Question about 1990 Toyota Camry

1 Answer

1987 camery and seatbelt just got stuck in door open position

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 73 Answers

Check for broken wires in the harness in the door jamb.

Posted on Sep 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Xc90 driver seatbelt stuck in pillar


Some cars have a belt release button in the door frame . When you open the door the button releases the seat belt. Check to see if your vehicle has one. Make sure it is not stuck or broken. Hope this helps.

Jan 10, 2014 | 2005 Volvo XC90 2.4

1 Answer

No power, no crank


Start by checking battery connections and be sure the battery is charged.

Jun 16, 2012 | 1987 Dodge Ramcharger

1 Answer

Automatic seat belt stays in extended position on 1987 camery


grab it close to the roller on both sides pull it back and forth pretty hard it may unlock

Feb 27, 2011 | 1987 Toyota Camry

1 Answer

The locking mechanism in my door is stuck in the closed position. that little "c" hook isnt moving at all, and my door will not fully close. is there a release latch somewhere?


Open the car door and pull on the release latch that you use to open the car door from the inside to get out. At the same time use a screwdriver to push up the latch on the side of the door. Sometimes the seatbelt gets caught on the door when you close it causing the latch on the side to close prematurely.

Jan 27, 2011 | 2001 Chevrolet Blazer

3 Answers

Seat belt stuck on 1995 850 volvo


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

Dec 31, 2009 | 1996 Volvo 850

1 Answer

1993 mercury villager- drivers side seatbelt is stuck.


You have a limit switch at each end of the seat belt track. One could be bad. Is belt stuck forward or at the back? It also has a module to control it.
It operates like a garage door opener. If you have to replace track, it's a big job. Have to take a lot of trim off the van. Best thing to do is get it in the rear position and just use the buckle. Get used part at car-part.com.
page with * is lowest pice. Or, go to pick n pull salvage yard and pull it yourself and learn how it comes out.

go here for team villager help

http://groups.yahoo.com/group/villagerquest/

Jul 29, 2009 | 1993 Mercury Villager

2 Answers

1993 Saturn SC1 Seatbelt Motor Killing Car Battery


The motor I believe, is located in the pillar between the doors. Remove the trim and pull the plug on the motor itself.

Jan 04, 2009 | 1993 Saturn SC1

1 Answer

Dome lights won't go out / 93 buick century


your doorswitch is inside the door on the striker latch. You will need to remove the door panel to access. chances are it is stuck in the closed position. Your seatbelt latch sensor has also gone bad. It is located inside the receptacle of the seatbelt. If you only want to diengage the light, look for the molex plug attached to the wire coming from the seatbelt receptacle.

Dec 24, 2008 | 1993 Buick Regal

1 Answer

Automatic seatbelt is stuck in forward position


try spraying some rust penetrant or WD40 into the door latch and open and close the door several times or more and see if the ajar light goes out and the belt is operating ok

Nov 25, 2008 | 1993 Ford Thunderbird

Not finding what you are looking for?
1990 Toyota Camry Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...