Question about 1999 Dodge Caravan

1 Answer

Very squeaky belt or pully, use to stop when gas pedal applied but now squeaks when gas pedal applied and most idle times. Been using wd40 but doesn't work as good now

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 301 Answers

1999 probably has a serpantine belt (multi grooved). I would guess that you may have a squeaky belt or more likley a bad bearing in on of the idler pulleys. Remove the belt and spin the idlers by hand. If one feels rough or makes noise replace it.

Posted on Sep 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

There is a recurring loud squeak from under the hood. What is it?


May be a worn on loose drive belt that squeaks as the engine idle speeds up as you change gear. Spray the belt with WD40 or similar . If this stops the squeak tighten or replace the belt.

Sep 28, 2014 | 2000 Toyota ECHO

1 Answer

What is the cause of a squeak in a 1997 GMC sierra while its running it sounds like a belt or belt tensioner but isn't


If your sure it's not a belt then u might wanna make sure the pullies the belts run on are good and tight. Although My dad always kept a bar of soap in his truck for squeaky belts;)

Feb 06, 2013 | Cars & Trucks

1 Answer

Pully squeaks in 2007 kia optima


to me it sounds like fan belt, just tighten it up and job done

Feb 25, 2012 | 2007 Kia Optima

1 Answer

Squeaky clutch pedal


This is a common problem. Your clutch pedal has a return spring on it, each end of which can squeak when dry.
Look under the dash, and locate this. Dab a bit of grease at each end of the spring where it hooks around. Work the pedal up and down a few times and the squeak should go the way of the Honda Element.

Nov 28, 2011 | 2003 Honda CR-V

1 Answer

My friend just install a serpantine tensioner pully & a belt on my 2000 2.4 grand am... but since then there's an annoying squeaky noise whenever I'm driving... he told me it will stop after a while b


double check the belt length if its too short even a little it can cause a squeak.also make sure there is no oil on any of the pulleys as well make sure the tensioner was installled properly and the pulley is the correct one.this does happen if someone doesn`t take the time to make sure of this and assumes they have been given the correct parts.

Nov 12, 2011 | 2000 Pontiac Grand Am GT

1 Answer

How to fix squeaky fan belt 1998 citroen xsara 1.9d The squeak is loud at start when the engine is cold, but after 60 seconds or so it stops, and when the car is warm it doesnt squeak, I have had the belt...


Its because your alternator is a 80 amp which is a lot of power drain ,some propriety belt sticky sprays will cure it for a while ,arrow chemicals used to make one 30 yrs ago in the Uk which was very good but aqs to sorting this one out then short of renewing the spring loaded tensioner their is not a lot you can other than to start engine and dont rev it let it idle for a minute and this will recharge the battery so stopping the strain on the belt and the screeching at the same time

Jun 07, 2011 | 2006 Renault Fuego

1 Answer

Broke brand new belt


youve got a pully locking up,all except the crank pully should spin freely by hand if there good

May 25, 2009 | 1988 Oldsmobile Cutlass Supreme

2 Answers

Squeaky noise when applying breaks


semi-metallic pads can cause noise from glazing over if you are too rough on them, or a crappy pad composition. get some BG brand STOP SQUEAL and apply it to the pads. clears it right up

Mar 19, 2009 | 2001 Dodge Neon

Not finding what you are looking for?
1999 Dodge Caravan Logo

487 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...