Question about 2004 Toyota Solara

Open Question

Power driver side mirror 2004 Solara sle

Need to repair a driver side mirror (power) that came slightly detached when hit garage door frame. Power still works, mirror loose
thanks
bob

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: 2004 Toyota Solara Healight adjustment

Look at the back side of the headlamp assembly. There are a couple of ears that stick out, right above a small silver toothed wheel. Using a suitably long phillips screwdriver, insert the driver down into the 2 small ears, and then the screwdriver should contact the small toothed wheel. The ears provide the proper support for the screwdriver to mesh with the toothed gear. Spin the screwdriver, and the toothed gear should spin, also. Rotate the driver in whatever direction to adjust the lamp beam. This will gibe you what you need. Hope this helps; any questions; please repost.

Posted on Oct 10, 2008

goofduck
  • 490 Answers

SOURCE: Power lock on driver side door does not work on2003 Toyota Celica

remove the door panel and change the solenoid on the inside of the door

Posted on Apr 16, 2009

  • 6 Answers

SOURCE: 1999 toyota solara power windows

These window motors do periodically fail. Instead of trying to tinker with the motor itself, best to cut right to replacing the window motor. You can buy them online. Don't buy the cheap ones with the short warranty. Make sure you get the ones that have a multi-year or lifetime warranty, as they are usually of a higher quality. I just replaced one for my 94 Camry and the part cost $67.00 with a lifetime warranty. Make sure that the bottom of the window is securely bolted to the unit, Check to make sure the bolt made it all the way through both parts, as it is easy to overlook it if not fully secure.

Posted on Jul 13, 2009

leedavidian
  • 1420 Answers

SOURCE: How do I replace the

Welcome to FIxYa.com


Remove the three 10mm bolts on top. You then need to realease the three clips on the grill. You can do this by pushing down on the bumper with your left hand and gently pulling the grill off with your right hand.


Regards, Lee Davidian


A Four Thumbs up ^^^^ is appreciated for answering your question. And please take the time to rate me by leaving a testimony. Thank you, Lee Davidian

Posted on Oct 10, 2010

swolfinor
  • 504 Answers

SOURCE: how do I program solara sle garage door opener

GOTO HOMELINK.COM


THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.


PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.


HOPE THIS HELPS

Posted on Nov 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove inside door panel form 2004 Toyota Solara SLE


theres one screw in the interior door handle area,
one on the other side of the sideview mirror (under that panel)
two more at the bottom
and one in the armrest area

the bottom of the door "pops" out first , then the top of the door panel slides up.

Jul 04, 2013 | Cars & Trucks

1 Answer

Similar electrical issues with driver's side door controls. Power locks, power window, and power mirror on driver's side are not functioning. I can manually unlock the door, but the buttons on...


CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.

Sep 11, 2011 | 2004 Saab 9-3

1 Answer

How do I program solara sle garage door opener


GOTO HOMELINK.COM


THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.


PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.


HOPE THIS HELPS

Oct 26, 2010 | 2005 Toyota Camry Solara

1 Answer

Is there a step by step instruction on how to change the left side mirror on my Mitsubishi Endeavor 04 ? thank you


Maybe try alldata.com, because on my online resource for the 2004 Mitsubishi Endeavor, there is no information on body work.

One could get the part from the salvage yard and look for the bolts like one would do for a GM car

One may have to remove some plastic parts to get at the fasteners.

Also, if there are cables for moving the mirror from the inside, then that should be considered, as well.

Also, if the mirror is heated, that should be considered.
---
(I got this off of Wiki Answers)
Very easily. Open the door, find two rubber circular boots right behind the
mirror. Take them off to expose the 2 bolts that hold the mirror on. Take the
bolts out and unplug the wire. Reverse these steps to install, hole this
helps...

There are three small bolts holding the driver's side mirror on. Two can be
accessed by opening door and removing the two circular rubber boots seen on the
upper end of the door . To access the third bolt you will need to remove the
door panel. you will need a forked driver to help remove the door panel. It can
be bought at any auto parts store. It has a flat Y shaped head that can be
inserted along the lateral and bottom edge of the door panel to pop it way from
the door frame. There are three screws holding the door panel on. Two under the
door handle and one behind the door latch. Then the door lifts up and off. Make
sure you have the window down before you take the panel off because you cannot
access the third bolt unless it is. You will have to unplug the electrical
connects that power the controls on the door handle to completely remove the
door panel. After you remove the panel there will be a hole in the upper right
hand door frame, possibly covered by a black patch. Beneath this is the third
bolt. you will also need to disconnect the light from inside the door frame
before you will be able pull the mirror off. There is a large rubber boot oval
shaped that you can pull out and you will see the electrical connection for the
mirror inside the hole on the right.


Good luck on this repair.

Oct 07, 2010 | 2004 Mitsubishi Endeavor

2 Answers

How do you remove the driver side door panel on a 2004 Jeep Cherokee.


- Remove trim plug from mirror flag bezel.
- Remove screws attaching trim panel to door
- Using a trim remover, detach trim panel perimeter push-in fasteners from door trim panel
- Lift trim panel upward and separate from door.
- If equipped, disconnect harness connectors for power accesories.
- Disconnect latch rods from inside handle actuator
- Finally, separate trim panel from vehicle.

I suggest check all information in the WJ Repair Manual Section 23 Body with graphics and other details.

Good luck (remember rated this help).


Feb 03, 2010 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Broken driver side mirror


you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can remove the cover adjacent to the mirror and remove the bolts and the mirror will pop right out

Aug 19, 2009 | 2005 Ford Focus

4 Answers

2004 Jeep Grand Cherokee driver side power windows do not work


I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Nov 25, 2008 | 2004 Jeep Grand Cherokee

1 Answer

2004 Toyota Solara Healight adjustment


Look at the back side of the headlamp assembly. There are a couple of ears that stick out, right above a small silver toothed wheel. Using a suitably long phillips screwdriver, insert the driver down into the 2 small ears, and then the screwdriver should contact the small toothed wheel. The ears provide the proper support for the screwdriver to mesh with the toothed gear. Spin the screwdriver, and the toothed gear should spin, also. Rotate the driver in whatever direction to adjust the lamp beam. This will gibe you what you need. Hope this helps; any questions; please repost.

Oct 10, 2008 | 2004 Toyota Solara

Not finding what you are looking for?
2004 Toyota Solara Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...