Question about 1999 Dodge Ram

Open Question

How do I remove the dashboard from a 1999 Dodge Ram 1500 pickup? The dash is broken and I have purchased a new replacement, which I want to install. It looks straight forward, but I'm concerned about the passenger side air bag.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
phoenixinks
  • 89 Answers

SOURCE: Pickup wont start

well you can short over the starter and see if it starts. honestly i would remove the starter and take it to your local autozone. they will check it for free. also check the start solenoid. they have a tendency to cause the same effect.

Posted on Jan 14, 2009

Ad
  • 3 Answers

SOURCE: 1999 dodge ram 1500 v8

Something else to check if not starter maybe starter relay is toast and if so it is $25 or less I am Canadian here its $25 US should be much cheaper.

Posted on Jan 15, 2009

SOURCE: 1999 Dodge Ram 1500 Fan Motor Resistor Location

I've never seen a vehicle w/o a blower resistor. You don't need to remove the blower. The resistor is about 2 inches x 3 inches and is installed in a hole in the plenum (duct) near the blower motor. It will have a wiring harness connected to it. It could be under the passenger dash or under the hood, depending on where the blower motor is.

Posted on May 06, 2009

boosted17
  • 1 Answer

SOURCE: SEATBELTS STUCK ON 1999 DODGE RAM 1500 IS IT A MODULE ?

it is under the center seat. Yes it is the module.

i am having the same problem right now.

trying to find a new one.


Posted on May 23, 2009

outdoorsman5
  • 631 Answers

SOURCE: 1999 Dodge Ram 1500 Pickup error code p0171

This code means that system to lean, bank 1.
some of the possible causes to make this code set are
1. intake or exhaust leak,
2. problem with the air system.
3. MAF (Mass Air Flow sensor)VAF sensor (Volume air flow sensor)
4. fuel pressure/pump
5. injector(s)
6. HO2S (Oxygen sensor)

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does brake light work but not turn signal?


The replacement dual- filament lamp could have been installed incorrectly in the socket

Oct 13, 2015 | 2002 Dodge Ram Pickup 1500

1 Answer

Key is stuck in ignition receiving no electricity


You are not the only one:

Key stuck in ignition, wont start, dodge ram pickup - Fixya

www.fixya.com/.../t14560159-key_stuck_in_ignition_wont_start_dodge
Oct 6, 2012 - key stuck in ignition, wont start, dodge ram pickup - Dodge Ram 1500question. ... 631 Answers. SOURCE: 1999 Dodge Ram 1500 Pickup error code p0171. This code means ... Jun 28, 2011 ' 1987 Dodge Ram 50 ยท 1 Answer .

Aug 23, 2015 | 2011 Dodge Ram Pickup 1500

1 Answer

1998 dodge ram 1500 5.2. outside air comming


You have broken vent door on your truck.
Remove the glovebox use flash light to check top of the heaterbox area (top of blower motor housing- toward windshiled area) You will see sponge covered vent.door or you just see outside light)
you can get complete repair kit with necessary electrical actuator about 65/75$ but thing is a job,, basically you have to remove almost whole dashboard to replace them correctly.
good luck.

Oct 05, 2013 | 2004 Dodge Ram 1500

1 Answer

How to replace freeze plug in 1998 dodge ram 1500 pickup


remove engine mounts , sometimes exhaust manifolds. jack up engine drill holes in old pugs use hole to pull out plug install new plugs is all day job for all.

Jul 15, 2012 | 1998 Dodge Ram

2 Answers

Where aux fuse panel for 99 dodge ram 1500


Check the Owner's manual. it could be located under the dash, in the glove box or under the hood.

May 25, 2010 | 1999 Dodge Ram

1 Answer

2005 Dodge Ram 1500. Dimly Flickering center dashboard lights


It is caused usually when the arternator is going bad

Jan 20, 2010 | 1999 Dodge Ram

1 Answer

Dashboard removal of '98 dodge ram 2500


on the 98 model the fuse box can be removed without removing the whole dash board.

Apr 29, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

Top of dash need replacing


There is a company called coverlay that sells a fitted cover for your dash. You can go to there website and search your vehicle to find the right one and the right color.
Here is the info from there website:

98-01 Dodge Ram Pickup Dash Cover 22-802L

Fits:
98-01 Ram 1500 (with airbag)
98-02 Ram 2500, 3500

This dash cover is custom formed to the exact shape of your orginal dash. It is installed over top of the orginal dash, and is held in place with silicone adhesive (provided). The installtion can usually be completed in 30 minutes or less. No special tools are required. No original parts need be removed. Dash covers can be purchased in several standard colors.

Mar 09, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
1999 Dodge Ram Logo

Related Topics:

840 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...