Replacement Front, Driver Side Window Regulator

SEE this YOUTUBE FIRST!

Fix Jeep Cherokee Power Window and Locking Issues The RIGHT Way 1997 1998...

Then try this: "2004 jeep grand cherokee passenger door module"?

And this: "2004 jeep grand cherokee passenger door module location" (both on GOOGLE "IMAGES")

Disconnect your battery
Find these connections and CLEAN every contact.
Call The Auto Club (just kidding)

Anthony
(Say Thank You!)

RTM
read the manual yet?
car WJ
2000
chapter body
read
page 100
its all there to read.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

It's time to replace the Window Motor & Regulator Assembly. If you have the cash and time do both passenger and driver-side (one is just serving notice that other is going to go soon as well). "Replacement" is a good brand to get. The procedure isn't all that challenging, there should be some good pictorials at various jeep websites to guide you through it.

This video shows you how to do the window regulator on the driver's side of your vehicle. Not much difference on the passenger's side.

2000 Jeep Grand Cherokee 4WD 4.0L MFI 6cyl:
The Fuel Filter is located under vehicle, driver side, below bed area, front of fuel tank, mounted on chassis in fuel line.



Fig. Fuel filter/pressure regulator location-1999-01 models.

For more details, can search in the Jeep WJ Repair Manual.

Hope helps with this (remember rated this help) Good luck.

Power Window Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the window regulator from the door.
3. Place the window regulator on a suitable work surface and remove the screws that secure the power window motor to the window regulator.
4. Remove the power window motor from the window regulator.
INSTALLATION
1. Position the power window motor onto the window regulator.
2. Install and tighten the screws that secure the power window motor to the window regulator. Tighten the screws to 9 Nm (80 in. lbs.).
3. Install the window regulator onto the door.
4. Reconnect the battery negative cable.

if the window keeps falling down either the regulator is stripped or the motor is check the regulator because i think this is a cable type and they are bad about this problem

THE CABLES ARE BROKEN ON THE WINDOW REGURALTORS, THE NUTS THAT SECURE THE WINDOW AND RAGURLATOR ARE 10MM

It could be a couple of things. If the motor has a hard time lowering the window, then it could be the motor. If not, then I'd buy a replacement switch box. You can replace that fairly easily. If that doesn't work, it could be the motor, or the window regulator could be jammed. If the motor hums and tries to move when you press the up button, it could be the regulator( all that other junk in the door that controls the window). In that case, do NOT replace the switch, because the humming you hear means the motor is getting power, and the switch is fine. You could replace the switch or the motor, but I would suggest letting a professional fix the regulator.

If you have a 2000 Grand Cherokee you have a WJ. 1999-2004 are the WJ model of the Grand Cherokee.