Question about 1993 Subaru Legacy

1 Answer

My 93 subaru engine light is on & yhere is no reverse help

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Take it to autozone or similar car center and have them read the code. A lot of times they can tell you what the problem is.

Posted on Sep 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tengo problemas con mi carro 93 subaru no quiere correr cuando va de subida solo asta que se pone una luz enel tablero que dise power entonses empiesa a sorrer mas fuerte


Babel Fish translates that as:
"I have problems with my car 93 subaru does not want to run when spear only goes of ascent that puts a light enel board that dise to power entonses empiesa to sorrer hard but"

So I can't quite make it out. I am assuming you are lacking in power.
So I would suggest checking the fuel filter, the timing, compression, plugs, wires, ERG, and PCV.
Then make sure the air mass sensor is not coated with foam from the PCV.
Clean it when it is off the car, to prevent cleaner from getting into the engine.

Jun 25, 2011 | Subaru Impreza Cars & Trucks

1 Answer

How do i get to the bulbs to change the tail lights in my 93 subaru legacy wagon


You begin by opening the rear-lid.
Remove the plastic panel.
Turn backward the bulb-holder.
[This will make it come off its housing]
Push-in the bulb, and turn it backward.
[it comes off]
Reverse these steps for installation.

Nov 24, 2009 | 1993 Subaru Legacy

1 Answer

My 1997 Subaru Outback Legacy Limited started jerking when in Drive- between first and 2nd gears. I then started driving in 2nd / 3rd, then drive. When in traffic very long time, would not engage at all...


Sounds like the transmission has reached the end of service life. I have a 93 that did the same thing. It would drive until the transmission heated up then nothing, except for reverse. I had a TRW rebuild transmission installed and now my 93 Legacy has 500,000 miles. $2,200 to repair vs $25,000 to replace. The only thing you would miss is the new car smell for a few weeks. But you can keep $20,000 plus.

Nov 16, 2009 | 1992 Subaru Legacy

1 Answer

93 Subaru Legacy Automatic transmission wont go into reverse


need to get trans looked at no simple fix without looking to diagnose problem,dont drive it till its seen to as it could be serious

Jul 29, 2009 | 1993 Subaru Legacy

1 Answer

93 Subaru legacy 2.2 turbo 5 speed manual tries to quit, jerks, acts like its not getting enough air, running rich,check engine light has been on since Ive had it.Hesitation. unplugged oxygen censor and it...


Sounds like the timing is lost, go get your engine timed, change plugs and check the continuity on the spark plug cables, also have it scanned for errors on the sensors, that should lead you straigh to the real issue, hope this helps ;-)

May 28, 2009 | 1993 Subaru Legacy

1 Answer

93 Subaru legacy 2.2 turbo 5 speed manual tries to quit, jerks, acts like its not getting enough air, running rich,check engine light has been on since Ive had it.Hesitation. unplugged oxygen censor and it...


ok , unplugged ox sensor cause engine light is on , then check the air filter and fuel filter for dirty and replace,connect the ox sensor, then disconnect the negative battery terminal few minutes, reconnect and test

Apr 16, 2009 | 1993 Subaru Legacy

2 Answers

Check engine light is on in my 1993 Subaru Loyale


i would suggest disconnecting the battery for 30mns then connecting this some times clears the code othr wise replace the sensor

Mar 25, 2009 | 1993 Subaru Loyale

3 Answers

Reverse went out on my 93 legacy


I have a 93 that had the same problem and drove the car for over a year with no reverse. Just had to watch where I parked it. When it was cold, reverse would work. After it warmed up, no reverse. Clutch disc in auto transmission was slipping. Tried fuilds and filter with no help. Ended up swapping out entire transmission with another good used one and that fix me up. Hope this helps.

Sep 18, 2008 | 1993 Subaru Legacy

Not finding what you are looking for?
1993 Subaru Legacy Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...