the small terminal to, first, the large terminal that the battery is connected to, then to the the mounting bolt for the solenoid. If the solenoid is good, the starter should operate with one of these two tests. In that case, the starter position of key switch is open--replace the ignition switch.

Sep 15, 2009 | 1997 Subaru Legacy

1 Answer

When starting, I get one click, and the car will not sart.


check the connections at the starter switch
tighten terminals inside

May 17, 2009 | 1994 Subaru Legacy Outdoor

1 Answer

97 outback legacy; won't start


not sure if this will help, but I recently changed the engine in my subaru and changed battery + starter also. Would start but then not restart once warmed up. Turns out the engine ground got forgotten, had that hooked back up after banging my head on a wall for a week and it runs like new

Apr 05, 2009 | 1997 Subaru Legacy

2 Answers

How do you replace the fuel pump in 1992 2wd Subaru Legacy Wagon


  1. Relieve the fuel system pressure.
  2. Disconnect the negative battery cable.
  3. Remove the rear exhaust pipe and muffler assembly.
  4. On All Wheel Drive (AWD) vehicles, remove the rear differential assembly and the rear crossmember. You do not have AWD so this step is not for you
  5. Remove the fuel filler cap and drain the fuel into a suitable container.
  6. Remove the fuel filler pipe protector.
  7. Raise and support the vehicle safely on jackstands.
  8. Remove the fuel filler, air vent and delivery hoses.
  9. On AWD vehicles, disconnect the air breather hoses and evaporation hose from the pipes.
  10. Support the fuel tank with a floor jack or equivalent lifting device.
  11. Loosen the attaching bolts and lower the fuel tank slightly.
  12. Disconnect the fuel pump harness

Feb 18, 2009 | 1992 Subaru Legacy

Not finding what you are looking for?
1998 Subaru Legacy Logo

Related Topics:

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...