My volvo 2000 s80t6 just had the throttle body sensor cleaned. The software upgrade did not work.
I also have to have the heater core replaced..leaking fluid into drivers side floor boards.
It is running ok, but now it has the check engine light on and these are the two codes that came up 1132 and 1152.
Any ideas what these codes are for. The volvo mechanic did not have them in his book for volvo, but was listed in there under ford.
SOURCE: Check Engine Light On Volvo S80 Turbo
The P1132 I believe is a bad mass flow sensor or a vaccum leak.
SOURCE: Check Engine Light On Volvo S80 2000
The P1132 I believe is a bad mass flow sensor or a vaccum leak
SOURCE: truck codes p1132 and p1152
Hi,
P1132 = Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates
Rich - Bank No. 1
P1152 = Lack of Upstream Heated Oxygen Sensor Switch - Sensor Indicates
Rich - Bank No. 2
It sounds to me like the oxygen sensors (between the engine and catalytic converters) should be replaced. Good luck!
SOURCE: 2000 ford windstar won't stay running
Sounds like you got a vacuum leak somewhere on that thing. Do you hear any hissing while its running. You can take some carb cleaner in aerosol can and spray it around the intake while its running to check for vacuum leaks. If it has one big enough the thing will change idle. Visually look for some sucked in vacuum lines on that thing. There is an IAC valve on top of the throttle body tap on it with a screwdriver and see if it idles. Lastly I hate to tell you those things were bad for upper plenum gasket leaks, you will need the upper plenum oring gaskets 6 I think, and the isolator bolts that hold it down, and 1 big upper plenum oring gasket. And the pcm will need a reflash when done should take care of the Check Engine Light.
SOURCE: code p0442
p0442 is a small leak somewhere in the emmission system, check the vacuum lines, or have a smoke test done, to find the leak.
1,006 views
Usually answered in minutes!
×