Question about 1996 Chevrolet Lumina Mini

1 Answer

Rear heater blower fan not working with either front or rear control switch

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

One simple question,have you checked your fuse?

Posted on Oct 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Pontiac Montana heat gets hot in front, blows but seems weak, and no heat on rear controls but blows ******* rear. what is going on?


Is your heater blower motor working on all speeds ? Are you get any air coming from the rear vents ?

Feb 25, 2015 | 2003 Pontiac Montana

1 Answer

Cruise control doesnt work the light doesnt even come on


Fuses are a great place to start, if not fuses the actual cruise control switch may be to fault. Rear heater do you get heat out the front and if so is there a fuse for a rear fan maybe a blower.. Let me know

Mar 28, 2014 | 2003 Dodge Durango

1 Answer

Rear blower only clicks when selecting any speed


CHECK YOUR HEATER RELAY SWITCH AND YOUR FUSES

Feb 14, 2013 | 2002 Ford Windstar Cargo

1 Answer

Both front and rear heater fans don't work, mechanic says it is an ignition switch?


Both "blower" fuses are fed by the ignition switch. If there is no power to those fuses than the switch is the likely problem.

Jan 22, 2013 | 2005 Chevrolet Venture

1 Answer

Rear blower: only works on high when set on cold, won't work at all when set to heat


I would start with the rear blower motor resistor, the resistor is what controls the speed of the fan, the resistor is located in the rear heater box near the blower, you will need to remove the right rear side panel to access the heater box. start with that

Dec 07, 2012 | 2004 Honda Odyssey

1 Answer

No power on the wires to the front heater blower fan , i have replaced fuse's inside and outside, installed a new blower fan ,will work if i run a hot wire from fuse box to fan, Rear blower works fine.


ok the is a sensor that leads to the fan this should be the problem to your fan not working. lol i remember one guy used a light switch wired to the fan sticking out of his dash. the problem is an easy fix :)

Mar 24, 2010 | 1989 Chevrolet Suburban

1 Answer

Heater fan on 2002 Yukon does not operate in front, only rear.


The front blower motor is controlled by the blower resistor module.This is usually the problem with the front blower not working.I looked up the schecmatics and I don`t see separate fuses for the front and rear.But the fuse for the front blower is in the under hood fuse block.If this is good then The problem is probably the resistor module.It is next to the blower motor.The connector from the resistor connects to the blower motor.If you want to confirm this you can check for power and ground at the blower motor connector when you activating the blower switch on.This can be done with a test light.Make sure you have power going into the resistor module also.If you have power going in and no power at the blower motor then replace the resistor.Hope this helps.Good luck.

Dec 28, 2009 | 2002 GMC Sierra C/K1500

1 Answer

I have a 2000 ford E350 van with front and rear air. the front blower motor runs at low speed, The front blower still runs on low even when the knob is set on medium or high. I do not know where the...


it's either the blower motor switch or blower motor resister. Resistor ?Heater Blower Motor Switch Removal Remove the battery (10655) ; refer to Section 414-01 . Remove the battery tray. Remove the screws. Remove the battery tray. Disconnect the heater blower motor switch resistor connector. Remove the heater blower motor switch resistor (18591). Remove the two screws. Remove the heater blower motor switch resistor. ----------------------------------- Switches Removal Disconnect the battery ground cable. Remove the center trim panel; refer to Section 501-12 . Remove the control assembly. Remove the screws. Remove the control assembly. Remove the A/C-heater function selector switch knob. Disconnect the vacuum harness connector. Disconnect the A/C-heater function selector switch connector. Remove the A/C-heater function selector switch. Remove the screw. Remove the A/C-heater function selector switch. Remove the temperature control switch knob. Disconnect the temperature control switch connector. Remove the temperature control switch. Remove the screw. Remove the temperature control switch. Remove the heater blower motor switch knob. Disconnect the heater blower motor switch connector. Remove the heater blower motor switch (18578). Remove the screw. Remove the heater blower motor switch. ----------------------------

Mar 31, 2009 | 2007 Ford E-350 Super Duty Length XLT

Not finding what you are looking for?
1996 Chevrolet Lumina Mini Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...