Question about 2000 Chrysler Sebring

1 Answer

When i put the car in gear or come to a stop it feels like the motor is jumping

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 496 Answers

Hi,
With the car in park also, does the engine idle steady, or does it seem to rev up and down etc. ?
If this is the case, you may have an issue with the throttle positioning sensor.
Hope this helps...

Posted on Sep 24, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diagnois ford territory engine mount vibration


u can do this 2 ways.tranny mounts, have someone get in the car,holdbreak,put in gear,slightly ascelarate the throttle and watch the engine .in drive engine will travel forward and vise versa in reverse.believe me, if u have any bad u will think the motor is tryin to jump out. upper mount check/ 9 out of 10 times,it feels like u are in a popcorn machine when u come to a complete stop ildeing in gear, take a small floorjack and place it under the oilpan again have someone in the car . start and put in gear, just let it idle,and slightly raise just the motor and see if the vibration goes away ./ note,be sure to have a small piece of wood between jack an oilpan.

Feb 04, 2015 | 2006 Ford Territory 4.0

1 Answer

I have a 02 lancer oz rally. Yesterday I left work stopped at a gas station and filled up. As I went to leave I put the car in first gear with no problem but when I pushed the clutch again to stop the car...


hydraulic clutch
replace the master and slave cylinders
cable clutch
replace the cable
if cable also check the engine mounts for failure as if the engine is allowed to move , the clutch action is affected

May 04, 2017 | 2002 Mitsubishi Lancer

1 Answer

Would broken motor mounts do this as well at about 50 mph..?? i know when the van is put in gear the motor "kick"s or jumps to say.


Definitely broken motor mount(s). Don't drive it far especially if you're feeling it at highway speeds because engine is actually changing position which can damage transmission and drive train by twisting on drive train angles

Feb 21, 2011 | 1999 Ford Windstar

3 Answers

My 87 Mazda B2000 has been parked down hill for 3 months.Now the motor starts but I cannot put it in any gear with the motor on. The stick shift will move into gears with the engine off.


sounds like the clutch has corroded somewhat.
does it feel like the clutch has some pressure?
try putting it in gear, depress the clutch, and then see if it will start in gear( be carefull it may jump forward)
this might free the clutch.
also the clutch fluid may have drained or have an air bubble, depressing the clutch many times quickly may self bleed the air out, or bleed some new fluid through it. make sure to top up the fluid.

Feb 04, 2011 | 1984 Mazda B-Series

1 Answer

I left my doors open two long and the battery died so I got a jump and it started and ran for 20 mins and shut off and would not start again on the dash say stability disable and I can't see how to put it...


need to let the battery charge up with motor running and nothing on. park is first then revers then nuetral and then drive. put shifter al the way to park and then feel each gear click as it goes in.

Jan 15, 2011 | Cadillac ESV Cars & Trucks

1 Answer

Was wonedrin if i had a bad motor mount or trans mount? had some one change trans but they didnt finish the job and had to put it back in by myself everything works but it jumps out of the upper gears now...


Without looking, Id say you have a transverse mount engine (sideways) with three main mounting points. One on either side of motor and one on the transmission end. Its also possible you have some sort of mounting on the north end end of the motor. In any case, the whole affair sits in the engine compartment like in a cradle....so, the transmission mount is every bit as important as the rest of the mounts, because all are needed to hold it into place properly. If the car is jumping out of gear, that could become hazardous in traffic. Get it looked at ASAP.

Theroadisalover

Try to post back and let me know If I helped you solve your problem. It will help me with my rating....! Thanks

Jan 07, 2011 | 1996 Volkswagen Jetta

1 Answer

Broken Motor Mount or Motor Mount Bolt


to check for a bad motor mount u need 2 people for this. Have the car running put it into gear with your foot pressed firmly on the brake u don't want to run your buddy over. Give it some gas in the motor is jumping around alot like 6 inches in any direction you have a broken motor mount. Which way the engine jumps will let u know which one is bad. Try this test in reverse gear to.

Aug 26, 2009 | 2003 Chrysler PT Cruiser

1 Answer

Jumps up and down at rear when braking


check front motor mounts. Hold brake and put in reverse then accelerate and let up on gas. do yhe same in forward gear.if you hear a thud a motor mount is broken with hood open you can see the motor lift up.. Acceleration causes engine to lift and drop. good luck

May 10, 2009 | 1990 Dodge D150

Not finding what you are looking for?
2000 Chrysler Sebring Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...