Question about 1999 Jeep Wrangler

1 Answer

How do you wire a 1999 jeep wrangler to hook up a trailer

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

You can get a book at Autozone with the color codes,Chilton manual

Posted on Sep 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1999 jeep cherokee-hooked up to a trailer with electrical problem-I instantly lost dim headlight and both driver's side running lights. I suspect the running lights module. I found the replacement part...

Hi. The trailer has a shot in the wiring and blew your Jeep lights. Check for fuse in fuse box near battery or inside Jeep under dash and replace it.

Jun 15, 2011 | 1999 Jeep Cherokee

1 Answer

Where is the tail light connector to put in a trailer hook up on 2006 wrangler

most if not being used will be tied or taped back along the driver's side of the frame close to the rea bumper.

Apr 22, 2010 | 2006 Jeep Wrangler

1 Answer

Directional lights and marker lights and dash and radio all come on with brake lights

You have a bad ground wire problem somewhere. The hot wire to the brake lights is back feeding into the other wires. My be in the taillights. I have seen people install a trailer light hook up plug and wire it wrong also that will make this happen. Good luck!

Mar 01, 2010 | 2004 Jeep Wrangler

1 Answer

How to wire a jeep wrangler for towing behind a motorhome using a 7 way rv connector . the jeep has three wires, brown, green and yellow. green and yellow are turn signals, I am having problems with the...

I tow my 2005 Jeep Wrangler behind my motor home. I installed a Jeep trailer towing wiring kit to the rear lights. the bought a long trailer wiring kit and ran it from the front of the Jeep to the Jeep tralier wire plug. Pluged it in and pluged the other end into the motor home trailer light recptacle. I used only four wires plus ground. There is probably a way you could tap into the wiring harnes under the hood but not having a wiring diagram this is the best I could come up with and all lights do work. You can buy a test plug with led lights that plugs in both male and female, real handy for checking connections.

Jan 09, 2010 | 2004 Jeep Wrangler

1 Answer

Wireing for a trailer 87 yj

ID each wire in harness and splice. After making rough connections, check to make sure you have it right, then solder connections and carefully tape to seal. (Would be nice if they put a hookup plug there)
Also: if you will be towing any distance or heavy item, consider a trans cooler. Jeep cooling systems are marginal at best, even pulling themselves along!

Mar 14, 2009 | 1987 Jeep Wrangler

1 Answer

Towing a 02' Jeep Wrangler

If you go to it will give you the answer but I think you'll need a trailer.

Sep 13, 2008 | 2002 Jeep Wrangler

2 Answers

Jeep 2008 unlimted trailer wiring

I just bought a wiring adapter from mopar for this. you take off the rear tail light on the drivers side and unplug it from its harness. the mopar wiring kit i bought plugs into the wiring from the car and has two outputs on it. one for the tail light and a longer one that will run down thru the frame and come out under the bottom by the bumper in just the right spot. i has the plastic clips in just the right spots for snapping into the frame underneath too. took me 5 min to install no splicing required. i got mine off ebay for about $20. super easy! good luck!

Jun 18, 2008 | 2008 Jeep Wrangler

Not finding what you are looking for?
1999 Jeep Wrangler Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides