Question about 2001 Pontiac Firebird

1 Answer

I need to replace the LH headlight motor in my 2001 trans am

I need to replace the headlight motor in my 2001 Trans am on the LH side, but not sure the proper steps to take. Can you help out?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Http://www.youtube.com/watch?v=HuolISwRJJg

same steps just replace the whole motor not the gear.

Posted on Feb 23, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove a vss on a 1994 Lincoln continental with a ax4s transmission


It attaches like a speedo cable used too. It just has one bolt holding it clamped into the trans tail shaft, LH side, with a plug on it instead of a cable. If you jack the rear up high, you may not lose any trans fluid. either way, check trans fluid level when you're done and make sure the plastic gear is the same color (number of teeth).

Sep 24, 2014 | 1994 Lincoln Continental

1 Answer

Where is reverse switch located on 2001 saturn sl?


for a std trans its on the top of the trans below but to the back side of the battery on a auto trans its on the back side of the trans below the brake master cylinder

Aug 14, 2012 | 2001 Saturn SL

3 Answers

Filter for transmission located for a 2001 dodge stratus.


jack up the car and put it on stands. remove the drivers side plastic shield next to the transmission. remove the 10mm bolts from the rear and sides of the trans and loosen the ones in front. keep a pan under the trans as you will drain the fluid this way. once you have the fluid out, remove the remaining bolts and drain the last of the fluid. The filter is visible under the trans. Be sure to remove the o-ring in the hole. Replace the filter and make sure it seats in place. Scrape off any silicone gasket material and install the pan gasket and pan. The bolts torque to 165 inch pounds or about 13 ft/lbs. Add in 4 quarts of transmission fluid. Start the car, keep your foot on the break and shift the car into each of the gears to fill up the trans piping with fluid.

Jun 07, 2010 | 2001 Dodge Stratus

1 Answer

I have a 2001 trans am and wheni hit the lock


That's a sign the head light motor is going out I would sugjest replacing the module for the light.

Oct 05, 2009 | Pontiac Trans Cars & Trucks

1 Answer

Speedometor not working and trans not shifting . any ideas? thanks


on the LH cars, 41TE is your trans regardles of engine, the rear output speed sensor has failed, left side of trans, towards the back, the one in front of trans is your input sensor, when the rear fails the trans goes to limp in mode, hence no shift and no speedo, easy to replace, best when everything is cooled down, about $50.00 for the part. You have to clear the mill light to. GOOD LUCK RDJRP

Aug 09, 2009 | 1999 Dodge Intrepid

1 Answer

MY 2004 CHRYSLER 300M CHECK ENGINE LIGHT CAME ON AND A P1776 AND P0700 CODES CAME UP, WHAT DO I NEED TO DO??? DEBBIE


p0700 indicates you have trans fault present..p1776 is a trans fault which means solenoid switch valve is latched in low/reverse position..solenoid switch valve is located in valve body of transmission,but for 2001-2004 LH vehicles you need transmission event data read to find out what TRS position the fault set..recommend chrysler dealer for this fault..also build code on solenoid pack in trans must be checked..if in a certain build code range,you replace solenoid pack..not the valve body..valve body must be removed to check build code on solenoid pack..i have seen this problem before..i am a dealer technician, and had one of these fault codes last week and solenoid pack was the problem..solenoid pack is about 375 dollars..total time with diagnostics was about 3 hours..

Jun 13, 2009 | 2003 Chrysler 300M

1 Answer

Motor needs change in 98 trans am


Dude thats complicated,
Y don't U go to Autozone and get a chilton's book for you car and read the instructions :)

Most likely you have to replace it, try car-parts.com for used parts from salvage yards

Apr 08, 2009 | 1992 Pontiac Firebird

2 Answers

Drain plug for the transmission fuild on a Scion xb 2006


Automatic or manual? No need to change either until 100k.

Nov 18, 2008 | 2006 Scion xB

1 Answer

Chevy Transmission Diagram


I have a 1998 olds Regency frt whl drive auto trans. Do not know the trans ref like 460 e? or what.
Any how have had a frt growl, vib @ 65 mph, up and down ride at 10mph. New balanced tires replaced lh whl bearing by guess mechanic said th whl brg was ok.
Latest Son checked the drive axles for movement--there is up and dn movement @ shaft into trans end --lh & Rh side also clunkie noise. Trans seal not leaking,yet.
I suspect brgs or a bushing in trans end as it accepts the drive axle. If it the problem is it replaceable after axle removeable??
John Pankow jpankowsenior@verizon

Oct 26, 2008 | 1993 Chevrolet Cavalier

Not finding what you are looking for?
2001 Pontiac Firebird Logo

Related Topics:

389 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...