Question about 1989 Jeep Cherokee

1 Answer

Turn ignition key and no start there is fuel and battery it does not crank just ehhs like im turning it

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

If it is turning over at normal speed, the batt is prob good. I would check for spark. start at the plugs and work your way back through the ditributor, rotor cap, coil, etc. ignition fuses
what year make model?

Posted on Sep 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93 Geo Storm standard Transmission 1.6 Engine Lately I have to push start it Replaced ignition switch Checked all the fuses Starters good Help 48 disabled female


bad fuel, is it old? fuel.
needs tuneup, air cleaner and spark plugs , at least.
if the starter cranks fast and dont' start,
but does push started. that means the spark is weak
when cranking, and marginal spark plugs can do that.
this car is really (under Geo snake skins) a
an Isuzu Impulse
and Isuzu is defunct there too. (double bad)

now my real guess......analysis...
im not sure your order stated.
the engine would not crank over with a key before the new switch or after?
and "starters good", does that mean , it still fails to crank start with key
but the hot wiring of starter does?
try this:
tell use what happens when you turn the key, is best.
I turn the key, and i get the dash board to light up,
lots of lights. and the CEL LaMP GLOWS.
the CEL lamp, means the ENGINE brain is alive.
then you turn the key to cranks (start) position.
  1. nothing happens.
  2. it only clicks
  3. it cranks slowly,
  4. it cranks fast, just like a new car does. fast. cranking.

1,2,3,4.?

and does jumper cable starts work>?
if this works , your battery is low. , discharged or dead, or bad.
if the battery keeps going low, its bad, or the alternator fails to charge the battery, or you have phantom drains , discharging it as you sleep.

my guess, (based on most common)
is #3, slow cranks, and spark plugs are long since gone.(fouled and gaps no longer in spec>)

Nov 01, 2014 | 1993 Geo Storm

2 Answers

Keys turns on but wont start the engine


check:
battery good 11 v min
battery conecctions cables, all clean
if automatic trans, in park or neutral selector
if standar trans, press the clutch pedal full down, check switch in pedal
the dash lights all on in switch on, check for antiefth extra
alarm disabled
and doors closed, seat belts
or crank start but engine no start need a full diagnosis for qualificated personal.

Sep 09, 2014 | Cars & Trucks

1 Answer

Wizard isuzu


Check your Fuel Lines and your Fuel Pump. (I just fixed a problem with my 2001 Isuzu Rodeo Fuel Return Line).

Also remember that in Rodeos, as soon as you turn your car key to turn the ignition on (just to make the dashboard lights go on) a certain amount of gasoline gets pumped to your engine in preparation of you turning the key all the way to crank the ignition and start the car. In other words, even before you turn the key all the way to crank the ignition, the Fuel Pump will pump some gasoline through the Fuel Lines to your engine (it will pump the gasoline for about 4 seconds then stop). So when you go to start your Rodeo, remember to turn the key with one continuos motion so that you start the ignition cranking while the gasoline is being actively pumped.

In addition, you should never turn the ignition lights on without turning the key all the way to start the engine. Doing so could cause that bit of gasoline that was pumped to start the engine to just sit there and create problems.

Jun 03, 2014 | 2001 Isuzu Rodeo

1 Answer

I have a 97 chevy 350 vortec that i am having problems with, it has fire to all the spark plugs and it has fuel delivery. the truck all of a sudden turned off while driving and would not turn on again. i...


how did you make your test.spark plug wire test is made with special tools call HEI spark tester.and injector fuel pressure test.and wire to injector anoid light

Sep 19, 2013 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

I went out to warm it up,it started fine.When I came out to leave,it was dead.All of the instrument cluster lights were on but it wouldnt crank and i am not getting a fuel pump.I checked the battery,all of...


First unhook the battery for about a half hour to reset the computer.
does that have anti-theft on it.
a remote starter ?
second either swap the relays for the starter and fuel pump or replace them outright.
when you bypass the relay to get it to crank... will it start ?

Robert

if that radio is of the anti-theft variety make sure you know the code and how to enter it

Dec 25, 2009 | Chrysler PT Cruiser Cars & Trucks

1 Answer

Car wont start


THere is no gas in the fuel rail at the time gas is running out. WHen you fill the tank, it needs to pump for a while so fuel can fill up the rail then the Fuel distributor so it can build up pressure for the injectors to work properly. It need to continue cranking at least 2 minutes. However you don't want to run out the battery, so can just turn on the key to hear the sound of the fuel pump stops, then turn key off turn key on again. Repeat this for 6 times then start the engine. The reason for it is that every time the key is on it turns on the fuel pump to prime the line then turns pump off after a specific time, then it turns on again only when key is at ignition position. By doing this you help to pump gas into the fuel rail instead of the starter continue cranking draining down battery fast. Cheers.

Dec 13, 2009 | Lexus LS 430 Cars & Trucks

2 Answers

B4 turn key start immed-now need hold key lond time to start


Sounds like a bad battery connection, either on the battery, or the starter or engine ground, or just a poor battery.

Aug 07, 2009 | Chrysler Cirrus Cars & Trucks

2 Answers

My 1996 Pontiac Sunfire wont crank...


tryy replacing the fule injectors and the fuel pump could possibly be shot as well. you have a fuel problem.

May 07, 2009 | 1996 Pontiac Sunfire

1 Answer

Car wont start


check the ignition relay its under the drivers side dash common on hondas

Oct 27, 2008 | 1995 Honda Accord

1 Answer

I have a R reg mercedes E320, the other day i got in to find that the ignition key will not turn, it doesnt seem to power up the ignition barrel?? ive stripped the barrel and if you insert the key and take...


Most likely there you have a security system VAT (Vehicle Anti-Theft) module. If you try to bypass this the car will not start. Have a mechanic or yourself get to the main wiring harness to the ignition in the steering column under the dash, unplug it and use another ignition with a key in it to learn the security system code first before trying to start it.

Jul 15, 2008 | 2001 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...