Question about Ford Tempo

1 Answer

INSTRUCTIONS TO REPLACE LEFT SIGNAL LIGHT BULB ON 1992 MERCURY TOPAZ . Took the center fake light out, got the headlight clips out ,could not get the headlight out to get at the corner light to access the bulb. Is there anything else to remove to get at the corner light? Tom

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 546 Answers

There are screws 8mm head I think,that also hold headlight assembly in place,along w/ the clips.

Posted on Sep 25, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replace turn signal flasher

Change the bulb first... That's a double filament setup...could be a $2 fix

Jan 27, 2014 | Mercury Mariner Cars & Trucks

1 Answer

Wind shield wipers go on on there own when I hit a bump on road when this happens the left signal dont work or the left headlight

Yes there is and it will be in ya stearing colum. Chance are it is a wire that has chafed though. Pull it apart and inspect all your wires it could only be a small hole in one wire causing the problem.

Dec 02, 2012 | 1992 Mercury Topaz

1 Answer

I have a 1991 Mercury Cougar LS. Intermittently the left brake light will fail to work. The right one works, as does all the rest of the lights,: reverse, park, turn signal, etc, even when the brake

Replace the bulb first, if it still does this replace the socket and make sure the ground for the light is clean and tight and that the connectors for the tail lights are fully clipped together.

Oct 25, 2012 | 1991 Mercury Cougar

1 Answer

Where is my tail light bulb located

This is pretty can do this! Open the trunk, lean in and you can see the wires leading to the tail light, it is the far left wires for the left signal and the far right wires for the right tail light. Grasp the socket that the wires are connected to, twist, and the socket comes out with the bulb. Take the bulb to the store and buy another one.

Better yet, the folks at Autozone will actually help you replace bulbs when you buy one there and it's as quick as this to replace...good luck...Chris

Oct 13, 2011 | 1992 Mercury Capri

1 Answer

I need to replace the left turn signal bulb but cant figure out how to get into the turn signal assembly

pop the hood up - remove the plastic cover that spans over the radiator area -- there should be 6 plastic push-in clips holding it, I use a wire crimper tool to pull them up -- it's a bit tough to see, a flash light will greatly help, but just next to the headlight you can use a larger screwdriver to pry back the plastic clip that holds the clearance/turn signal lamp to the headlamp and it will just pop out from there. If I remember correctly, you'll have to pry towards the center of the car. It is fairly stiff so be firm, but not violent.

May 21, 2010 | 2001 Chevrolet Cavalier

3 Answers

I need to change the left front turn signal bulb on a 2006 Cadillac SRX? Looks difficult. Paul LeMaster

hi Paul

Should be able to open the hood remove plastic headlight cover & pull pins (2) on light assembly whole light assembly will pull out then replace turn signal.

Good luck.

Dec 02, 2009 | 2006 Cadillac SRX

2 Answers

Changing the headlight in a '02 Mazda tribute

The bulb is actually very easy and straight forward to replace.

If you are replacing one bulb, I suggest doing both at the same time and a twin pack is less than buying two packs seperately.
  • Removal
  1. Holding the connector on the sides squeeze and pull back away from you.
  2. Once the connector is removed, gently pull the rubber boot back.
  3. This will revail a snap type of clip. NOTE bottom of clip does come off. Push each top side of the clips towards you to relase them.
  4. Once the tops of the clip are undone let the clip swing down.
  5. slide the bulb out of the lens.
  • Install
  1. To install the new bulb ensure the three keys are properly aligned with the lens when installed.
  2. Install buld into lens.
  3. Place clip over bulb.
  4. Place boot over bulbs making sure it is fully engaged into lens.
  5. Push connector back onto bulb.
  6. Check lights to make sure everything works.

Nov 05, 2008 | 2003 Mazda Mazda6

1 Answer

Need stereo wiring codes for 1992 mercury topaz

1991-92 Mercury Topaz Stereo Wiring Constant 12V+ Green/Yellow Switched 12V+ Yellow/Black Ground Red/Black Illumination n/a Dimmer Blue/Red Antenna Right Front Front Speakers 6 1/2" Doors Left Front (+) Orange/Green Left Front (-) Black/White Right Front (+) White/Green Right Front (-) Black/White Rear Speakers 6" x 9" Rear Deck Left Rear (+) Pink/Green Left Rear (-) Pink/Blue Right Rear (+) Pink/Blue Right Rear (-) Green/Orange


Please take a moment to rate this solution thanks

Oct 08, 2008 | 1992 Mercury Topaz

1 Answer

How to replace headlight on a 2003 Chevy Tracker

There are two black plastic clips behind the the air filter, remove them and release the whole assembly to access the lights.

If you still get in troubles, have it replaced at a petrol station, they will help you in fitting the bulb, and it won't be expensive.

Here follows
2003 Chevrolet Tracker Light Bulb Size Chart
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 1157A
Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 921
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 168 Or 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 921
Front Sidemarker Light Bulb Size: 194
Ash Tray Light Bulb Size: 74
Step/Courtesy Light Bulb Size: 168
Trunk/Cargo Area Light Bulb Size: 168
Instrument-General Light Bulb Size: 158 or 74
Check Engine Indicator Light Bulb Size: 74
Hi-Beam Indicator Light Bulb Size: 74
Seat Belt Indicator Light Bulb Size: 74
Brake Warning Light Bulb Size: 74
Automatic Transmission Indicator Light Bulb Size: 74
Directional Signal Indicator Light Bulb Size: 74

Oct 02, 2008 | 2003 Chevrolet Tracker

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

324 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers


Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides