Question about 2000 Volkswagen Passat 4Motion

1 Answer

How do I change the left turn signal assembly of my 2000 Passat?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,085 Answers

Very difficult. You have to open the inside access door on the drivershow do I change the left turn signal assembly of - 2.gif side, remove the amp and wheel well cover, pinch the tabs and the bulb cluster will release. The taillight assembly is bolted from inside of the car, so it can't be done outside.

Posted on Sep 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Left turn signal stops working


Had simular problem with wife 2000 Jeep Cherookee.
My signal light were not working at all.Check flasher relay under steering colum

Nov 28, 2012 | 2000 Jeep Grand Cherokee

1 Answer

How to change the right front turn indicator on


1.Remove the front turn signal assembly mounting screws and slide the assembly forward, out of the vehicle body.
2.Twist the bulb socket a quarter turn counterclockwise, then remove the bulb assembly from the housing
3.The defective bulb can then be removed from the socket and replaced.
4. Installation of the front turn signal assembly is the reverse of removal.

Dec 31, 2009 | 2000 Ford Excursion

2 Answers

Turn signal on 2000 Volkswagen Passat GLS


start with the flasher that should solve your problem, if not then you will need the signal switch replaced, most of the time its just the flsher, good luck

Nov 28, 2009 | 2000 Volkswagen Passat 4Motion

1 Answer

When I use the turn signal, left or right it


try replacing the signal light flasher that should solve your problem, if it does not then the signal swith needs replacing, most of the time its the flsher,start with that hope this helps,good luck.

Nov 28, 2009 | 2000 Volkswagen Passat 4Motion

1 Answer

I opened 2000 passat door for change of broken assembly but it doesnot start now what can i do


you need to reset the antitheft module,or in the lash is a wire desconected ok ,there it be a light flashing, a red one,in the nob,do you remember it, ??

Nov 24, 2009 | 2000 Volkswagen Passat 4Motion

1 Answer

I have a 2000 VW Passat. Recently, my cruise control has been acting up. It will engage but shut off every time I turn on my left turn signal or my brights. However, three days ago, it stopped working...


Check the wiring harness, especially the one that goes underneath the dashboard and steering column. There may be bad wires or loose connections that may have caused your cruise control to act up when turning on the signals or the brights. If that checks out Ok, inspect the speed sensor near the transmission. It may have gone bad.

Oct 27, 2009 | 2000 Volkswagen Passat 4Motion

1 Answer

How do you change tail lights for the 2003 passat


Rear Turn Signal, Brake and Parking Lights Removal & Installation To Remove
  1. Remove or disconnect the following:
    • Harness connector
    • Combination nuts
    • Lamp and its assembly toward rear
To Install:
  1. Install or connect the following:
    • Lamp and its assembly into position
    • Combination nuts; torque to 35 lb-in. (4 Nm)
    • Harness connector
This is the only thing the tech manual says.

Jul 22, 2009 | 2003 Volkswagen Passat

1 Answer

Passat 2000 turn signal problem


sound like you have a poor earth on the rear lights or indicator circuit

Oct 22, 2008 | 2002 Volkswagen Passat

Not finding what you are looking for?
2000 Volkswagen Passat 4Motion Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

79123 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...