Question about 2004 Mazda 3

1 Answer

Can you just change outside plastic cover on headlight on a 2004 mazda 3

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

No. there are some kits available to "polish" them and they may look good for a few months, but the real fix is to replace them.

Posted on Sep 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda 6 sport sedan break lights not working after hid light conversion


Instructions Open the rear deck lid on the Mazda 6.Carefully remove the plastic finishing cover from the license plate light housing, using a small flat-head screwdriver to release the locking tabs. Pull the cover downward and off of the deck lid, exposing the license plate bulb.
Remove the old light bulb from the license plate bulb socket by hand. Wrap your new one in a paper towel and do not touch the bulb with your bare fingers. Insert the new bulb into the light socket. Install the finishing cover onto the light housing and push it upward until it clicks and locks into place.
Repeat Steps 2 and 3 to complete the LED light conversion on the opposite side of the deck lid. Test the new bulbs by turning on the headlights on the Mazda 6.
Mercedes Parts.






May 25, 2012 | 2004 Mazda 6

1 Answer

Replacing low beam headlight for a Madza 6 2004


Easier than high-beams, need to find the black turn covers just on the inside of the fender, release metal clip holding bulb and unplug light, replace resecure and put plastic cover back on should be good to go

Sep 25, 2011 | 2004 Mazda 6

1 Answer

I can't figure out how to replace the driver side low beam headlight on my 2007 Mazda 3.


very simple. remove black plastic cover by the air filter box. -couple of phillips plastic screws. then reach in and turn black plastic round dust cover,counter-clockwise then carefully remove electrical plug (harness) and then with your finger push metal hold down (silver) to unlock the bulb. do not touch new bulb with fingers (will reduce the bulb life) wear gloves.reverse procedure to install.remember the bulb is replaced from under the hood and no other tools are required.

Mar 31, 2011 | 2007 Mazda 3

1 Answer

Hi how can i replace my Mazda ^ 2006 headlight bulb ?


You can open the hood and you should be able to see the headlight compartment, right between your radiator on the front. Most Mazda's have a plastic cover on them. Simply turn the cover or pull it out. The light bulb is inside that compartment. Hope that helps you.

Jan 10, 2011 | 2004 Mazda 6

1 Answer

Where can i find the spark plugs on a 2004 mazda mpv?


Changing the plugs on the 04 MPV is a pain.

The front three plugs are easy to get to - just remove the black plastic cover over the engin block(3 screws) and they're right there (but deeply recessed in the block).

But you have to remove the manifold to get to the back three plugs. and this kinda sucks. you will need a new manifold gasket set also....... I hope this helps

Nov 28, 2010 | 2004 Mazda MPV

1 Answer

Where is the location of the spark plugs for the 2004 Mazda 3


under the plastic cover that is over the top of the engine ,

Aug 15, 2010 | 2004 Mazda 3

1 Answer

How to change headlight on 2004 Mercury


When you open the hood you will see a cover where the hood latch is. Some covers have individual doors on each side of the hood latch. If you have that type just pop the release on the cover and reach down to the headlamp bulb. It comes out with a twist with the socket and then pull the bulb free. Use a kleenex or gloves to install new bulb and reverse the process.

If the whole panel is one piece there are some plastic button holders to remove to lift the cover. Your headlights are underneath. In some cases the passengers side headlight may require removing the battery to access. Then just twist the socket and remove the bulb afterwards, then reverse process.

Mar 18, 2010 | 2004 Mercury Grand Marquis

1 Answer

Change filter for saloon


Open front passenger door.Remove the cover underneath of a dashboard.There is plastic cover with 3 screw. Open it and you will see your polen filter.

Jan 13, 2010 | 2004 Mazda 3

1 Answer

Changing the bulb for a headlight


I guess you refer to the dipped beam headlamp?
If the light is a normal one, not the fancy expensive bright lamp, bluish colour light emitted you should be able to reach it throgh the wheelarch after removing part of the plastic trim.
The cover rotates and can be easily removed.
The there is the usual wire spring loop that hold the lamp in.
The lamp in mine was a standard H1 single filament bulb.
Took about 20 minutes to replace in semi darkness with the aid of a wind-up torch!

Hope this helps.

Paul H.

Apr 30, 2009 | 2004 Mazda 6

1 Answer

Headlight bulb out


pop the hood take the plastic cover off it should have about 6 clips then unbolt the whole light from the car should be 2-3 screws and pull it out once u do that u might need to unscrew the plastic cover of the back to get to the wiring harness them u can change the bulb and reasmble

Feb 11, 2009 | 2004 Cadillac Deville

Not finding what you are looking for?
2004 Mazda 3 Logo

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...